A Technique for Estimating the Signal-To-Noise Ratio in Fiber-Optic Transmission Systems with Frequency Division Multiplexing

2017 ◽  
Vol 60 (7) ◽  
pp. 724-730
Author(s):  
V. A. Vardanyan
Keyword(s):  
Fiber Optic ◽  
Signal To Noise Ratio ◽  
Frequency Division Multiplexing ◽  
Frequency Division ◽  
Signal To Noise ◽  
Transmission Systems ◽  
Noise Ratio

scholarly journals Performance on FBMC-OQAM and OFDM Multicarrier Systems

2019 ◽  
Vol 8 (10) ◽  
pp. 1564-1568
Keyword(s):  
Orthogonal Frequency Division Multiplexing ◽  
Filter Bank ◽  
Signal To Noise Ratio ◽  
Cyclic Prefix ◽  
Frequency Division Multiplexing ◽  
Frequency Division ◽  
Signal To Noise ◽  
Multicarrier Systems ◽  
Noise Ratio ◽  
Power Equality

Filter Bank Multi Carrier (FBMC) offers best detestable properties took a gander at over orthogonal frequency division multiplexing (OFDM) to the attack of nonexistent hindrance. FBMC system is a multicarrier structure, particularly sensible for 5G remote correspondences. FBMC beats OFDM as a result of proficient use of the open information move limit and without usage of cyclic prefix (CP). In this paper, we address the issue of remarkable enrollment at the pilot territory and used to audit the channels with pilot picture, in like way consider the fundamental conditions for utilization of the assistant pilot pictures. First and two partner pictures for each pilot plans with power equality uses instead of one picture; it can attainable inspirations driving necessity of OFDM and FBMC depending upon signal to noise ratio (SNR) what's relentlessly possible to improve the introduction of one frivolity pictures by using multiple associate pictures. Finally autonomous the BER execution reenactment results and adornment pilot pictures

scholarly journals Model Kanal 5G dengan Pengaruh Kelembapan pada Frekuensi 3,3 GHz dan Bandwidth 99 MHz Berbasis Convolutional Codes

2021 ◽  
Vol 9 (4) ◽  
pp. 878
Author(s):  
RENI DYAH WAHYUNINGRUM ◽  
KHOIRUN NI’AMAH ◽  
SOLICHAH LARASATI
Keyword(s):  
Orthogonal Frequency Division Multiplexing ◽  
Channel Model ◽  
Signal To Noise Ratio ◽  
Convolutional Codes ◽  
Cyclic Prefix ◽  
Frequency Division Multiplexing ◽  
Frequency Division ◽  
Signal To Noise ◽  
Power Delay Profile ◽  
Noise Ratio

ABSTRAKGenerasi telekomunikasi kelima (5G) diterapkan pada 2021 dengan frekuensi tinggi yang menyebabkan redaman yang besar dibandingkan pita sub-1 GHz. Penelitian ini mengkaji sistem 5G dengan frekuensi operasi 3,3 GHz dan bandwidth 99 MHz berdasarkan spesifikasi 5G dari Cyclic Prefix-Orthogonal Frequency Division Multiplexing (CP-OFDM) numerologi μ = 1 menggunakan parameter lingkungan yang diukur secara langsung di kota Bandung. Penelitian ini menemukan bahwa model kanal 5G dengan pengaruh kelembapan maksimum memiliki power delay profile (PDP) 9 path dengan nilai daya yang lebih kecil dan outage performances (𝑅>𝐶) yang lebih buruk dengan gap sebesar 0,3 dB dibandingkan dengan pengaruh kelembapan minimum. Hasil penelitian menunjukkan bahwa penggunaan convolutional codes dapat membantu menghemat Signal to Noise Ratio (SNR) dengan gap sebesar 3 dB. Hasil dari penelitian ini diharapkan dapat memberikan kontribusi bagi perkembangan komunikasi nirkabel 5G di Indonesia.Kata kunci: 5G, model kanal, convolutional codes, PDP, FER, BER. ABSTRACTThe fifth generation of telecommunications (5G) implemented in 2021, where high frequency which causes a large attenuation compared to the sub-1 GHz band. This research examines a 5G system with an operating frequency of 3.3 GHz and a bandwidth of 99 MHz based on the 5G specification of the Cyclic Prefix - Orthogonal Frequency Division Multiplexing (CP-OFDM) numerology μ = 1 using environmental parameters measured directly in Bandung, Indonesia. This research shows that the 5G channel model under maximum humidity has a 9 power delay profile (PDP) with a smaller power value and worse outage performances (𝑅>𝐶) with a gap of 0.3 dB compared to the effect of minimum humidity. The results showed that the use of convolutional codes can save the Signal to Noise Ratio (SNR) with gap of 3 dB. The results of this research are expected to contribute to the development of 5G wireless communications in Indonesia.Keywords: 5G, channel model, convolutional codes, PDP, FER, BER.

scholarly journals Estimasi Kanal Sistem OFDM pada Kanal Fading Rayleigh dengan Metode Piece-wise Linear

