scholarly journals Energy system contribution during competitive cross-country skiing

2019 ◽  
Vol 119 (8) ◽  
pp. 1675-1690 ◽  
Author(s):  
Thomas Losnegard

AbstractEnergy system contribution during cross-country (XC) skiing races is dependent on several factors, including the race duration, track profile, and sub-techniques applied, and their subsequent effects on the use of the upper and lower body. This review provides a scientific synopsis of the interactions of energy system contributions from a physiological, technical, and tactical perspective. On average, the aerobic proportion of the total energy expended during XC skiing competitions is comparable to the values for other sports with similar racing times. However, during both sprint (≤ 1.8 km) and distance races (≥ 10 and 15 km, women and men, respectively) a high aerobic turnover interacts with subsequent periods of very high work rates at ~ 120 to 160% of VO2peak during the uphill sections of the race. The repeated intensity fluctuations are possible due to the nature of skiing, which involves intermittent downhills where skiers can recover. Thus, the combination of high and sustained aerobic energy turnover and repeated work rates above VO2peak, interspersed with short recovery periods, distinguishes XC skiing from most other endurance sports. The substantially increased average speed in races over recent decades, frequent competitions in mass starts and sprints, and the greater importance of short periods at high speeds in various sub-techniques, have demanded changes in the physiological, technical, and tactical abilities needed to achieve world-class level within the specific disciplines.

1987 ◽  
Vol 3 (4) ◽  
pp. 353-369 ◽  
Author(s):  
Robert W. Norman ◽  
Paavo V. Komi

The purpose of this study was to determine whether world class skiers were alike in their mechanical power outputs (normalized for body mass and velocity and called mechanical cost, MTC) and body segment energy transfers when skiing in competition on level and uphill terrain using the diagonal technique. Eleven competitors were analyzed from film taken during a 15-km World Championship race on a level (1.6°) and uphill (9.0°) section of the course. Metabolic rates were estimated from assumptions concerning the efficiencies of positive and negative work and calculations, from the film, of the mechanical power produced by the skiers. The results showed that skiing on the slope was 2.2 times more demanding mechanically than skiing on a level track (MTC of 4.0 vs. 1.8 J • kg−1• m−1, respectively). Skiers who had high MTC had low energy transfers (r = −0.9). Even in this presumably homogeneous group of elite skiers there were large individual differences in MTC and other mechanical variables, suggesting technique problems for some. Furthermore, on flat terrain the estimated metabolic rate was only about 76% of an MV02of 80 ml • kg−1• min−1. This suggests that speed, using the diagonal stride, may be limited by constraints on body segment utilization and not by the physiological energy delivery system of these highly trained athletes.


2021 ◽  
Vol 3 ◽  
Author(s):  
Per-Øyvind Torvik ◽  
Guro Strøm Solli ◽  
Øyvind Sandbakk

Purpose: To investigate the training characteristics of world-class long-distance cross-country skiers.Methods: Twelve world-class male long-distance cross-country skiing specialists reported training from their best season, through a questionnaire and follow-up interviews. Training data were systemized by training form (endurance, strength, and speed), intensity [low- (LIT), moderate- (MIT), and high-intensity training (HIT)], and exercise mode, followed by a division into different periodization phases. Specific sessions utilized in the various periodization phases were also analyzed.Results: The annual training volume was 861 ± 90 h, consisting of 795 ± 88 h (92%) of endurance training, 53 ± 17 h (6%) of strength training, and 13 ± 14 h (2%) of speed training. A pyramidal (asymptotic) endurance training distribution was employed (i.e., 88.7% LIT, 6.4% MIT, and 4.8% HIT). Out of this, 50–60% of the endurance training was performed with double poling (DP), typically in the form of a daily 3- to 5-h session. A relatively evenly distributed week-to-week periodization of training load was commonly used in the general preparation period, whereas skiers varied between high-load training weeks and competition weeks, with half the training volume and a reduced amount of DP during the competition period.Conclusions: To match the specific demands of long-distance cross-country skiing, specialized long-distance skiers perform relatively long but few training sessions and use a pyramidal intensity distribution pattern and a large amount of training spent using the DP technique.


Author(s):  
Jacob Walther ◽  
Roy Mulder ◽  
Dionne A. Noordhof ◽  
Thomas A. Haugen ◽  
Øyvind Sandbakk

Purpose: To quantify peak age and relative performance progression toward peak age in cross-country skiing according to event type, sex, and athlete performance level. Methods: International Ski Federation (FIS) points (performance expressed relative to the best athlete) of athletes born between 1981 and 1991, competing in junior world championships or finishing top 30 in world championships or Olympics, were downloaded from the FIS website. Individual performance trends were derived by fitting a quadratic curve to each athletes FIS point and age data. Results: Peak age was 26.2 (2.3) years in distance and 26.0 (1.7) years in sprint events. The sex difference in peak age in sprint events was ∼0.8 years (small, P = .001), while there was no significant sex difference in peak age in distance events (P = .668). Top performers displayed higher peak ages than other athletes in distance (mean difference, ±95% confidence limits = 1.6 y, ±0.6 y, moderate, P < .001) and sprint events (1.0, ±0.6 y, moderate, P < .001). FIS point improvement over the 5 years preceding peak age did not differ between event types (P = .325), while men improved more than women in both events (8.8, ±5.4%, small, P = .002 and 7.5, ±6.4%, small, P = .002). Performance level had a large effect on improvement in FIS points in both events (P < .001). Conclusion: This study provides novel insights on peak age and relative performance progression among world-class cross-country skiers and can assist practitioners, sport institutions, and federations with goal setting and evaluating strategies for achieving success.


