scholarly journals Instantaneous d frame driven shunt active filter for harmonics and reactive power mitigation using Xilinx System Generator

2019 ◽  
Vol 10 (1) ◽  
pp. 15-22 ◽  
Author(s):  
Ramakrishnan Sriranjani ◽  
Subbaiah Jayalalitha
Keyword(s):  
Reactive Power ◽  
Active Filter ◽  
Shunt Active Filter ◽  
System Generator ◽  
Xilinx System Generator

scholarly journals Enhancing the LVRT Capability and Mitigation of Power Quality Issues Using UPQC of a Grid Connected Wind Conversion System

2017 ◽  
Vol 7 (3) ◽  
pp. 643
Author(s):  
C.S Boopathi ◽  
Kuppusamy Selvakumar ◽  
Avisek Dutta
Keyword(s):  
Power Quality ◽  
Reactive Power ◽  
Low Voltage ◽  
Active Filter ◽  
Shunt Active Filter ◽  
Unified Power Quality Conditioner ◽  
Conversion System ◽  
Quality Issues ◽  
Power Quality Conditioner ◽  
Doubly Fed

In this paper unified power quality conditioner has been used to enhance low voltage ride through capability of grid connected wind conversion system taking Doubly fed induction generator (DFIG). Unified Power quality conditioner (UPQC) device is a combination of series active filter and shunt active filter. This custom power device is mainly used to mitigate power quality issues which is an essential factor today because of wide application of power electronics devices. UPQC is capable to deal with voltage and current imperfection simultaneously. It is installed in the system mainly to improve the power quality i.e. Voltage sag/swell, Harmonics, reactive power compensation etc. at point of common coupling. System is modeled in MATLAB/SIMULINK and results shows utilization of UPQC for the enhancement of LVRT of a DFIG wind system according to Grid code. when fault occurs in the system, it will create voltage dip and series compensator of UPQC injects during this time to prevent disconnection from grid and stay connected to contribute during fault. UPQC is also used for fast restoration of system steady state, power factor improvement, prevent rotor over current.

scholarly journals Design and Simulation of three Phase three Wire Shunt Active Filter using Instantaneous PQ Theory

2020 ◽  
Vol 15 (1) ◽  
pp. 181-186
Author(s):  
Tilak Giri ◽  
Ram Prasad Pandey ◽  
Sabin Bhandari ◽  
Sujan Moktan ◽  
Lagat Karki
Keyword(s):  
Power Factor ◽  
Communication Systems ◽  
Reactive Power ◽  
Active Filter ◽  
Shunt Active Filter ◽  
Current Harmonics ◽  
Passive Filter ◽  
Three Phase ◽  
Wide Range ◽  
Source Current

Due to intensive use of power converters and other non-linear loads, power quality is degrading. The presence of harmonics in the power lines result in greater power losses in distribution, interference problems in communication systems. Non linearity reduces the efficiency and power factor of the system. As the power factor reduces, the reactive power demanded from the supply increases which have no any contribution in energy transfer, so compensation is required. For this, shunt passive filter has been developed but it is bulky and frequency dependent and has many drawbacks. In contrast to passive filter, shunt active filter (SAF) has been developed which is smaller and has wide range of applications. In this paper, shunt active filter based on p-q theory is demonstrated for compensating reactive power and current harmonics. Simulation has been done with and without SAF and results are presented and ended with recommendation and conclusion. An effort is made to reduce the THD of the source current below 5% (specified by IEEE).

PHOTOVOLTAIC SYSTEM WITH A DC–DC CONVERTER FED SHUNT ACTIVE FILTER FOR POWER QUALITY IMPROVEMENT USING ICos Φ ALGORITHM

2014 ◽  
Vol 23 (09) ◽  
pp. 1450132 ◽  
Author(s):  
G. VIJAYAKUMAR ◽  
R. ANITA
Keyword(s):  
Fuzzy Logic Controller ◽  
Reactive Power ◽  
Active Filter ◽  
Photovoltaic System ◽  
Pv System ◽  
Shunt Active Filter ◽  
Point Tracking ◽  
Consequent Reduction ◽  
Small Industry ◽  
Power Point

This paper presents an operation of photovoltaic (PV)-based shunt active filter (SAF) for significant energy conservation, harmonic mitigation and reactive power compensation. When the PV system generates excessive or equal power required to the load demand, then the coordinating logic disconnects the service grid from the load and with a consequent reduction of panel tariff and global warming gasses. The PV module is connected to the DC side of SAF through the DC–DC converter. Converter switch is controlled by fuzzy-based perturb & observe (P&O) maximum power point tracking (MPPT) algorithm and it eliminates the drawback in the conventional PV system. The reference currents are extracted by the fuzzy logic controller-based ICos Φ control strategy. This proposed PV-SAF, if connected at the terminals of a small industry or a home or a small enlightening institution can avoid the use of interruptible power supply and individual stabilizer. An emulation using MATLAB Simulink is presented to validate the advantage of the proposed system.

Sign in / Sign up

Export Citation Format

Share Document