2021 ◽  
Vol 1 (2) ◽  
Author(s):  
Walid Maulana Hadiansyah
Keyword(s):  
Orthogonal Frequency Division Multiplexing ◽  
Signal To Noise Ratio ◽  
Long Term Evolution ◽  
Frequency Division Multiplexing ◽  
Frequency Division ◽  
Signal To Noise ◽  
Term Evolution ◽  
Noise Ratio

Transmisi data kecepatan tinggi menjadi sorotan masyarakat saat ini karena semakin banyak masyarakat menggunakan teknologi nirkabel pita lebar untuk memenuhi kebutuhan sehari-hari. Long Term Evolution (LTE) masih menjadi teknologi eksisting yang memanfaatkan sistem Orthogonal Frequency Division Multiplexing (OFDM) sebagai solusi penghematan bandwidth. Untuk mempertahankan kualitas data dari distorsi, maka dibutuhkan teknik estimasi kanal. Dengan mengetahui hasil estimasi kanal, maka akan didapatkan solusi untuk meminimalisasi efek distorsi. Respon impuls diasumsikan berupa kanal fading Rayleigh. Estimasi kanal yang dipakai adalah metode estimasi Piece-wise Linear dengan 2 slope. Serangkaian penelitian yang bisa dilakukan setelah estimasi kanal adalah estimasi efek doppler, minimalisasi interferensi antar-simbol, dan efisiensi serta optimalisasi sistem. Dari hasil simulasi menggunakan program Matlab dengan 100 kali iterasi, dapat diambil kesimpulan bahwa semakin besar Signal to Noise Ratio (SNR), semakin kecil error yang terjadi. Nilai rata-rata error estimasi dari SNR=9-40 dB adalah 2.4%-38.2%.

scholarly journals Technical Note: Determining regions of interest for CCD camera-based fiber optic luminescence dosimetry by examining signal-to-noise ratio

2011 ◽  
Vol 38 (3) ◽  
pp. 1374-1377 ◽  
Author(s):  
David M. Klein ◽  
Francois Therriault-Proulx ◽  
Louis Archambault ◽  
Tina M. Briere ◽  
Luc Beaulieu ◽  
...  
Keyword(s):  
Fiber Optic ◽  
Signal To Noise Ratio ◽  
Ccd Camera ◽  
Technical Note ◽  
Regions Of Interest ◽  
Signal To Noise ◽  
Luminescence Dosimetry ◽  
Noise Ratio

scholarly journals Joint use of frequency-time division and antinoise coding in radio communication systems with FHSS

2021 ◽  
Vol 9 (4) ◽  
pp. 77-84
Author(s):  
A. A. Paramonov ◽  
Van Zung Hoang
Keyword(s):  
Data Transmission ◽  
Communication Systems ◽  
Error Probability ◽  
Noise Immunity ◽  
Signal To Noise Ratio ◽  
Frequency Division ◽  
Radio Communication ◽  
Signal To Noise ◽  
Noise Ratio ◽  
Time Division

In the context of continuous improvement of radio prospecting and active radio jamming technics along with introduction of automated active countermeasures systems (ACS), the frequency-hopping spread spectrum (FHSS) radio communication systems (RCS) are widely used in order to improve reliability and noise immunity of data transmission. The noise immunity of the RCS affected by unintentional or deliberate interference can be significantly perfected by the combined use of frequency-time division and antinoise coding. This paper explores the case when the interference created by an ACS system with a limited transmitter power covers a part of the RCS frequency range. The receiver gets input mix of the wanted signal, the receiver noise, and probably a deliberate interference also considered as a noise. The article analyzes the noise immunity of signals reception with FHSS in the low-speed radio systems with joint use of frequency-time division of information subsymbols and noise combating codes when the deliberate interference destructively impacts a part of the RCS working band. Dependence of the bit error probability on the signal-to-noise ratio is calculated for the joint use of frequency division of information subsymbols and noise combating codes. It is shown that due to effective use of the frequency-energy resource of a radio line, considering the use of correction codes, a quite high noise immunity of RCS under the influence of deliberate interference can be assured. The indicated dependences of the error probability on the signal-to-noise ratio confirm that the reliability of data transmission can be significantly increased by the proper combination of signal spectrum spreading, applying of correction codes, and frequency division of subsymbols followed by their weight processing.

scholarly journals Signal-to-noise ratio analysis of computational distributed fiber-optic sensing

2020 ◽  
Vol 28 (7) ◽  
pp. 9563 ◽  
Author(s):  
Dayong Shu ◽  
Da-Peng Zhou ◽  
Xinlei Zhou ◽  
Wei Peng ◽  
Liang Chen ◽  
...  
Keyword(s):  
Fiber Optic ◽  
Signal To Noise Ratio ◽  
Ratio Analysis ◽  
Signal To Noise ◽  
Noise Ratio ◽  
Fiber Optic Sensing
Sign in / Sign up

Export Citation Format

Share Document