Effect of freezing and heating on the screw withdrawal capacity of Norway spruce and European larch wood

2021 ◽  
Vol 303 ◽  
pp. 124457
Author(s):  
Miroslav Gašparík ◽  
Elham Karami ◽  
Anil Kumar Sethy ◽  
Sumanta Das ◽  
Tomáš Kytka ◽  
...  
2016 ◽  
Vol 13 (5) ◽  
pp. 1537-1552 ◽  
Author(s):  
Marta Petrillo ◽  
Paolo Cherubini ◽  
Giulia Fravolini ◽  
Marco Marchetti ◽  
Judith Ascher-Jenull ◽  
...  

Abstract. Due to the large size (e.g. sections of tree trunks) and highly heterogeneous spatial distribution of deadwood, the timescales involved in the coarse woody debris (CWD) decay of Picea abies (L.) Karst. and Larix decidua Mill. in Alpine forests are largely unknown. We investigated the CWD decay dynamics in an Alpine valley in Italy using the chronosequence approach and the five-decay class system that is based on a macromorphological assessment. For the decay classes 1–3, most of the dendrochronological samples were cross-dated to assess the time that had elapsed since tree death, but for decay classes 4 and 5 (poorly preserved tree rings) radiocarbon dating was used. In addition, density, cellulose, and lignin data were measured for the dated CWD. The decay rate constants for spruce and larch were estimated on the basis of the density loss using a single negative exponential model, a regression approach, and the stage-based matrix model. In the decay classes 1–3, the ages of the CWD were similar and varied between 1 and 54 years for spruce and 3 and 40 years for larch, with no significant differences between the classes; classes 1–3 are therefore not indicative of deadwood age. This seems to be due to a time lag between the death of a standing tree and its contact with the soil. We found distinct tree-species-specific differences in decay classes 4 and 5, with larch CWD reaching an average age of 210 years in class 5 and spruce only 77 years. The mean CWD rate constants were estimated to be in the range 0.018 to 0.022 y−1 for spruce and to about 0.012 y−1 for larch. Snapshot sampling (chronosequences) may overestimate the age and mean residence time of CWD. No sampling bias was, however, detectable using the stage-based matrix model. Cellulose and lignin time trends could be derived on the basis of the ages of the CWD. The half-lives for cellulose were 21 years for spruce and 50 years for larch. The half-life of lignin is considerably higher and may be more than 100 years in larch CWD. Consequently, the decay of Picea abies and Larix decidua is very low. Several uncertainties, however, remain: 14C dating of CWD from decay classes 4 and 5 and having a pre-bomb age is often difficult (large age range due to methodological constraints) and fall rates of both European larch and Norway spruce are missing.


Holzforschung ◽  
2018 ◽  
Vol 72 (10) ◽  
pp. 871-879 ◽  
Author(s):  
Daniel F. Llana ◽  
Guillermo Íñiguez-González ◽  
Joaquín Montón ◽  
Francisco Arriaga

AbstractNeedle penetration resistance (NPR), screw withdrawal resistance (SWR), core drilling (CD) and drilling chips extraction (DCE) are nondestructive and semi-destructive techniques used to estimate density in timber structures. In most of the previous studies, these techniques were tested in clear sawn timber and clear specimens. The goal of the present paper is to study the relationship between density and these techniques by means of five different devices in whole pieces of timber from built-in engineering structures, which are from 12 4.5-m long structural timber joists of Norway spruce from a 19thcentury building in Barcelona (Catalonia, Spain). Although determination coefficients (R2) for density estimation models were lower than those from clear timber, the results obtained confirmed that these four techniques are suitable forin-situdensity estimation of woods in buildings. The best results were obtained by CD (the bigger the bit, the higher the correlation), followed by DCE, and SWR. The worst correlation was found for NPR devices, but the results could be probably improved with more measurements.


