Mafic magma batches at Vesuvius: a glass inclusion approach to the modalities of feeding stratovolcanoes

1995 ◽  
Vol 120 (2) ◽  
pp. 159-169 ◽  
Author(s):  
P. Marianelli ◽  
N. M�trich ◽  
R. Santacroce ◽  
A. Sbrana
Keyword(s):  

1995 ◽  
Vol 120 (2) ◽  
pp. 159-169
Author(s):  
P. Marianelli ◽  
N. M�trich ◽  
R. Santacroce ◽  
A. Sbrana
Keyword(s):  


2021 ◽  
Vol 130 (3) ◽  
Author(s):  
Mohd Azhar Ul Haq ◽  
S Balakrishnan ◽  
Rajneesh Bhutani ◽  
Jitendra K Dash


2021 ◽  
Author(s):  
Barbara Cserép ◽  
Zoltán Kovács ◽  
Kristóf Fehér ◽  
Szabolcs Harangi

<p>Identification of trans-crustal magma reservoir processes beneath volcanoes is a crucial task to better understand the behaviour and possible future activities of volcanic systems. Detailed petrological investigations have a fundamental role in such studies. Dacitic magmas are usually formed in an upper crustal magma reservoir by complex open-system processes including crystal fractionation and magma mixing following recharge events. Conditions of such processes are usually constrained by crystal-scale studies, whereas there is much less information about the petrogenetic processes occurring in the lower crustal hot zone. Here we provide insight into such processes by new results on amphibole crystal clots found in dacitic pumices from an explosive volcanic suite of the Ciomadul volcano, the youngest one in eastern-central Europe.</p><p>Amphibole is a common mineral phase of the Ciomadul dacites, occuring as phenocrysts and antecrysts, but occasionally they also form crystal clots with an inner core of either pyroxene or olivine with high Mg-numbers. Olivine is observed mostly in the 160-130 ka lava dome rocks, whereas the younger explosive eruption products are characterised by orthopyroxene and clinopyroxene. Such mafic crystal clots are most common in the pumices of the earliest explosive eruptions, which occurred after long quiescence at 56-45 ka. The most common appearance has high-Mg pyroxene core (mg#: 0.76-0.92) rimmed by amphibole. Two types of amphibole are found in such clots: irregular zone of actinolite to magnesio-hornblende directly around orthopyroxene and high Mg-Al pargasitic amphibole as the outer zone. Several crystal clots contain smaller amphibole crystals with diffuse transition to clinopyroxene at the inner part and complexly zoned amphibole with biotite inclusions in the outer part. These amphibole and pyroxene have lower Mg-number (< 0.80), and higher MnO content (up to 0.52 wt%) than the most common type. In both cases, amphibole could be a peritectic product of earlier-formed pyroxenes, which reacted with water-rich melt at higher and lower temperatures, respectively. Actinolite to magnesio-hornblende at the contact represents a transitional phase between pyroxene and the newly formed amphibole. In a few cases, crystal clots contain amphibole inclusions in pyroxene macrocrysts. These amphiboles have a particular composition not yet reproduced by experiments: they have high mg# (>0.86), but low tetrahedral Al (0.9-1.0 apfu) and usually high Cr content (Cr<sub>2</sub>O<sub>3</sub> is up to 0.9 wt%), similar to the orthopyroxene and clinopyroxene hosts (0.26-0.71 and 0.78-0.89 wt%, respectively). We interpret these amphiboles as an early formed liquidus phase crystallized along with pyroxene from an ultra-hydrous mafic magma. Occasionally, crystal clots are complexly zoned amphibole macrocrysts with dispersed clinopyroxene inclusions. The amphibole has a wide compositional range, usually with high Mg-Al pargasitic core. These amphiboles could have formed by peritectic reaction between clinopyroxene and a water-rich melt.</p><p>The observed mafic crystal clots in the dacites indicate the presence of strongly hydrous mafic magmas accumulated probably at the crust-mantle boundary. During mafic recharge, volatile transfer may contribute to the crystal mush rejuvenation at shallow depth and triggering explosive eruptions.</p><p>This research was financed by the Hungarian National Research, Development and Innovation Fund (NKFIH) within K135179 project.</p>



Energies ◽  
2020 ◽  
Vol 13 (17) ◽  
pp. 4524
Author(s):  
Amin Nozariasbmarz ◽  
Daryoosh Vashaee

