Determination of losses sustained from hydrodynamic failure at a tailing pond located in the northern climatic zone

2007 ◽  
Vol 41 (5) ◽  
pp. 265-267
Author(s):  
S. N. Guzenkov ◽  
N. K. Shul’gina
Keyword(s):  
Climatic Zone ◽  
Tailing Pond

Galactic orbits of stars

1966 ◽  
Vol 25 ◽  
pp. 93-97
Author(s):  
Richard Woolley
Keyword(s):  
Globular Cluster ◽  
Potential Field ◽  
High Velocity ◽  
Velocity Vector ◽  
Variable Stars ◽  
The Sun ◽  
Proper Motions ◽  
Rr Lyrae ◽  
The Galaxy

It is now possible to determine proper motions of high-velocity objects in such a way as to obtain with some accuracy the velocity vector relevant to the Sun. If a potential field of the Galaxy is assumed, one can compute an actual orbit. A determination of the velocity of the globular clusterωCentauri has recently been completed at Greenwich, and it is found that the orbit is strongly retrograde in the Galaxy. Similar calculations may be made, though with less certainty, in the case of RR Lyrae variable stars.

Distance to SN 1987A and the LMC

1999 ◽  
Vol 190 ◽  
pp. 549-554
Author(s):  
Nino Panagia
Keyword(s):  
Angular Size ◽  
Large Magellanic Cloud ◽  
Magellanic Cloud ◽  
Light Curves ◽  
Distance Modulus ◽  
Absolute Size ◽  
Sn 1987A

Using the new reductions of the IUE light curves by Sonneborn et al. (1997) and an extensive set of HST images of SN 1987A we have repeated and improved Panagia et al. (1991) analysis to obtain a better determination of the distance to the supernova. In this way we have derived an absolute size of the ringRabs= (6.23 ± 0.08) x 1017cm and an angular sizeR″ = 808 ± 17 mas, which give a distance to the supernovad(SN1987A) = 51.4 ± 1.2 kpc and a distance modulusm–M(SN1987A) = 18.55 ± 0.05. Allowing for a displacement of SN 1987A position relative to the LMC center, the distance to the barycenter of the Large Magellanic Cloud is also estimated to bed(LMC) = 52.0±1.3 kpc, which corresponds to a distance modulus ofm–M(LMC) = 18.58±0.05.

International determination of the total motion of the pole

1961 ◽  
Vol 13 ◽  
pp. 29-41
Author(s):  
Wm. Markowitz
Keyword(s):  
Secular Motion ◽  
The Future

A symposium on the future of the International Latitude Service (I. L. S.) is to be held in Helsinki in July 1960. My report for the symposium consists of two parts. Part I, denoded (Mk I) was published [1] earlier in 1960 under the title “Latitude and Longitude, and the Secular Motion of the Pole”. Part II is the present paper, denoded (Mk II).

Time and Latitude in South Africa

1972 ◽  
Vol 1 ◽  
pp. 27-38
Author(s):  
J. Hers
Keyword(s):  
South Africa ◽  
Cape Town ◽  
Astronomical Observations ◽  
Royal Observatory ◽  
The Republic ◽  
Astronomical Determination ◽  
Limited Accuracy ◽  
Better Than

In South Africa the modern outlook towards time may be said to have started in 1948. Both the two major observatories, The Royal Observatory in Cape Town and the Union Observatory (now known as the Republic Observatory) in Johannesburg had, of course, been involved in the astronomical determination of time almost from their inception, and the Johannesburg Observatory has been responsible for the official time of South Africa since 1908. However the pendulum clocks then in use could not be relied on to provide an accuracy better than about 1/10 second, which was of the same order as that of the astronomical observations. It is doubtful if much use was made of even this limited accuracy outside the two observatories, and although there may – occasionally have been a demand for more accurate time, it was certainly not voiced.

Large-scale Motion of Solar Filaments

2000 ◽  
Vol 179 ◽  
pp. 205-208
Author(s):  
Pavel Ambrož ◽  
Alfred Schroll
Keyword(s):  
Magnetic Flux ◽  
Proper Motion ◽  
Time Scale ◽  
Large Scale ◽  
Accuracy Of Measurements ◽  
Solar Filaments ◽  
General Movement ◽  
Scale Motion ◽  
Velocity Scatter

AbstractPrecise measurements of heliographic position of solar filaments were used for determination of the proper motion of solar filaments on the time-scale of days. The filaments have a tendency to make a shaking or waving of the external structure and to make a general movement of whole filament body, coinciding with the transport of the magnetic flux in the photosphere. The velocity scatter of individual measured points is about one order higher than the accuracy of measurements.

