scholarly journals Fire-extinguishing performance and mechanism of aqueous film-forming foam in diesel pool fire

2020 ◽  
Vol 17 ◽  
pp. 100578 ◽  
Author(s):  
Zhisheng Xu ◽  
Xing Guo ◽  
Long Yan ◽  
Wendong Kang
Keyword(s):  
Pool Fire ◽  
Fire Extinguishing ◽  
Film Forming ◽  
Performance And Mechanism

scholarly journals Effects of Discharge Area and Atomizing Gas Type in Full Cone Twin-Fluid Atomizer on Extinguishing Performance of Heptane Pool Fire under Two Heat Release Rate Conditions in an Enclosed Chamber

2021 ◽  
Vol 11 (7) ◽  
pp. 3247
Author(s):  
Dong Hwan Kim ◽  
Chi Young Lee ◽  
Chang Bo Oh
Keyword(s):  
Heat Release ◽  
Flow Rate ◽  
Heat Release Rate ◽  
Release Rate ◽  
Water Mist ◽  
Pool Fire ◽  
Sauter Mean Diameter ◽  
Discharge Area ◽  
Fire Extinguishing ◽  
Enclosed Chamber

In this study, the effects of discharge area and atomizing gas type in a twin-fluid atomizer on heptane pool fire-extinguishing performance were investigated under the heat release rate conditions of 1.17 and 5.23 kW in an enclosed chamber. Large and small full cone twin-fluid atomizers were prepared. Nitrogen and air were used as atomizing gases. With respect to the droplet size of water mist, as the water and air flow rates decreased and increased, respectively, the Sauter mean diameter (SMD) of the water mist decreased. The SMD of large and small atomizers were in the range of approximately 12–60 and 12–49 μm, respectively. With respect to the discharge area effect, the small atomizer exhibited a shorter extinguishing time, lower peak surface temperature, and higher minimum oxygen concentration than the large atomizer. Furthermore, it was observed that the effect of the discharge area on fire-extinguishing performance is dominant under certain flow rate conditions. With respect to the atomizing gas type effect, nitrogen and air appeared to exhibit nearly similar extinguishing times, peak surface temperatures, and minimum oxygen concentrations under most flow rate conditions. Based on the present and previous studies, it was revealed that the effect of atomizing gas type on fire-extinguishing performance is dependent on the relative positions of the discharged flow and fire source.

Comparison of fire extinguishing performance of four halon substitutes and Halon 1301

2021 ◽  
pp. 073490412110301
Author(s):  
Yawei Wang ◽  
Gaowan Zou ◽  
Conglin Liu ◽  
Y Gao
Keyword(s):  
Dilution Effect ◽  
Pool Fire ◽  
Design Standards ◽  
Ignition Probability ◽  
Fire Extinguishing ◽  
Halon 1301 ◽  
Efficient Alternative ◽  
Oil Pool ◽  
The Difference ◽  
Effect Of Oxygen

The Halon 1301 fixed gas fire extinguishing system used in ship engine rooms has been banned from production all over the world, because halon destroys the ozone layer. Therefore, it is necessary to find an environmentally friendly, compatible and efficient alternative firefighting system. In this study, we performed fire extinguishing tests in an ISO9705 standard room for four alternative fire extinguishing agents, as well as Halon 1301. The fire extinguishing efficiency of each agent was determined based on its cooling effect, dilution effect of oxygen concentration, the extinguishing time of the oil pool fire and the re-ignition probability of the wood stack. The test results provide data support for the selection of alternatives of Halon 1301 from the aspect of fire extinguishing efficiency. Among these results, Novec 1230 had the best ability to put out the oil pool fire, and HFC-227ea suppressed the wood stack fire the best. The difference between the cooling ability of each fire extinguishing agent was small, and the inert gas (IG-541) displayed the best ability to dilute oxygen. Hot aerosol required the longest time to extinguish fire. Consequently, under the existing design standards, HFC-227ea had the better firefighting efficiency, more suitable to replace Halon 1301.

scholarly journals Study on Flame Retardancy and Mechanism of Talc Composite Foams

2021 ◽  
Vol 8 ◽  
Author(s):  
Xiujuan Li ◽  
Ruisong Guo ◽  
Xiaodong Qian
Keyword(s):  
High Temperature ◽  
Fire Resistance ◽  
Flame Retardancy ◽  
Dense Layer ◽  
Composite Foam ◽  
Fire Extinguishing ◽  
Fuel Burning ◽  
Composite Foams ◽  
Film Forming ◽  
Improved Stability

Under high temperature, aqueous film forming foam extinguishing agent has poor flame retardancy and low fire efficiency. In order to solve this problem, talc was introduced into foam to form composite foam. The fire resistance and fire extinguishing properties of the composite foam were studied. The results showed that talc composite foam had good flame retardant resistance. when the concentration of talc reached 40 g/100 ml, the 50% liquid separation time of the composite foam was 21.1 min. The fuel burning in the anti burning tank did not ignite the gasoline in the oil pan, and burned out at 51.5 min. It was related to the structure of composite foam and the properties of talc. Due to the introduction of talc, the viscosity of the composite foam increased. The network structure of composite foam was important to the improved stability of foam. Talc powder formed a dense layer covering the oil surface, which effectively isolated the oil from the air.

scholarly journals Comprehensive Assimilation of Fire Suppression Modeling and Simulation of Radiant Fire by Water and Its Synergistic Effects with Carbon Dioxide