2016 ◽  
Vol 27 (4) ◽  
pp. 385-398 ◽  
Author(s):  
E. Andersson ◽  
G. Björklund ◽  
H-C. Holmberg ◽  
N. Ørtenblad

2016 ◽  
Vol 11 (7) ◽  
pp. 899-906 ◽  
Author(s):  
Øyvind Sandbakk ◽  
Vegard Rasdal ◽  
Steinar Bråten ◽  
Frode Moen ◽  
Gertjan Ettema

Purpose:To compare sport-specific laboratory capacities and the annual training of world-class Nordic combined (NC) athletes with specialized ski jumpers (SJ) and cross-country (XC) skiers.Methods:Five world-class athletes from each sports discipline were compared. Ski jump imitations were performed on a 3-dimensional force plate in NC athletes and SJ, whereas XC skiing characteristics were obtained from submaximal and maximal roller ski skating on a treadmill in NC athletes and XC skiers. In addition, anthropometrics and annual training characteristics were determined.Results:NC athletes demonstrated 9% higher body mass and showed 17% lower vertical speed in the ski jump imitation than SJ (all P < .05). NC athletes had 12% lower body mass and showed 10% lower peak treadmill speed and 12% lower body-mass-normalized peak oxygen uptake than XC skiers (all P < .05). NC athletes performed half the number of ski-jumping-specific sessions and outdoor ski jumps compared with SJ. NC athletes performed 31% less endurance training, mainly caused by lower amounts of low- and moderate-intensity training in the classical technique, whereas high-intensity strength and speed training and endurance training in the skating technique did not differ substantially from XC skiers.Conclusions:To simultaneously optimize endurance, explosive, and technical capacities in 2 different disciplines, world-class NC athletes train approximately two-thirds of the XC skier’s endurance training volume and perform one-half of the ski-jump-specific training compared with SJ. Still, the various laboratory capacities differed only 10–17% compared with SJ and XC skiers.


2019 ◽  
Vol 51 (4) ◽  
pp. 760-772 ◽  
Author(s):  
THOMAS STÖGGL ◽  
OLLI OHTONEN ◽  
MASAKI TAKEDA ◽  
NAOTO MIYAMOTO ◽  
CORY SNYDER ◽  
...  

2004 ◽  
Vol 38 (4) ◽  
pp. 506-506
Author(s):  
P Blackman

Sensors ◽  
2021 ◽  
Vol 21 (7) ◽  
pp. 2535
Author(s):  
Thomas Stöggl ◽  
Dennis-Peter Born

The aims of the study were to assess the robustness and non-reactiveness of wearable near-infrared spectroscopy (NIRS) technology to monitor exercise intensity during a real race scenario, and to compare oxygenation between muscle groups important for cross-country skiing (XCS). In a single-case study, one former elite XCS (age: 39 years, peak oxygen uptake: 65.6 mL/kg/min) was equipped with four NIRS devices, a high-precision global navigation satellite system (GNSS), and a heart rate (HR) monitor during the Vasaloppet long-distance XCS race. All data were normalized to peak values measured during incremental laboratory roller skiing tests two weeks before the race. HR reflected changes in terrain and intensity, but showed a constant decrease of 0.098 beats per minute from start to finish. Triceps brachii (TRI) muscle oxygen saturation (SmO2) showed an interchangeable pattern with HR and seems to be less affected by drift across the competition (0.027% drop per minute). Additionally, TRI and vastus lateralis (VL) SmO2 revealed specific loading and unloading pattern of XCS in uphill and downhill sections, while rectus abdominus (RA) SmO2 (0.111% drop per minute) reflected fatigue patterns occurring during the race. In conclusion, the present preliminary study shows that NIRS provides a robust and non-reactive method to monitor exercise intensity and fatigue mechanisms when applied in an outdoor real race scenario. As local exercise intensity differed between muscle groups and central exercise intensity (i.e., HR) during whole-body endurance exercise such as XCS, NIRS data measured at various major muscle groups may be used for a more detailed analysis of kinetics of muscle activation and compare involvement of upper body and leg muscles. As TRI SmO2 seemed to be unaffected by central fatigue mechanisms, it may provide an alternative method to HR and GNSS data to monitor exercise intensity.


Sign in / Sign up

Export Citation Format

Share Document