Practical Realization of a Reference System for Earth Dynamics by Satellite Methods

1975 ◽  
Vol 26 ◽  
pp. 341-380 ◽  
Author(s):  
R. J. Anderle ◽  
M. C. Tanenbaum
Keyword(s):  
Reference Frame ◽  
Polar Motion ◽  
Pole Position ◽  
Control Points ◽  
Significant Information ◽  
Crustal Motion ◽  
Average Reference ◽  
Future Data ◽  
Existing Data

AbstractObservations of artificial earth satellites provide a means of establishing an.origin, orientation, scale and control points for a coordinate system. Neither existing data nor future data are likely to provide significant information on the .001 angle between the axis of angular momentum and axis of rotation. Existing data have provided data to about .01 accuracy on the pole position and to possibly a meter on the origin of the system and for control points. The longitude origin is essentially arbitrary. While these accuracies permit acquisition of useful data on tides and polar motion through dynamio analyses, they are inadequate for determination of crustal motion or significant improvement in polar motion. The limitations arise from gravity, drag and radiation forces on the satellites as well as from instrument errors. Improvements in laser equipment and the launch of the dense LAGEOS satellite in an orbit high enough to suppress significant gravity and drag errors will permit determination of crustal motion and more accurate, higher frequency, polar motion. However, the reference frame for the results is likely to be an average reference frame defined by the observing stations, resulting in significant corrections to be determined for effects of changes in station configuration and data losses.

Models of Thermodynamic Properties of Prominences

1979 ◽  
Vol 44 ◽  
pp. 349-355
Author(s):  
R.W. Milkey
Keyword(s):  
Thermodynamic Properties ◽  
Mass Transport ◽  
Emission Spectrum ◽  
Thermodynamic Parameters ◽  
Working Group ◽  
Physical Processes ◽  
Theoretical Concepts ◽  
Group 3 ◽  
Observational Techniques

The focus of discussion in Working Group 3 was on the Thermodynamic Properties as determined spectroscopically, including the observational techniques and the theoretical modeling of physical processes responsible for the emission spectrum. Recent advances in observational techniques and theoretical concepts make this discussion particularly timely. It is wise to remember that the determination of thermodynamic parameters is not an end in itself and that these are interesting chiefly for what they can tell us about the energetics and mass transport in prominences.

Progress in the compilation of the FK5

1978 ◽  
Vol 48 ◽  
pp. 421-432 ◽  
Author(s):  
W. Fricke ◽  
W. Gliese
Keyword(s):  
Status Report ◽  
Magnitude Range

Abstract:Presented is a status report on work on FK5 giving information on the following items: (a) the intended increase of the number of fundamental stars and their magnitude range in FK5, (b) available material for the improvement of the system, (c) methods for the determination of systematic differences, (d) the determination of equator and equinox of FK5, and (e) the elimination of the motion of the FK4 equinox.

A general computer program for the extended plate overlap algorithm

1978 ◽  
Vol 48 ◽  
pp. 287-293 ◽  
Author(s):  
Chr. de Vegt ◽  
E. Ebner ◽  
K. von der Heide
Keyword(s):  
Computer Program ◽  
Simultaneous Determination ◽  
General Computer Program ◽  
General Computer

In contrast to the adjustment of single plates a block adjustment is a simultaneous determination of all unknowns associated with many overlapping plates (star positions and plate constants etc. ) by one large adjustment. This plate overlap technique was introduced by Eichhorn and reviewed by Googe et. al. The author now has developed a set of computer programmes which allows the adjustment of any set of contemporaneous overlapping plates. There is in principle no limit for the number of plates, the number of stars, the number of individual plate constants for each plate, and for the overlapping factor.

Statistics and parallaxes

1978 ◽  
Vol 48 ◽  
pp. 7-29
Author(s):  
T. E. Lutz
Keyword(s):  
Experimental Design ◽  
Statistical Methods ◽  
Review Paper ◽  
Systematic Errors ◽  
Past Experience ◽  
Random Errors ◽  
Trigonometric Parallaxes ◽  
Systematic And Random Errors

This review paper deals with the use of statistical methods to evaluate systematic and random errors associated with trigonometric parallaxes. First, systematic errors which arise when using trigonometric parallaxes to calibrate luminosity systems are discussed. Next, determination of the external errors of parallax measurement are reviewed. Observatory corrections are discussed. Schilt’s point, that as the causes of these systematic differences between observatories are not known the computed corrections can not be applied appropriately, is emphasized. However, modern parallax work is sufficiently accurate that it is necessary to determine observatory corrections if full use is to be made of the potential precision of the data. To this end, it is suggested that a prior experimental design is required. Past experience has shown that accidental overlap of observing programs will not suffice to determine observatory corrections which are meaningful.

Sign in / Sign up

Export Citation Format

Share Document