Study of droplet vaporization of various vegetable oils and blends of domestic fuel oil–cottonseed oil under different ambient temperature conditions

2012 ◽  
Vol 46 ◽  
pp. 653-663 ◽  
Author(s):  
T. Daho ◽  
G. Vaitilingom ◽  
O. Sanogo ◽  
S.K. Ouiminga ◽  
B.G. Segda ◽  
...  
Fuel ◽  
2009 ◽  
Vol 88 (7) ◽  
pp. 1261-1268 ◽  
Author(s):  
T. Daho ◽  
G. Vaitilingom ◽  
O. Sanogo

Author(s):  
Sangchae Kim ◽  
Bharath Bethala ◽  
Simone Ghirlanda ◽  
Senthil N. Sambandam ◽  
Shekhar Bhansali

Magnetocaloric refrigeration is increasingly being explored as an alternative technology for cooling. This paper presents the design and fabrication of a micromachined magnetocaloric cooler. The cooler consists of fluidic microchannels (in a Si wafer), diffused temperature sensors, and a Gd5(Si2Ge2) magnetocaloric refrigeration element. A magnetic field of 1.5 T is applied using an electromagnet to change the entropy of the magnetocaloric element for different ambient temperature conditions ranging from 258 K to 280 K, and the results are discussed. The tests show a maximum temperature change of 7 K on the magnetocaloric element at 258 K. The experimental results co-relate well with the entropy change of the material.


2012 ◽  
Vol 443-444 ◽  
pp. 996-1006 ◽  
Author(s):  
Yu Liu ◽  
Jun Li ◽  
Ying Gao ◽  
Xin Mei Yuan

Different blend ratio of ternary component fuel was tested inside a constant volume chamber to investigate fuel injection and combustion under similar real engine working conditions. Because liquid spray light scattering is the different reflective rate from the liquid droplets and its surrounding background, butanol-biodiesel-diesel liquid jet penetration length can be highlighted in the images taken by high speed camera. Various ambient temperatures from 800K to 1200K and fuel composition were investigated. Measured results showed that sudden but repeatable drop of liquid jet penetration length at constant ambient temperature conditions of 800K and 900K. With ambient temperature increasing, this phenomenon became weak and disappeared. So more works focus on non-combusting experiments in order to delete combustion reflect. With butanol and biodiesel content increasing, micro explosion becomes prone excited and more violent because of the enlarged differences in volatilities and boiling point among the components. It is concluded that micro explosion which will distinctly enhances premixed combustion process and heat release rate but it present under certain initial ambient temperature conditions only and the light fuel content shouldn’t be lower than 10%.


2019 ◽  
Vol 2019 (4) ◽  
pp. 119-126
Author(s):  
CH Bekmurotov ◽  

The article reviewed the certification and quality control of the technological process for the production of vegetable oil. There is a procedure for packaging, quality control of products, determination of quality indicators and quality control of finished products. The procedure for using refined cottonseed oil and its varieties, the requirements for placement and storage of vegetable oils, as specified in the regulatory documents, the quality control of vegetable oils and other solutions for cottonseed oil are provided. The gas analyzer shows a solution for measuring the amount of solution by painting the tubes of a mixture of gas and air in oil. Detailed information on the production of vegetable oils, the cost of raw materials, the level of fat content of cotton seeds and the methods used to produce oil from cotton seeds. Methods for certification of vegetable oils, types of quality control, methods of testing and quality determination are presented. It was shown that the procedure for refined production of cottonseed oils and their types, as well as the state of the product classification of products based on the method of producing vegetable oils for consumer purposes, analysis of the sequence of refined oils and refining processes.


