A study of the vibrational motions of water in an aqueous CaCl2 solution

1986 ◽  
Vol 106 (2) ◽  
pp. 205-212 ◽  
Author(s):  
P. Bopp
Keyword(s):  
Foods ◽  
2021 ◽  
Vol 10 (6) ◽  
pp. 1368
Author(s):  
Marbie Alpos ◽  
Sze Ying Leong ◽  
Indrawati Oey

Legumes are typically soaked overnight to reduce antinutrients and then cooked prior to consumption. However, thermal processing can cause over-softening of legumes. This study aimed to determine the effect of calcium addition (0, 100, 300, and 500 ppm in the form of calcium chloride, CaCl2), starting from the overnight soaking step, in reducing the loss of firmness of black beans during thermal processing for up to 2 h. The impact of calcium addition on the in vitro starch and protein digestibility of cooked beans was also assessed. Two strategies of calcium addition were employed in this study: (Strategy 1/S1) beans were soaked and then cooked in the same CaCl2 solution, or (Strategy 2/S2) cooked in a freshly prepared CaCl2 solution after the calcium-containing soaking medium was discarded. Despite the texture degradation of black beans brought about by increasing the cooking time, texture profile analysis (TPA) revealed that their hardness, cohesiveness, springiness, chewiness, and resilience improved significantly (p < 0.05) with increasing calcium concentration. Interestingly, beans cooked for 2 h with 300 ppm CaCl2 shared similar hardness with beans cooked for 1 h without calcium addition. Starch and protein digestibility of calcium-treated beans generally improved with prolonged cooking. However, calcium-treated beans cooked for 1 h under S2 achieved a reduced texture loss and a lower starch digestibility than those beans treated in S1. A lower starch digestion could be desired as this reflects a slow rise in blood glucose levels. Findings from this result also showed that treating black beans with high level of CaCl2 (i.e., 500 ppm) was not necessary, otherwise this would limit protein digestibility of cooked black beans.


BioResources ◽  
2021 ◽  
Vol 16 (3) ◽  
pp. 5780-5793
Author(s):  
Ji-Soo Park ◽  
Chan-Woo Park ◽  
Song-Yi Han ◽  
Eun-Ah Lee ◽  
Azelia Wulan Cindradewi ◽  
...  

Cellulose nanocrystals (CNCs) were wet-spun in a coagulation bath for the fabrication of microfilaments, and the effect of sodium alginate (AL) addition on the wet-spinnability and properties of the microcomposite filament was investigated. The CNC suspension exhibited excellent wet-spinnability in calcium chloride (CaCl2) solution, and the addition of AL in CNC suspension resulted in the enhancement of the wet-spinnability of CNCs. As the AL content increased from 3% to 10%, the average diameter of the microcomposite filament decreased, and its tensile properties deteriorated. The increased spinning rate caused an increase in the orientation index of CNCs, resulting in an improvement in the tensile properties of the microcomposite filament.


Fuel ◽  
2009 ◽  
Vol 88 (7) ◽  
pp. 1286-1293 ◽  
Author(s):  
Baohong Guan ◽  
Liuchun Yang ◽  
Zhongbiao Wu ◽  
Zhuoxian Shen ◽  
Xianfa Ma ◽  
...  

2009 ◽  
Vol 104 (5) ◽  
pp. 276-284
Author(s):  
Itoe TAMURA ◽  
Naotatsu SHIKAZONO ◽  
Masataka NAKATA

1994 ◽  
Vol 34 (1) ◽  
pp. 123 ◽  
Author(s):  
CMC Yuen ◽  
N Caffin ◽  
D Boonyakiat

Mature but unripe Fuerte and Hass avocados harvested at 3 stages of maturity were vacuum-infiltrated with 4 and 8% calcium chloride (CaCl2) solutions and stored at 20�C. The fruit were assessed for ripening and injury development and analysed for Ca content. Postharvest application of Ca to fruit harvested 2 weeks before prime harvest elicited a greater delay in ripening and caused less fruit injury than application at prime harvest or 2 weeks after prime harvest. Fruit maturity did not have a significant effect on the amount of Ca taken up by fruit when infiltrated with each CaCl2 solution. Vacuum infiltration with 8% CaCl2 solution greatly enhanced the uptake of Ca by both Hass and Fuerte fruit but did not delay ripening further than 4% CaCl2 treatment.


2015 ◽  
Vol 51 (65) ◽  
pp. 12935-12938 ◽  
Author(s):  
Yoshihisa Sakata ◽  
Takuya Hayashi ◽  
Ryō Yasunaga ◽  
Nobuyuki Yanaga ◽  
Hayao Imamura

Remarkably high photocatalytic activity for the overall H2O splitting was achieved by utilizing a Rh0.5Cr1.5O3(Rh; 0.5 wt%)/Zn(3 mol%)–Ga2O3 photocatalyst when Ga2O3 was prepared using dilute CaCl2 aqueous solution (0.001 mol l−1).


2009 ◽  
Vol 24 (1_suppl) ◽  
pp. 48-62 ◽  
Author(s):  
Rui Yao ◽  
Renji Zhang ◽  
Xiaohong Wang

A cell encapsulation device based on the principle of high-voltage dispersion technology was designed and constructed. The parameters that influenced the formation of cell microcapsules, such as; voltage, push speed, electrode distance, and syringe size were analyzed and optimized. Unlike the traditional cell microencapsulating devices, both of the electrodes were separated from the CaCl2 solution in this device, which simplified the procedure of keeping the operation within a sanitary environment. Integrated adipose derived stem cell (ADSC) microcapsules with smooth surface and consistent diameter distribution were prepared. After 1-week in culture as a microcapsule and 3 days assembled in a construct, the ADSCs maintained a high viability and significant proliferation that established a favorable basis for the controlled assembly of cell microcapsules.


Sign in / Sign up

Export Citation Format

Share Document