Dynamic blocked transfer stiffness method of characterizing the magnetic field and frequency dependent dynamic viscoelastic properties of MRE

2016 ◽  
Vol 28 (4) ◽  
pp. 301-313 ◽  
Author(s):  
Umanath R Poojary ◽  
Sriharsha Hegde ◽  
K.V. Gangadharan
Keyword(s):  
Magnetic Field ◽  
Viscoelastic Properties ◽  
Frequency Dependent ◽  
Stiffness Method ◽  
The Magnetic Field ◽  
Dynamic Blocked Transfer Stiffness

Experimental research of viscoelastic properties and stress relaxation of magnetizable elastomers

2021 ◽  
Vol 57 (2) ◽  
pp. 161-170
Keyword(s):  
Magnetic Field ◽  
Stress Relaxation ◽  
Field Strength ◽  
Viscoelastic Properties ◽  
Uniform Magnetic Field ◽  
Experimental Studies ◽  
Theoretical Research ◽  
Shear Moduli ◽  
Viscosity Coefficients ◽  
The Magnetic Field

Torsional deformations of cylindrical bodies with magnetizable elastomers in a uniform magnetic field are considered. During theoretical research, different models of viscoelastic materials are used. Experimental studies of stress relaxation in a magnetic field are carried out, and the models that consider stress relaxation are used to describe the experiment. Dependences of the shear moduli and viscosity coefficients of magnetizable elastomers on the magnetic field strength are found experimentally. Tables 1, Figs 10, Refs 9.

scholarly journals Experimental Analysis of Viscoelastic Properties of Room Temperature Vulcanized Silicone based Magnetorheological Elastomer

2022 ◽  
Vol 72 (1) ◽  
pp. 98-104
Author(s):  
Sandesh Bhaktha ◽  
Sriharsha Hegde ◽  
Sathish Rao U.
Keyword(s):  
Magnetic Field ◽  
Shear Modulus ◽  
Viscoelastic Properties ◽  
Loss Factor ◽  
Room Temperature ◽  
Sandwich Beam ◽  
Core Material ◽  
Volume Percentage ◽  
Elastomeric Matrix ◽  
The Magnetic Field

Magnetorheological Elastomers (MRE) endure a change in mechanical properties with the application of an externally applied magnetic field. It consists of an elastomeric matrix reinforced with ferromagnetic powdered particles. This paper focuses on the investigation of viscoelastic properties of Room Temperature Vulcanized (RTV) silicone based isotropic MRE in sandwich beam configuration by varying the volume percentage of Carbonyl Iron Powdered (CIP) reinforcement. Viscoelastic properties of the MRE core material were calculated by following the ASTM E756-05 standard. The magnetic field was applied by employing a Halbach array which was numerically analyzed using Finite Element Method Magnetics (FEMM). The magnetic field was varied up to 0.15 T. Loss factor and shear modulus were found to be strongly influenced by the percentage content of CIP. The loss factor and shear modulus of 30% MRE at 0.15 T were higher than other tested samples. The variation of natural frequency with respect to the addition of CIP was validated numerically using Modal analysis conducted in Hyperworks.

Observing the galactic magnetic field

1967 ◽  
Vol 31 ◽  
pp. 375-380
Author(s):  
H. C. van de Hulst
Keyword(s):  
Magnetic Field ◽  
Fair Agreement ◽  
Solar Neighbourhood ◽  
Galactic Magnetic Field ◽  
The Magnetic Field

Various methods of observing the galactic magnetic field are reviewed, and their results summarized. There is fair agreement about the direction of the magnetic field in the solar neighbourhood:l= 50° to 80°; the strength of the field in the disk is of the order of 10-5gauss.

Evolution of Large-Scale Coronal Structures

1994 ◽  
Vol 144 ◽  
pp. 29-33
Author(s):  
P. Ambrož
Keyword(s):  
Magnetic Field ◽  
Field Line ◽  
Large Scale ◽  
Coronal Magnetic Field ◽  
Source Surface ◽  
Solar Cycles ◽  
Characteristic Relationship ◽  
The Magnetic Field ◽  
Coronal Structures

AbstractThe large-scale coronal structures observed during the sporadically visible solar eclipses were compared with the numerically extrapolated field-line structures of coronal magnetic field. A characteristic relationship between the observed structures of coronal plasma and the magnetic field line configurations was determined. The long-term evolution of large scale coronal structures inferred from photospheric magnetic observations in the course of 11- and 22-year solar cycles is described.Some known parameters, such as the source surface radius, or coronal rotation rate are discussed and actually interpreted. A relation between the large-scale photospheric magnetic field evolution and the coronal structure rearrangement is demonstrated.