2020 ◽  
Vol 111 ◽  
pp. 43-52
Author(s):  
Bartłomiej Pazio ◽  
Piotr Boruszewski

Analysis of the influence of larch fibers and particles on selected properties of fiber- and particleboards. The paper presents the results of the research on the effect of the addition of fibers and particles obtained from European larch wood (Larix decidua Mill) from plantations on selected properties of fiber- and particleboards in comparison to the boards of the same structure based on typical industrial raw material (pine wood) uses by European wood based panels industry. The differences were shown in the tests, i.e.: modulus of rupture (MOR), modulus of elasticity in static bending (MOE), internal bond (IB), thickness swelling after 2 and 24 hours soaking in water and density profile. In the MOR and MOE tests, larch boards with a minimum 50% fiber share were characterized by comparable values of the properties determined to pine boards, while in the other variants, boards made of pine wood had better properties. In most cases, the larch boards were characterized by significantly lower values of swelling by thickness (with the exception of boards made of fibers) than boards made of wood from forest cultivation. The density profile of the boards on the cross-section of the plantation raw material did not differ from the boards made of pine raw material.


2020 ◽  
Vol 139 (3) ◽  
pp. 459-472
Author(s):  
Jan Cukor ◽  
Aleš Zeidler ◽  
Zdeněk Vacek ◽  
Stanislav Vacek ◽  
Václav Šimůnek ◽  
...  

2019 ◽  
Vol 65 (No. 6) ◽  
pp. 203-208
Author(s):  
Hana Prknová

The cones of the giant sequoia contain red, water-soluble crystalline substances known as cone crystals. The inhibitory effect of this extracted material on Norway spruce, Scots pine and European larch germination was newly examined. Sown seed representative samples without and with added cone crystals were compared after their incubation in the same appropriate conditions. All these cases have brought compelling evidence that cone crystals totally inhibit germination. However, the chemically inhibited seeds being rinsed afterwards germinated very well. This switch effect caused by the cone crystals of the three above-mentioned conifers proved to be a nonspecific tool. Seeds of the giant sequoia, naturally affected by the cone crystals, were sown as rinsed and non-rinsed samples. Both the samples, grown on a wet peat substrate in appropriate conditions for 16 weeks, exhibited an equal, yet very low viability of 1.3% at the same time. This low number, fixed in seeds of the tree being far from the ecological optimum, does not allow any disputation with other authors.


Forests ◽  
2020 ◽  
Vol 11 (1) ◽  
pp. 92 ◽  
Author(s):  
Magdalena Czajka ◽  
Beata Fabisiak ◽  
Ewa Fabisiak

The qualitative and quantitative composition of volatile organic compounds (VOC) emitted from furnishings from solid wood and all kinds of wood derivative materials depends on many factors, of which the most important is the wood species. The intraspecies and interspecies differences in VOC emission result from the differences in the chemical composition and anatomical structure of heartwood and sapwood of different species. VOC composition analysis was performed separately for heartwood and sapwood of Scots pine (Pinus sylvestris L.), Norway spruce (Picea abies (L.) Karst.) and European larch (Larix decidua Mill.) trees. The studies were conducted in a glass climatic chamber of 0.025 m3, equipped with a system for the monitoring and control of climatic conditions. Samples of air for analyses were collected after 3, 7, 14 and 28 days of exposure. The results provided evidence for interspecies and intraspecies differences in the qualitative and quantitative compositions of VOC. The concentration of total VOC (TVOC) released from heartwood of Scots pine was higher than that released from sapwood. For European larch and Norway spruce, the opposite relations were observed. The VOC emission from Scots pine heartwood was about 17 times higher than the emission from European larch and Norway spruce heartwood. The differences in TVOC emitted from the sapwood of samples from different species were smaller. For each of the species, the highest percentage contribution to TVOC was made by terpenes. The second highest percentage contribution in TVOC was made by compounds containing a carbonyl group, mainly aldehydes, while aromatic compounds made the third highest contribution.


Author(s):  
Ian Alexander ◽  
Roy Watling

SynopsisEighty-four potentially mycorrhizal macrofungi have been recorded with Sitka spruce in Scotland. They derive primarily from the native flora of birch and pine and many are fungi with a wide host range. Specific mycorrhizal associates do not occur. In its native range hypogeous fungi are important but these are largely absent from Scotland. The regularly encountered mycorrhizal flora is less abundant and less diverse than that of Norway spruce or European larch and reflects the importation of Sitka spruce by seed and the ecological conditions to which it gives rise. The saprotrophic macrofungi are species which are widespread and common in a range of vegetation types.


Sign in / Sign up

Export Citation Format

Share Document