scholarly journals Joint use of frequency-time division and antinoise coding in radio communication systems with FHSS

2021 ◽  
Vol 9 (4) ◽  
pp. 77-84
Author(s):  
A. A. Paramonov ◽  
Van Zung Hoang
Keyword(s):  
Data Transmission ◽  
Communication Systems ◽  
Error Probability ◽  
Noise Immunity ◽  
Signal To Noise Ratio ◽  
Frequency Division ◽  
Radio Communication ◽  
Signal To Noise ◽  
Noise Ratio ◽  
Time Division

In the context of continuous improvement of radio prospecting and active radio jamming technics along with introduction of automated active countermeasures systems (ACS), the frequency-hopping spread spectrum (FHSS) radio communication systems (RCS) are widely used in order to improve reliability and noise immunity of data transmission. The noise immunity of the RCS affected by unintentional or deliberate interference can be significantly perfected by the combined use of frequency-time division and antinoise coding. This paper explores the case when the interference created by an ACS system with a limited transmitter power covers a part of the RCS frequency range. The receiver gets input mix of the wanted signal, the receiver noise, and probably a deliberate interference also considered as a noise. The article analyzes the noise immunity of signals reception with FHSS in the low-speed radio systems with joint use of frequency-time division of information subsymbols and noise combating codes when the deliberate interference destructively impacts a part of the RCS working band. Dependence of the bit error probability on the signal-to-noise ratio is calculated for the joint use of frequency division of information subsymbols and noise combating codes. It is shown that due to effective use of the frequency-energy resource of a radio line, considering the use of correction codes, a quite high noise immunity of RCS under the influence of deliberate interference can be assured. The indicated dependences of the error probability on the signal-to-noise ratio confirm that the reliability of data transmission can be significantly increased by the proper combination of signal spectrum spreading, applying of correction codes, and frequency division of subsymbols followed by their weight processing.

scholarly journals Comparative analysis of noise immunity of reception of nonlinear complex discrete signals with standard signals AFM-16 BPSK

Radiotekhnika ◽  
2020 ◽  
pp. 133-140
Author(s):  
S.G. Rassomakhin ◽  
A.A. Zamula ◽  
I.D. Gorbenko ◽  
Ho Tri Luc
Keyword(s):  
Comparative Analysis ◽  
Error Probability ◽  
Noise Immunity ◽  
Signal To Noise Ratio ◽  
Statistical Simulation ◽  
Gaussian Channel ◽  
Signal To Noise ◽  
Discrete Signals ◽  
Noise Ratio ◽  
Correlation Properties

The article shows that the solution to the problem of increasing the noise immunity (noise immunity and secrecy of functioning) of the ICS can be achieved using systems of nonlinear signals with improved ensemble, structural and correlation properties. Two classes of nonlinear complex discrete signals are considered: characteristic discrete signals (CDS) and cryptographic signals (CS). Methods for the synthesis of these signals are presented. The paper gives a statistical simulation model for studying the noise immunity of various classes of signals in the Gaussian channel. Using this model, estimates of the dependence of the error probability on the signal-to-noise ratio were obtained for various classes of signals, namely: CDS, KS and standard BPSK AFM-16 signals. It is shown that for the signal-to-noise ratio – 10 the error probability for the CDR is 4.6875e-06, for the CS is 3.515625e-06, and for the AFM-16 is 0.002025. Thus, the use of nonlinear complex discrete signals, in particular, CDS and KS, can significantly increase the noise immunity of signal reception in modern ICS. At the same time, taking into account the improved ensemble and structural properties of these nonlinear signals, it is possible to improve significantly the indicators of crypto- and imitation security of the systems functioning.

scholarly journals NOISE STABILITY OF SIGNAL RECEPTION ALGORITHMS WITH MULTIPULSE PULSE-POSITION MODULATION

2018 ◽  
Vol 42 (1) ◽  
pp. 167-174 ◽  
Author(s):  
V. I. Parfenov ◽  
D. Y. Golovanov
Keyword(s):  
Communication Systems ◽  
Pulse Sequence ◽  
Signal To Noise Ratio ◽  
Point Of View ◽  
Estimation Accuracy ◽  
Pulse Position Modulation ◽  
Signal To Noise ◽  
Pass Filter ◽  
Low Pass Filter ◽  
Noise Ratio