Depending on the application of bismuth telluride thermoelectric materials in cooling, waste heat recovery, or wearable electronics, their material properties, and geometrical dimensions should be designed to optimize their performance. Recently, thermoelectric materials have gained a lot of interest in wearable electronic devices for body heat harvesting and cooling purposes. For efficient wearable electronic devices, thermoelectric materials with optimum properties, i.e., low thermal conductivity, high Seebeck coefficient, and high thermoelectric figure-of-merit (zT) at room temperature, are demanded. In this paper, we investigate the effect of glass inclusion, microwave processing, and annealing on the synthesis of high-performance p-type (BixSb1−x)2Te3 nanocomposites, optimized specially for body heat harvesting and body cooling applications. Our results show that glass inclusion could enhance the room temperature Seebeck coefficient by more than 10% while maintaining zT the same. Moreover, the combination of microwave radiation and post-annealing enables a 25% enhancement of zT at room temperature. A thermoelectric generator wristband, made of the developed materials, generates 300 μW power and 323 mV voltage when connected to the human body. Consequently, MW processing provides a new and effective way of synthesizing p-type (BixSb1−x)2Te3 alloys with optimum transport properties.



Geosphere ◽  
2021 ◽  
Author(s):  
S.J. Seaman ◽  
M.L. Williams ◽  
K.E. Karlstrom ◽  
P.C. Low

Recognition of fundamental tectonic boundaries has been extremely difficult in the (>1000-km-wide) Proterozoic accretionary orogen of southwestern North America, where the main rock types are similar over large areas, and where the region has experienced multiple postaccretionary deformation events. Discrete ultramafic bodies are present in a number of areas that may mark important boundaries, especially if they can be shown to represent tectonic fragments of ophiolite complexes. However, most ultramafic bodies are small and intensely altered, precluding petrogenetic analysis. The 91-Mile peridotite in the Grand Canyon is the largest and best preserved ultramafic body known in the southwest United States. It presents a special opportunity for tectonic analysis that may illuminate the significance of ultramafic rocks in other parts of the orogen. The 91-Mile peridotite exhibits spectacular cumulate layering. Contacts with the surrounding Vishnu Schist are interpreted to be tectonic, except along one margin, where intrusive relations have been interpreted. Assemblages include olivine, clinopyroxene, orthopyroxene, magnetite, and phlogopite, with very rare plagioclase. Textures suggest that phlogopite is the result of late intercumulus crystallization. Whole-rock compositions and especially mineral modes and compositions support derivation from an arc-related mafic magma. K-enriched subduction-related fluid in the mantle wedge is interpreted to have given rise to a K-rich, hydrous, high-pressure partial melt that produced early magnetite, Al-rich diopside, and primary phlogopite. The modes of silicate minerals, all with high Mg#, the sequence of crystallization, and the lack of early plagioclase are all consistent with crystallization at relatively high pressures. Thus, the 91-Mile peridotite body is not an ophiolite fragment that represents the closure of a former ocean basin. It does, however, mark a significant tectonic boundary where lower-crustal arc cumulates have been juxtaposed against middle-crustal schists and granitoids.