1945 ◽  
Vol 14 (1-2) ◽  
pp. 45-58 ◽  
Author(s):  
K. M. Henry ◽  
S. K. Kon ◽  
T. P. Hilditch ◽  
M. L. Meara

1. A series of experiments with rats is described in which the growth-promoting properties of butter fat have been compared with those of the solid and liquid fractions of butter fat, with margarine and with certain vegetable oils.2. The separation of butter fat into fractions containing a preponderance of glycerides of saturated or unsaturated acids was effected by means of crystallization from acetone.3. The following results were obtained by incorporating fats in liquid skim milk:(a) No differences were detected between the growth-promoting properties of butter and margarine or of butter fat and deodorized arachis oil; in the latter comparison the arachis oil was more economically used than the butter fat.(b) No differences were found between butter fat and maize oil alone or containing the solid or liquid fractions of butter fat in the approximate proportions in which they occur in the original fat. The less saturated oils, i.e. maize oil and maize oil + the liquid butter fraction, were more economically used than butter fat and its solid fraction mixed with maize oil.(c) No differences were observed between the growth-promoting values of butter fat, arachis oil, cottonseed oil or soya-bean oil. The butter fat was rather less well utilized than the less saturated oils, but the differences were not significant.(d) Poorer growth was observed with the more saturated fraction of butter fat than with the original fat or the liquid fraction.4. When butter fat, margarine fat or arachis oil was incorporated in a dry basal diet, no differences were observed in the growth-promoting value of these fats, but the arachis oil was more economically used than the other fats. This finding was not con- firmed in a second experiment of longer duration in which poorer growth was observed with the arachis-oil diet, though the economy of gains was the same with all diets.5. It is concluded from these experiments that it is unlikely that butter fat possesses superior nutritive properties to those of other fats, and that the more saturated fraction of butter fat is certainly not superior in growth-promoting value to that of the more unsaturated fraction or to more unsaturated vegetable oils.


2020 ◽  
Vol 271 ◽  
pp. 115158
Author(s):  
Gaurav Bhattacharjee ◽  
Hari Prakash Veluswamy ◽  
Rajnish Kumar ◽  
Praveen Linga

2020 ◽  
Vol 11 (25) ◽  
pp. 6500-6509 ◽  
Author(s):  
Michael Fairley ◽  
Leonie J. Bole ◽  
Florian F. Mulks ◽  
Laura Main ◽  
Alan R. Kennedy ◽  
...  

Using 2-methyl THF as solvent enables efficient and ultrafast amidation of esters by lithium amides at room temperature in air, edging closer towards reaching air- and moisture-compatible polar organometallic chemistry.


2013 ◽  
Vol 13 (6) ◽  
pp. 757-764 ◽  
Author(s):  
George Pantazopoulos ◽  
Athanasios Vazdirvanidis ◽  
Andreas Rikos ◽  
Anagnostis Toulfatzis

1989 ◽  
Vol 1989 (1) ◽  
pp. 149-153
Author(s):  
Jean-Yves Huet ◽  
Yannick Naour ◽  
Jean-Pierre Belluteau ◽  
Christian Bocard ◽  
Christian Such ◽  
...  

ABSTRACT On January 31, 1988, the Amazzone spilled about 1,500 tons of a highly paraffinic medium fuel oil (having a pour point of 36°C) along a distance of 300 km off the coast of Brittany. Due to very rough sea conditions, no offshore recovery operation could be carried out. Most of the pollution was beached as scattered patches on numerous sites, including pebble beaches in south Finistère, which had been especially difficult to clean during previous spills. In this area, the pebble banks that protect the dunes are relatively exposed to erosion. It was therefore decided to try cleaning these pebbles on site using the mobile plant that was designed for washing polluted sands and tested in 1985. The plant prototype was put in working order and conveyed to the site on the Baie d'Audierne. The equipment was very easily adapted to washing the pebbles polluted by a mixture of sand and fuel oil emulsion. A total of 1,400 m3 was cleaned during 10 days at the end of March. The plant worked smoothly with a load of 20 to 25 m3 of pebbles per hour and using a petroleum solvent as a washing agent. Because the ambient temperature was rather low (around 5°C), cleaning was performed with warmed water. Compared to other techniques that could be used to clean polluted pebble beaches, the washing plant proved very effective (providing good cleaning and high throughput) and competitive (costing less than quicklime treatment, for instance). Another advantage of this technique is that cleaned pebbles are returned to the beach, helping the pebble bank to keep its anti-erosion function.


2016 ◽  
Vol 128 (52) ◽  
pp. 16379-16382 ◽  
Author(s):  
Cristian Vidal ◽  
Joaquín García-Álvarez ◽  
Alberto Hernán-Gómez ◽  
Alan R. Kennedy ◽  
Eva Hevia

Sign in / Sign up

Export Citation Format

Share Document