Removal of ammonia nitrogen and phosphorus by biochar prepared from sludge residue after rusty scrap iron and reduced iron powder enhanced fermentation

2021 ◽  
Vol 282 ◽  
pp. 111970
Author(s):  
Lu Zhang ◽  
Feng Deng ◽  
Zhongkai Liu ◽  
Lexian Ai
Keyword(s):  
Iron Powder ◽  
Ammonia Nitrogen ◽  
Nitrogen And Phosphorus ◽  
Reduced Iron Powder ◽  
Scrap Iron

Mechanism Analysis and Experimental Research on the Interception of Nitrogen and Phosphorus Pollutants by Gullies in Northern China

2011 ◽  
Vol 250-253 ◽  
pp. 3392-3396
Author(s):  
Yu Jia Song ◽  
Hui Qing Liu
Keyword(s):  
Total Phosphorus ◽  
Nitrate Nitrogen ◽  
Northern China ◽  
Careful Analysis ◽  
Ammonia Nitrogen ◽  
Mechanism Analysis ◽  
Nitrogen And Phosphorus ◽  
Urban Sewage ◽  
Control Section ◽  
Nitrogen Pollutants

The discharge of urban sewage and agricultural non-point source pollutants is the main reason causing eutrophication in gullies in most cities of northern China. Based on a careful analysis on the ecological structure and ecological characteristics of a gully, this article preliminarily studies the interception and degradation mechanisms of nitrogen pollutants by the gully. Meanwhile, to take gullies in Changchun as the object of the study, this article carries out an experiment on the interception effect of nitrogen pollutants by gullies. This experiment respectively establishes a control section in the upper and lower reaches of a gully, and takes water samples four times in each section from May to August to determine total nitrogen, total phosphorus, nitrate nitrogen, ammonia nitrogen and salinity. The result shows: the gully plays some role in the interception of pollutants; total phosphorus accounts for the largest interception in pollutants in the experimented gully section, with the relative interception rate of 27.46%, followed by ammonia nitrogen, with the interception rate of 21.80%, which is the result of the combined effects of aquatic plants, microorganisms and sediment in the gully.

scholarly journals Graphene-Modulated Removal Performance of Nitrogen and Phosphorus Pollutants in a Sequencing Batch Chlorella Reactor

Materials ◽  
2018 ◽  
Vol 11 (11) ◽  
pp. 2181 ◽  
Author(s):  
Gonghan Xia ◽  
Wenlai Xu ◽  
Qinglin Fang ◽  
Zishen Mou ◽  
Zhicheng Pan
Keyword(s):  
Optical Microscopy ◽  
Sewage Treatment ◽  
Ammonia Nitrogen ◽  
Pollutant Removal ◽  
Plate Count ◽  
Nitrogen And Phosphorus ◽  
Removal Rates ◽  
Practical Support ◽  
Plate Count Method ◽  
The Impact

In this work, the influence of graphene on nitrogen and phosphorus in a batch Chlorella reactor was studied. The impact of graphene on the removal performance of Chlorella was investigated in a home-built sewage treatment system with seven identical sequencing batch Chlorella reactors with graphene contents of 0 mg/L (T1), 0.05 mg/L (T2), 0.1 mg/L (T3), 0.2 mg/L (T4), 0.4 mg/L (T5), 0.8 mg/L (T6) and 10 mg/L (T7). The influence of graphene concentration and reaction time on the pollutant removal performance was studied. The malondialdehyde (MDA) and total superoxide dismutase (SOD) concentrations in each reactor were measured, and optical microscopy and scanning electron microscopy (SEM) characterizations were performed to determine the related mechanism. The results show that after 168 h, the total nitrogen (TN), ammonia nitrogen (AN) and total phosphorus (TP) removal rates of reactors T1–T7 become stable, and the TN, AN and TP removal rates were gradually reduced with increasing graphene concentration. At 96 h, the concentrations of both MDA and SOD in T1–T7 gradually increased as the graphene concentration increased. In optical microscopy and SEM measurements, it was found that graphene was adsorbed on the surface of Chlorella, and entered Chlorella cells, deforming and reducing Chlorella. Through the blood plate count method, we estimated an average Chlorella reduction of 16%. According to the water quality and microscopic experiments, it can be concluded that the addition of graphene causes oxidative damage to microalgae and destruction of the Chlorella cell wall and cell membrane, inhibiting the nitrogen and phosphorus removal in Chlorella reactors. This study provides theoretical and practical support for the safe use of graphene.

Experimental Studies on Enhanced Coagulation of Tail Water

2013 ◽  
Vol 295-298 ◽  
pp. 1478-1481
Author(s):  
Feng Xun Tan ◽  
Jiu Mei Wang ◽  
Dao Ji Wu
Keyword(s):  
Ferric Chloride ◽  
Removal Rate ◽  
Reclaimed Water ◽  
Experimental Studies ◽  
Ammonia Nitrogen ◽  
Raw Water ◽  
Nitrogen And Phosphorus ◽  
Enhanced Coagulation ◽  
Tail Water ◽  
Water Eutrophication

Traditional wastewater treatment methods can no longer remove effectively nitrogen and phosphorus that are the direct murderers of water eutrophication hazard. Enhanced coagulation method was adopted to improve the treatment effect by dosing suitable coagulants and coagulant aids. The raw water was from the reclaimed water in a University. TP and ammonia nitrogen removal of the water had been researched through an enhanced coagulation process with dosing ferric chloride, aluminum sulfate, polymeric ferric chloride, and poly-aluminum chloride (PAC) in this study. The coagulants effects were estimated by determining the removal rate of ammonia nitrogen, TP, COD and turbidity. When dosing the raw water with 80 mg/L PAC, the removal rates of ammonia nitrogen, TP, COD and turbidity are respectively 6.12%, 67.79%, 26.21%, 85.41%. The experimental results can be used as a reference of water treatment in the reclaimed water station.