Energies ◽  
2020 ◽  
Vol 13 (21) ◽  
pp. 5850
Author(s):  
Hassan Raza Shah ◽  
Kun Wang ◽  
Xu Qing Lang ◽  
Jing Wu Wang ◽  
Jing Jun Wang ◽  
...  
Keyword(s):  
Carbon Dioxide ◽  
Synergistic Effects ◽  
Fire Suppression ◽  
Water Mist ◽  
Pool Fire ◽  
Water Suppression ◽  
Water Droplets ◽  
Film Forming ◽  
The Difference ◽  
Suppression Effects

Recently, water has been employed as a supportive agent for the preparation of multiple suppressing agents including aqueous film forming foams (AFFF), which is combined with different kinds of gases for its various applications. In this study, the water mist is chosen for the gas-suppressing agent such as carbon dioxide. Our work investigated the suppression effects of water droplets on the n-heptane pool fire, and its mixture with carbon dioxide, respectively. The size and frequency of droplets with their effect on temperature and suppression was compared to observe the difference in the suppression. Initially, it was found that the droplets having a larger droplet size were found to be more efficient as compared to the smaller droplets with respect to the heat release rate, temperature, and radiation. Afterwards, a mixture of water droplets and carbon dioxide was simultaneously discharged to compare the difference between these two suppressing agents. It was found that the synergistic effect of the mixture has higher advantages over the use of only water suppression. It helps reduce the hot gases that surround the pool fire and allows the water mist to travel efficiently towards the fuel. Both suppression mechanisms were set to similar initial parameters that lead to different outcomes.

A study of the probability distribution of pool fire extinguishing times using water mist

2015 ◽  
Vol 93 ◽  
pp. 240-248 ◽  
Author(s):  
Tianshui Liang ◽  
Mengjie Liu ◽  
Zhonglin Liu ◽  
Wei Zhong ◽  
Xiukun Xiao ◽  
...  
Keyword(s):  
Probability Distribution ◽  
Water Mist ◽  
Pool Fire ◽  
Fire Extinguishing

scholarly journals Preparation and Absorption Carbon Monoxide Properties of a Novel Flame Retardants Based Fire-Fighting Foam

2021 ◽  
Vol 8 ◽  
Author(s):  
Xiujuan Li ◽  
Ruisong Guo ◽  
Xiaodong Qian
Keyword(s):  
Carbon Monoxide ◽  
Flame Retardant ◽  
Magnesium Hydroxide ◽  
Flue Gas ◽  
Flame Retardants ◽  
Water Soluble ◽  
Gas Temperature ◽  
Fire Extinguishing ◽  
Film Forming ◽  
Co Concentration

The toxicity of CO threatens the life of people in the fire site. In this study, flame retardants of nano magnesium hydroxide particles and water-soluble flame retardant 8124 are used to be mixed into the aqueous film forming fire extinguishing agent (AFFF). Smoke-suppressed fire extinguishing agent was prepared in Waring-Blender mixing cup and then stirred at 3,000 r/min for 5 min. The new extinguishing agent shows a good performance of absorption of CO and reducing the flue gas temperature. The concentration of CO was decreased below 131 ppm and flue gas temperature was basically kept below 40°C, which was 367 ppm and 83.1°C less than that in free-fire. Using new extinguishing agent can effectively reduce the harm to the trapped personnel and firemen in the fire site. It was of great significance. The harm of CO concentration below 131 ppm and flue gas temperature below 40°C was low. The time to reach the maximum CO concentration and the maximum flue gas temperature was delayed, which ensures that people have more time to escape. Even if there was not enough time to escape, people will not be seriously threatened.

scholarly journals Ethanol Pool Fire Extinguishing Experiment Using Twin-fluid Nozzle Supplied with Water and Air

2019 ◽  
Vol 33 (3) ◽  
pp. 37-43
Author(s):  
Chan Seok Jeong ◽  
◽  
Chi Young Lee ◽  
Keyword(s):  
Pool Fire ◽  
Fire Extinguishing

Experimental and Numerical Study on the Suppression of Pool Fire with Water Mist

2013 ◽  
Vol 790 ◽  
pp. 686-689
Author(s):  
Chen Jian ◽  
Xu Yan Ying ◽  
Wang Yan Sheng
Keyword(s):  
Systems Engineering ◽  
Numerical Study ◽  
Fire Suppression ◽  
Inhibitory Effect ◽  
Water Mist ◽  
Pool Fire ◽  
Optimized Design ◽  
Operating Pressure ◽  
Fire Extinguishing ◽  
Oil Pool

The objective of this work is to investigate the diesel analog pool fire with water mist .For this purpose, a series of water mist fire suppression experiment are carried out by changing the nozzle operating pressure, the source of fire power, opening and closing the exhaust fan to analyze the inhibitory effect of water mist to oil pool fire in the enclosed compartment of 5.0m × 5.0m × 3.0m. The results shows that extinguishing efficiency first increases and then decreases when the nozzle operating pressure increases from 8MPa to 12MPa, reaching the highest efficiency at 10MPa; increasing the power of the source of fire, the burning speed increases and the water mist fire extinguishing efficiency decreases; fresh oxygen coming in when smoke exhaust fan is turned on and water mist fire suppression efficiency decreases. Using FDS to simulate the water mist extinguishing oil pool fire, the predict temperature field and extinguishing time are basically consistent with the experimental results. In the actual applications of water mist fire suppression systems engineering, we can use the FDS field simulation methods to predict the characteristic parameters variation of the fire fighting fire temperature and component concentration, which is significant to the fire extinguishing system optimized design.

Sign in / Sign up

Export Citation Format

Share Document