Emergence of Twisted Magnetic Flux Related Sigmoidal Brightening

2000 ◽  
Vol 179 ◽  
pp. 263-264
Author(s):  
K. Sundara Raman ◽  
K. B. Ramesh ◽  
R. Selvendran ◽  
P. S. M. Aleem ◽  
K. M. Hiremath
Keyword(s):  
Magnetic Field ◽  
Magnetic Fields ◽  
Magnetic Flux ◽  
Ultra Violet ◽  
Active Regions ◽  
Morphological Properties ◽  
Energy Storage And Conversion ◽  
The Sun ◽  
X Rays ◽  
The Magnetic Field

Extended AbstractWe have examined the morphological properties of a sigmoid associated with an SXR (soft X-ray) flare. The sigmoid is cospatial with the EUV (extreme ultra violet) images and in the optical part lies along an S-shaped Hαfilament. The photoheliogram shows flux emergence within an existingδtype sunspot which has caused the rotation of the umbrae giving rise to the sigmoidal brightening.It is now widely accepted that flares derive their energy from the magnetic fields of the active regions and coronal levels are considered to be the flare sites. But still a satisfactory understanding of the flare processes has not been achieved because of the difficulties encountered to predict and estimate the probability of flare eruptions. The convection flows and vortices below the photosphere transport and concentrate magnetic field, which subsequently appear as active regions in the photosphere (Rust & Kumar 1994 and the references therein). Successive emergence of magnetic flux, twist the field, creating flare productive magnetic shear and has been studied by many authors (Sundara Ramanet al.1998 and the references therein). Hence, it is considered that the flare is powered by the energy stored in the twisted magnetic flux tubes (Kurokawa 1996 and the references therein). Rust & Kumar (1996) named the S-shaped bright coronal loops that appear in soft X-rays as ‘Sigmoids’ and concluded that this S-shaped distortion is due to the twist developed in the magnetic field lines. These transient sigmoidal features tell a great deal about unstable coronal magnetic fields, as these regions are more likely to be eruptive (Canfieldet al.1999). As the magnetic fields of the active regions are deep rooted in the Sun, the twist developed in the subphotospheric flux tube penetrates the photosphere and extends in to the corona. Thus, it is essentially favourable for the subphotospheric twist to unwind the twist and transmit it through the photosphere to the corona. Therefore, it becomes essential to make complete observational descriptions of a flare from the magnetic field changes that are taking place in different atmospheric levels of the Sun, to pin down the energy storage and conversion process that trigger the flare phenomena.

On the Configuration of the Magnetic Field of β CrB

1976 ◽  
Vol 32 ◽  
pp. 613-622
Author(s):  
I.A. Aslanov ◽  
Yu.S. Rustamov
Keyword(s):  
Magnetic Field ◽  
Field Strength ◽  
Radial Velocity ◽  
Magnetic Field Strength ◽  
Complex Shape ◽  
Rotation Period ◽  
Field Variation ◽  
Magnetic Field Variation ◽  
Secular Variations ◽  
The Magnetic Field

SummaryMeasurements of the radial velocities and magnetic field strength of β CrB were carried out. It is shown that there is a variability with the rotation period different for various elements. The curve of the magnetic field variation measured from lines of 5 different elements: FeI, CrI, CrII, TiII, ScII and CaI has a complex shape specific for each element. This may be due to the presence of magnetic spots on the stellar surface. A comparison with the radial velocity curves suggests the presence of a least 4 spots of Ti and Cr coinciding with magnetic spots. A change of the magnetic field with optical depth is shown. The curve of the Heffvariation with the rotation period is given. A possibility of secular variations of the magnetic field is shown.

Materials for Electron Beam Information Storage

1969 ◽  
Vol 27 ◽  
pp. 152-153 ◽  
Author(s):  
D. E. Speliotis
Keyword(s):  
Magnetic Field ◽  
Electron Beam ◽  
Recent Literature ◽  
Electron Beams ◽  
Information Storage ◽  
The Subject ◽  
The Magnetic Field

The interaction of electron beams with a large variety of materials for information storage has been the subject of numerous proposals and studies in the recent literature. The materials range from photographic to thermoplastic and magnetic, and the interactions with the electron beam for writing and reading the information utilize the energy, or the current, or even the magnetic field associated with the electron beam.

A Super-High-Resolution HVEM (H-1500) Newly Installed in NIRIM

1990 ◽  
Vol 48 (1) ◽  
pp. 142-143
Author(s):  
S. Horiuchi ◽  
Y. Matsui
Keyword(s):  
Magnetic Field ◽  
High Resolution ◽  
Chromatic Aberration ◽  
Inorganic Materials ◽  
Electron Gun ◽  
Resolving Power ◽  
National Budget ◽  
Voltage Electron ◽  
Specimen Holder ◽  
The Magnetic Field

A new high-voltage electron microscope (H-1500) specially aiming at super-high-resolution (1.0 Å point-to-point resolution) is now installed in National Institute for Research in Inorganic Materials ( NIRIM ), in collaboration with Hitachi Ltd. The national budget of about 1 billion yen including that for a new building has been spent for the construction in the last two years (1988-1989). Here we introduce some essential characteristics of the microscope.(1) According to the analysis on the magnetic field in an electron lens, based on the finite-element-method, the spherical as well as chromatic aberration coefficients ( Cs and Cc ). which enables us to reach the resolving power of 1.0Å. have been estimated as a function of the accelerating As a result of the calculaton. it was noted that more than 1250 kV is needed even when we apply the highest level of the technology and materials available at present. On the other hand, we must consider the protection against the leakage of X-ray. We have then decided to set the conventional accelerating voltage at 1300 kV. However. the maximum accessible voltage is 1500 kV, which is practically important to realize higher voltage stabillity. At 1300 kV it is expected that Cs= 1.7 mm and Cc=3.4 mm with the attachment of the specimen holder, which tilts bi-axially in an angle of 35° ( Fig.1 ). In order to minimize the value of Cc a small tank is additionally placed inside the generator tank, which must serve to seal the magnetic field around the acceleration tube. An electron gun with LaB6 tip is used.

Sign in / Sign up

Export Citation Format

Share Document