2013 ◽  
Vol 29 ◽  
pp. 1-24 ◽  
Author(s):  
Brian G.J. Upton

The 1300–1140 Ma Gardar period in South Greenland involved continental rifting, sedimentation and alkaline magmatism. The latest magmatism was located along two parallel rift zones, Isortoq–Nunarsuit in the north and the Tuttutooq–Ilimmaasaq–Narsarsuaq zone in the south addressed here. The intrusive rocks crystallised at a depth of troctolitic gabbros. These relatively reduced magmas evolved through marked iron enrichment to alkaline salic differentiates. In the Older giant dyke complex, undersaturated augite syenites grade into sodalite foyaite. The larger, c . 1163 Ma Younger giant dyke complex (YGDC) mainly consists of structureless troctolite with localised developments of layered cumulates. A layered pluton (Klokken) is considered to be coeval and presumably comagmatic with the YGDC. At the unconformity between the Ketilidian basement and Gardar rift deposits, the YGDC expanded into a gabbroic lopolith. Its magma may represent a sample from a great, underplated mafic magma reservoir, parental to all the salic alkaline rocks in the southern rift. The bulk of these are silica undersaturated; oversaturated differentiates are probably products of combined fractional crystallisation and crustal assimilation. A major dyke swarm 1–15 km broad was intruded during declining crustal extension, with decreasing dyke widths and increasing differentiation over time. Intersection of the dyke swarm and E–W-trending sinistral faults controlled the emplacement of at least three central complexes (Narssaq, South Qôroq and early Igdlerfigssalik). Three post-extensional complexes (Tugtutôq, Ilímaussaq and late Igdlerfigssalik) along the former rift mark the end of magmatism at c . 1140 Ma. The latter two complexes have oblate plans reflecting ductile, fault-related strain. The Tugtutôq complex comprises quartz syenites and alkali granites. The Ilímaussaq complex mainly consists of nepheline syenite crystallised from highly reduced, Fe-rich phonolitic peralkaline (agpaitic) magma, and resulted in rocks with very high incompatible element concentrations. Abundant anorthositic xenoliths in the mafic and intermediate intrusions point to a large anorthosite protolith at depth which is considered of critical importance in the petrogenesis of the salic rocks. Small intrusions of aillikite and carbonatite may represent remobilised mantle metasomites. The petrological similarity between Older and Younger Gardar suites implies strong lithospheric control of their petrogenesis. The parental magmas are inferred to have been derived from restitic Ketilidian lithospheric mantle, metasomatised by melts from subducting Ketilidian oceanic crust and by small-scale melt fractions associated with Gardar rifting. There are numerous analogies between the southern Gardar rift and the Palaeogene East African rift.



Author(s):  
Scott A. Barboza ◽  
George W. Bergantz

ABSTRACT:Dehydration melting of crustal rocks may commonly occur in response to the intrusion of mafic magma in the mid- or lower crust. However, the relative importance of melt buoyancy, shear or dyking in melt generation and extraction under geologically relevant conditions is not well understood. A numerical model of the partial melting of a metapelite is presented and the model results are compared with the Ivrea-Verbano Zone in northern Italy. The numerical model uses the mixture theory approach to modelling simultaneous convection and phase change and includes special ramping and switching functions to accommodate the rheology of crystal-melt mixtures in accordance with the results of deformation experiments. The model explicitly includes both porous media flow and thermally and compositionally driven bulk convection of a restitecharged melt mass. A range of melt viscosity and critical melt fraction models is considered. General agreement was found between predicted positions of isopleths and those from the Ivrea-Verbano Zone. Maximum melt velocities in the region of porous flow are found to be 1 × 10−7 and 1 × 10−1m per year in the region of viscous flow. The results indicate that melt buoyancy alone may not be a sufficient agent for melt extraction and that extensive, vigorous convection of partially molten rocks above mafic bodies is unlikely, in accord with direct geological examples.



2020 ◽  
Vol 177 (5) ◽  
pp. 965-980
Author(s):  
Robert J. Stern ◽  
Kamal Ali ◽  
Paul D. Asimow ◽  
Mokhles K. Azer ◽  
Matthew I. Leybourne ◽  
...  

We analysed gabbroic and dioritic rocks from the Atud igneous complex in the Eastern Desert of Egypt to understand better the formation of juvenile continental crust of the Arabian–Nubian Shield. Our results show that the rocks are the same age (U–Pb zircon ages of 694.5 ± 2.1 Ma for two diorites and 695.3 ± 3.4 Ma for one gabbronorite). These are partial melts of the mantle and related fractionates (εNd690 = +4.2 to +7.3, 87Sr/86Sri = 0.70246–0.70268, zircon δ18O ∼ +5‰). Trace element patterns indicate that Atud magmas formed above a subduction zone as part of a large and long-lived (c. 60 myr) convergent margin. Atud complex igneous rocks belong to a larger metagabbro–epidiorite–diorite complex that formed as a deep crustal mush into which new pulses of mafic magma were periodically emplaced, incorporated and evolved. The petrological evolution can be explained by fractional crystallization of mafic magma plus variable plagioclase accumulation in a mid- to lower crustal MASH zone. The Atud igneous complex shows that mantle partial melting and fractional crystallization and plagioclase accumulation were important for Cryogenian crust formation in this part of the Arabian–Nubian Shield.Supplementary material: Analytical methods and data, calculated equilibrium mineral temperatures, results of petrogenetic modeling, and cathodluminesence images of zircons can be found at https://doi.org/10.6084/m9.figshare.c.4958822



Author(s):  
T. P. Thayer
Keyword(s):  


Sign in / Sign up

Export Citation Format

Share Document