An algorithm for estimating time positions and amplitudes of a periodic pulse sequence from a small number of samples was proposed. The number of these samples was determined only by the number of pulses. The performance of this algorithm was considered on the assumption that the spectrum of the original signal is limited with an ideal low-pass filter or the Nyquist filter, and conditions for the conversion from one filter to the other were determined. The efficiency of the proposed algorithm was investigated through analyzing in which way the dispersion of estimates of time positions and amplitudes depends on the signal-to-noise ratio and on the number of pulses in the sequence. It was shown that, from this point of view, the efficiency of the algorithm decreases with increasing number of sequence pulses. Besides, the efficiency of the proposed algorithm decreases with decreasing signal-to-noise ratio.It was found that, unlike the classical maximum likelihood algorithm, the proposed algorithm does not require a search for the maximum of a multivariable function, meanwhile characteristics of the estimates are practically the same for both these methods. Also, it was shown that the estimation accuracy of the proposed algorithm can be increased by an insignificant increase in the number of signal samples.The results obtained may be used in the practical design of laser communication systems, in which the multipulse pulse-position modulation is used for message transmission. 

scholarly journals Calculations of Signal to Noise Ratio (SNR) for Free Space Optical Communication Systems

2008 ◽  
Vol 5 (1) ◽  
pp. 95-100
Author(s):  
Baghdad Science Journal
Keyword(s):  
Optical Communication ◽  
Free Space ◽  
Communication Systems ◽  
Signal To Noise Ratio ◽  
Full Duplex ◽  
Free Space Optical ◽  
Signal To Noise ◽  
Optical Communication Systems ◽  
Space Optical Communication ◽  
Noise Ratio

In this paper, we calculate and measure the SNR theoretically and experimental for digital full duplex optical communication systems for different ranges in free space, the system consists of transmitter and receiver in each side. The semiconductor laser (pointer) was used as a carrier wave in free space with the specification is 5mW power and 650nm wavelength. The type of optical detector was used a PIN with area 1mm2 and responsively 0.4A/W for this wavelength. The results show a high quality optical communication system for different range from (300-1300)m with different bit rat (60-140)kbit/sec is achieved with best values of the signal to noise ratio (SNR).

THE ANALYTICAL MODEL OF NOISE IMMUNITY CALCULATION OF COMMUNICATION SYSTEMS WITH MULTI-POSITION TYPES OF MODULATION AND CONVOLUTIONAL CODING

2020 ◽  
Author(s):  
Э.Б. ЛИПКОВИЧ ◽  
А.А. СЕРЧЕНЯ
Keyword(s):  
Computer Simulations ◽  
Communication Systems ◽  
Error Probability ◽  
Noise Immunity ◽  
Convolutional Code ◽  
Analytical Models ◽  
Signal To Noise ◽  
Probability Of Error ◽  
Information Efficiency ◽  
Convolutional Coding

Получены математические модели расчета отношений сигнал/шум и несущая/шум, требуемые для обеспечения заданной вероятности ошибки на выходе декодера с «мягким» решением, без необходимости вычисления коэффициентов спектра сверточного кода и выполнения процедур компьютерного моделирования характеристик помехоустойчивости. Приведены расчетные выражения для определения исправляющей способности декодера, энергетического выигрыша от кодирования и информационной эффективности систем связи в зависимости от параметров многопозиционных видов модуляции, сверточного кодирования и вероятности ошибки в информационном бите. По полученным аналитическим моделям построены зависимости и дана оценка результатов исследований. Mathematical models are obtained for calculating signal-to-noise and carrier-to-noise ratios required to provide a given error probability at the decoder output with a “soft” solution and without calculating the convolutional code spectrum coefficients and performing computer simulations of noise immunity characteristics. Calculation expressions are given to determine the correcting ability of the decoder, the energy gain from coding, and the information efficiency of communication systems depending on the parameters of multi-position types of modulation, convolutional coding, and the probability of error in the information bit. Dependencies are constructed according to the obtained analytical models and the research results are evaluated.

