LiNi0.5Mn1.5O4-δ (LNMO) as Co-free cathode for lithium ion batteries via solution-gel synthesis: particle size and morphology investigation

2021 ◽  
pp. 162175
Author(s):  
Fulya ULU OKUDUR ◽  
Satish Kumar MYLAVARAPU ◽  
Mohammadhosein SAFARI ◽  
Dries DE SLOOVERE ◽  
Jan D’HAEN ◽  
...  
RSC Advances ◽  
2015 ◽  
Vol 5 (18) ◽  
pp. 13331-13340 ◽  
Author(s):  
T. N. Ng ◽  
X. Q. Chen ◽  
K. L. Yeung

Flow-synthesis of mesoporous silica allows deliberate and precise control over the size and shapes and enables the preparation of complex microstructures (i.e., hollow spheres).


2021 ◽  
Vol 11 (14) ◽  
pp. 6578
Author(s):  
Aleksandra Jedlińska ◽  
Alicja Barańska ◽  
Dorota Witrowa-Rajchert ◽  
Ewa Ostrowska-Ligęza ◽  
Katarzyna Samborska

This paper discusses the physicochemical properties of powders obtained by spray drying of cloudy beetroot juice, using dehumidified air in variants with or without carriers. The inlet air temperature was 130 °C or 90 °C, and the addition of the carriers was at a ratio of juice to carrier solids of 3:2. In the obtained powders, the following physicochemical properties were determined: water content and water activity, apparent density, loose and tapped density, porosity, flowability, particle size and morphology, and the content and retention of betalains. It was possible to dry cloudy beetroot juice without the use of carriers at low temperatures (90 or 130 °C). The 100% beetroot powders were characterized by satisfactory physicochemical properties, often better than those with carriers (including lower hygroscopicity and higher color saturation and yield). A lower loss of betalains was found for the powders with the addition of carriers. The best process yields were obtained for the powder without carriers at 130 °C and 90 °C.


2007 ◽  
Vol 336-338 ◽  
pp. 140-142
Author(s):  
Jun Jie Hao ◽  
Xiao Hui Wang ◽  
Shi Yun Lin ◽  
Long Tu Li

Na0.5Bi0.5TiO3 (NBT) is considered to be an excellent candidate for lead-free piezoelectric ceramics. In this study, we propose a hydrothermal method for the preparation of single phase NBT powder at relatively low treatment-temperature. The particle size and morphology of the synthesized powders were examined by SEM. The powders were further pressed into disk and sintered at 1120°C/2h in air, and its properties and microstructure were compared with traditionally prepared samples.


2020 ◽  
Vol 44 (20) ◽  
pp. 8486-8493 ◽  
Author(s):  
Zhongyue Zi ◽  
Yantao Zhang ◽  
Yangqian Meng ◽  
Ge Gao ◽  
Peiyu Hou

The wide particle size distribution of LLO microspheres assembled from {010} exposed primary grains is proposed to improve their Li+ kinetics and tap-density.


2014 ◽  
Vol 2 (37) ◽  
pp. 15437-15447 ◽  
Author(s):  
Aziz Abdellahi ◽  
Oncu Akyildiz ◽  
Rahul Malik ◽  
Katsuyo Thornton ◽  
Gerbrand Ceder

Using calculations based on first principles, we demonstrate that the preferred interface in singles LiFePO4 particles depends both on the particle size and morphology.


2014 ◽  
Vol 153 ◽  
pp. 130-135 ◽  
Author(s):  
V.M. Lisitsyn ◽  
D.T. Valiev ◽  
I.A. Tupitsyna ◽  
E.F. Polisadova ◽  
V.I. Oleshko ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document