scholarly journals The Cellular and Mechanical Basis for Response Characteristics of Identified Primary Afferents in the Rat Vibrissal System

2020 ◽  
Vol 30 (5) ◽  
pp. 815-826.e5 ◽  
Author(s):  
Takahiro Furuta ◽  
Nicholas E. Bush ◽  
Anne En-Tzu Yang ◽  
Satomi Ebara ◽  
Naoyuki Miyazaki ◽  
...  
1996 ◽  
Vol 199 (4) ◽  
pp. 893-899 ◽  
Author(s):  
J Montgomery ◽  
D Bodznick ◽  
M Halstead

Recordings were made from primary afferent fibres and secondary projection neurones (crest cells) in the mechanosensory lateral line system of the dwarf scorpionfish. Crest cells were identified by antidromic stimulation from the contralateral midbrain. Differences between primary afferent fibre and crest cell response characteristics are indicative of signal processing by the neuronal circuitry of the medial octavolateralis nucleus. There are a number of differences between primary afferent fibres and crest cells. Primary afferents have relatively high levels of spontaneous activity (mean close to 40 impulses s-1) and many of them are strongly modulated by ventilation. By contrast, crest cells have a much lower rate of spontaneous activity that is not obviously modulated by ventilation. Primary afferents show a simple tonic response to a maintained stimulus, whereas crest cells show a variety of temporal response properties, but in general show a phasic/tonic response to the same prolonged stimulus. Afferents are most sensitive to frequencies of stimulation around 100 Hz; in contrast, crest cells show a strong suppression of activity at this frequency. Crest cells are most responsive around 50 Hz. These afferent/secondary comparisons show similarities with those reported for allied electrosensory and auditory pathways.


1976 ◽  
Vol 39 (1) ◽  
pp. 1-8 ◽  
Author(s):  
P. D. Cheney ◽  
J. B. Preston

A study was made of the response characteristics of spindle afferents in the baboon soleus muscle. Afferents were isolated from the dorsal roots, their conduction velocities were determined, and their responses were recorded to muscle stretch at rates of 2.5-45 mm/s and amplitudes of 2-10 mm. Spindle afferents could be classified as primary or secondary on the basis of two criteria. The first criterion was conduction velocity. The conduction velocity histogram was bimodal, with peaks at about 45 and 80 m/s and an intermediate region from 55 to 70 m/s. The second criterion was the pattern of adaptation following the peak of ramp stretch. This latter criterion has the advantage of allowing units with intermediate conduction velocities also to be confidently classified as primary or secondary. The velocity and position sensitivities of primate spindle afferents were determined. The mean dynamic index and mean dynamic sensitivity of secondary afferents were about 45% of the corresponding values for primary afferents. On the other hand, the position sensitivities of primary and secondary spindle afferents in the baboon were not significantly different.


2006 ◽  
Vol 18 (7) ◽  
pp. 1611-1636 ◽  
Author(s):  
Miriam Zacksenhouse ◽  
Ehud Ahissar

Rhythmic active touch, such as whisking, evokes a periodic reference spike train along which the timing of a novel stimulus, induced, for example, when thewhiskers hit an external object, can be interpreted. Previous work supports the hypothesis that the whisking-induced spike train entrains a neural implementation of a phase-locked loop (NPLL) in the vibrissal system. Hereweextend thiswork and explorehowthe entrained NPLL decodes the delay of the novel, contact-induced stimulus and facilitates object localization. We consider two implementations of NPLLs, which are based on a single neuron or a neural circuit, respectively, and evaluate the resulting temporal decoding capabilities. Depending on the structure of the NPLL, it can lock in either a phase- or co-phase-sensitive mode, which is sensitive to the timing of the input with respect to the beginning of either the current or the next cycle, respectively. The co-phase-sensitive mode is shown to be unique to circuit-based NPLLs. Concentrating on temporal decoding in the vibrissal system of rats, we conclude that both the nature of the information processing task and the response characteristics suggest that the computation is sensitive to the co-phase. Consequently, we suggest that the underlying thalamocortical loop should implement a circuit-based NPLL.


2000 ◽  
Vol 14 (1) ◽  
pp. 1-10 ◽  
Author(s):  
Joni Kettunen ◽  
Niklas Ravaja ◽  
Liisa Keltikangas-Järvinen

Abstract We examined the use of smoothing to enhance the detection of response coupling from the activity of different response systems. Three different types of moving average smoothers were applied to both simulated interbeat interval (IBI) and electrodermal activity (EDA) time series and to empirical IBI, EDA, and facial electromyography time series. The results indicated that progressive smoothing increased the efficiency of the detection of response coupling but did not increase the probability of Type I error. The power of the smoothing methods depended on the response characteristics. The benefits and use of the smoothing methods to extract information from psychophysiological time series are discussed.


1997 ◽  
Vol 36 (04/05) ◽  
pp. 237-240
Author(s):  
P. Hammer ◽  
D. Litvack ◽  
J. P. Saul

Abstract:A computer model of cardiovascular control has been developed based on the response characteristics of cardiovascular control components derived from experiments in animals and humans. Results from the model were compared to those obtained experimentally in humans, and the similarities and differences were used to identify both the strengths and inadequacies of the concepts used to form the model. Findings were confirmatory of some concepts but contrary to some which are firmly held in the literature, indicating that understanding the complexity of cardiovascular control probably requires a combination of experiments and computer models which integrate multiple systems and allow for determination of sufficiency and necessity.


1998 ◽  
Vol 1998 (183) ◽  
pp. 211-218 ◽  
Author(s):  
Yoshio Iwahashi ◽  
Shigeo Ohmatsu ◽  
Takashi Tsubogo

2020 ◽  
Vol 12 ◽  
Author(s):  
Fang Wang ◽  
Jingkai Wei ◽  
Caixia Guo ◽  
Tao Ma ◽  
Linqing Zhang ◽  
...  

Background: At present, the main problems of Micro-Electro-Mechanical Systems (MEMS) temperature detector focus on the narrow range of temperature detection, difficulty of the high temperature measurement. Besides, MEMS devices have different response characteristics for various surrounding temperature in the petrochemical and metallurgy application fields with high-temperature and harsh conditions. To evaluate the performance stability of the hightemperature MEMS devices, the real-time temperature measurement is necessary. Objective: A schottky temperature detector based on the metal/n-ZnO/n-Si structures is designed to measure high temperature (523~873K) for the high-temperature MEMS devices with large temperature range. Method: By using the finite element method (FEM), three different work function metals (Cu, Ni and Pt) contact with the n-ZnO are investigated to realize Schottky. At room temperature (298K) and high temperature (523~873K), the current densities with various bias voltages (J-V) are studied. Results: The simulation results show that the high temperature response power consumption of three schottky detectors of Cu, Ni and Pt decreases successively, which are 1.16 mW, 63.63 μW and 0.14 μW. The response temperature sensitivities of 6.35 μA/K, 0.78 μA/K, and 2.29 nA/K are achieved. Conclusion: The Cu/n-ZnO/n-Si schottky structure could be used as a high temperature detector (523~873K) for the hightemperature MEMS devices. It has a large temperature range (350K) and a high response sensitivity is 6.35 μA/K. Compared with traditional devices, the Cu/n-ZnO/n-Si Schottky structure based temperature detector has a low energy consumption of 1.16 mW, which has potential applications in the high-temperature measurement of the MEMS devices.


Sign in / Sign up

Export Citation Format

Share Document