Dual-Tree Wavelet Packet Transform for Ultrasonic Data Transmission Through Metal Structures

2015 ◽  
Author(s):  
Jinjiang Wang ◽  
Robert X. Gao ◽  
Xinyao Tang ◽  
Zhaoyan Fan ◽  
Peng Wang
Keyword(s):  
Signal Processing ◽  
Data Transmission ◽  
Signal To Noise Ratio ◽  
Wavelet Packet ◽  
Experimental Studies ◽  
Wavelet Packet Transform ◽  
Signal To Noise ◽  
Metallic Structures ◽  
Time Frequency ◽  
Noise Ratio

Data communication through metallic structures is generally encountered in manufacturing equipment and process monitoring and control. This paper presents a signal processing technique for enhancing the signal-to-noise ratio and high-bit data transmission rate in ultrasound-based wireless data transmission through metallic structures. A multi-carrier coded-ultrasonic wave modulation scheme is firstly investigated to achieve high-bit data rate communication while reducing inter-symbol inference and data loss, due to the inherent signal attenuation, wave diffraction and reflection in metallic structures. To improve the signal-to-noise ratio, dual-tree wavelet packet transform (DT-WPT) has been investigated to separate multi-carrier signals under noise contamination, given its properties of shift-invariance and flexible time frequency partitioning. A new envelope extraction and threshold setting strategy for selected wavelet coefficients is then introduced to retrieve the coded digital information. Experimental studies are performed to evaluate the effectiveness of the developed signal processing method for manufacturing.

scholarly journals Physical layer synchronization algorithms for signal-code sequence increasing noise immunity of dvb-s2x standard vl-snr mode

2021 ◽  
Vol 2021 (1) ◽  
Author(s):  
L. A. Antiufrieva ◽  
◽  
K. K. Iansitov ◽  
A. V. Dvorkovich
Keyword(s):  
Noise Immunity ◽  
Signal To Noise Ratio ◽  
Physical Layer ◽  
Code Sequence ◽  
Signal To Noise ◽  
Synchronization System ◽  
Noise Ratio ◽  
Signal Operating

The work is devoted to expanding the noise immunity of the DVB-S2X standard and the VL-SNR mode physical layer synchronization algorithms. The article proposes a signal-code sequence that increases the noise immunity of the signal, operating down to −11 dB signal-to-noise ratio, and a synchronization system for it.

scholarly journals PERFORMANCE EVALUATION OF SINGLE CARRIER FREQUENCY DOMAIN EQUILIZER (SC-FDE) OVER IMPULSIVE NOISE CHANNEL

2019 ◽  
Vol 11 (2) ◽  
pp. 270-277
Author(s):  
Hussein Abdullah Leftah ◽  
Husham Lateef Swadi
Keyword(s):  
Frequency Domain ◽  
Carrier Frequency ◽  
Communication Systems ◽  
Impulsive Noise ◽  
Signal To Noise Ratio ◽  
High Signal ◽  
Signal To Noise ◽  
Single Carrier ◽  
Noise Ratio ◽  
Error Floors

Impulsive noise is considered as one of the major source of disturbance in the state-of-the-art multicarrier (MC) communication systems. Therefore, several techniques are being constantly proposed to eliminate the effect of such noise. In this work, a time domain matrix interleaved is compiled with a single carrier frequency domain equalizer (SC-FDE) is proposed to reduce the deleterious effects of impulsive noise. A mathematical model for the proposed scheme is also presented in this paper. Simulation results show that the proposed technique superiors the interleaved multicarrier system where the proposed scheme can completely avoid the error floors not only at high signal-to-noise ratio (SNR) but also at heavily distributed impulsive noise. The bit-error-rate (BER) of the alternative proposed scheme decreases as the signal-to-noise ratio (SNR) increases whereas the BER of the standard system suffers from error-floors with a constant BER at about 10-3 for about 8 dB SNR for medium and heavily impulsive noise.

Sign in / Sign up

Export Citation Format

Share Document