A study of NH3-N and P refixation by struvite formation in hybrid anaerobic reactor

2004 ◽  
Vol 49 (5-6) ◽  
pp. 207-214 ◽  
Author(s):  
J.J. Lee ◽  
C.U. Choi ◽  
M.J. Lee ◽  
I.H. Chung ◽  
D.S. Kim
Keyword(s):  
Removal Efficiency ◽  
Ammonia Nitrogen ◽  
Magnesium Ions ◽  
Nitrogen And Phosphorus ◽  
X Ray ◽  
Naked Eye ◽  
N Removal ◽  
Magnesium Salts ◽  
Main Components ◽  
P Removal

This research is concerned with the removal of ammonia nitrogen and phosphorus in foodwaste by crystallization. Reductions have been achieved by struvite formation after the addition of magnesium ions (Mg2+). Magnesium ions used in this study were from magnesium salts of MgCl2. The results of our analysis using scanning electron microscopy and energy dispersive X-ray analysis showed that the amount of struvite in precipitated sludge grew enough to be seen with the naked eye (600-700μm). EDX analysis also showed that the main components of the struvite were magnesium and phosphorus. NH3-N removal efficiency using MgCl2 was 67% while PO4-P removal efficiency was 73%. It was confirmed that nitrogen and phosphorus could be stabilized and removal simultaneously through anaerobic digestion by Mg, NH3 and PO4-P, which were necessary for struvite formation.

scholarly journals Optimization of Polyaluminum Chloride-Chitosan Flocculant for Treating Pig Biogas Slurry Using the Box–Behnken Response Surface Method

2019 ◽  
Vol 16 (6) ◽  
pp. 996 ◽  
Author(s):  
Yu Li ◽  
Leigang Li ◽  
Reham Yasser Farouk ◽  
Yuanyuan Wang
Keyword(s):  
Response Surface ◽  
Response Surface Method ◽  
Removal Rate ◽  
Organic Fertilizer ◽  
Ammonia Nitrogen ◽  
Biogas Slurry ◽  
Nitrogen And Phosphorus ◽  
Polyaluminum Chloride ◽  
Surface Method ◽  
Total Ammonia

Flocculation can remove large amounts of nitrogen and phosphorus from wastewater, and the resulting nitrogen- and phosphorus-rich floc can be used to produce organic fertilizer. For biogas slurries containing high levels of nitrogen and phosphorus, ordinary flocculants can no longer meet the flocculation requirements. In this study, to fully utilize the advantages of the two flocculants and achieve efficient removal rates of nitrogen and phosphorus from a biogas slurry, chitosan (CTS) and polyaluminum chloride (PAC) were used as a composite flocculation agent to flocculate pig biogas slurries. The response surface method was used to study the effect of PAC added (PACadded) to the composite flocculant (CF), composite flocculant added (CFadded) to the biogas slurry and the pH on flocculation performance, and optimize these three parameters. In the tests, when the PACadded was 6.79 g·100 mL−1CF, the CFadded was 20.05 mL·L−1 biogas slurry and the pH was 7.50, the flocculation performance was the best, with an absorbance of 0.132 at a wavelength of 420 nm. The total phosphorus (TP) concentration was reduced from 214.10 mg·L−1 to 1.38 mg·L−1 for a removal rate of 99.4%. The total ammonia nitrogen (TAN) concentration was reduced from 1568.25 mg·L−1 to 150.27 mg·L−1 for a removal rate of 90.4%. The results showed that the CF could form larger flocs, and had greater adsorption capacity and more stable flocculation performance than ordinary flocculants. Furthermore, the CF could exhibit better chelation, electrical neutralization and bridge adsorption.

The ecological filter system for treatment of decentralized wastewater

2016 ◽  
Vol 74 (7) ◽  
pp. 1553-1560
Author(s):  
Kun Zhong ◽  
Yi-yong Luo ◽  
Zheng-song Wu ◽  
Qiang He ◽  
Xue-bin Hu ◽  
...  
Keyword(s):  
Removal Efficiency ◽  
Organic Pollutants ◽  
Oxygen Demand ◽  
Ammonia Nitrogen ◽  
Nitrogen And Phosphorus ◽  
Treatment Technology ◽  
Removal Rates ◽  
Carbon Nitrogen Ratio ◽  
Ecological Filter ◽  
Aerated Filter

A vertical flow constructed wetland was combined with a biological aerated filter to develop an ecological filter, and to obtain the optimal operating parameters: The hydraulic loading was 1.55 m3/(m2·d), carbon–nitrogen ratio was 10, and gas–water ratio was 6. The experimental results demonstrated considerable removal efficiency of chemical oxygen demand (COD), ammonia nitrogen (NH4+-N), total nitrogen (TN), and total phosphorus (TP) in wastewater by the ecological filter, with average removal rates of 83.79%, 93.10%, 52.90%, and 79.07%, respectively. Concentration of NH4+-N after treatment met the level-A discharge standard of GB18918-2002. Compared with non-plant filter, the ecological filter improved average removal efficiency of COD, NH4+-N, TN, and TP by 13.03%, 25.30%, 14.80%, and 2.32%, respectively: thus, plants significantly contribute to the removal of organic pollutants and nitrogen. Through microporous aeration and O2 secretion of plants, the ecological filter formed an aerobic–anaerobic–aerobic alternating environment; thus aerobic and anaerobic microbes were active and effectively removed organic pollutants. Meanwhile, nitrogen and phosphorus were directly assimilated by plants and as nutrients of microorganisms. Meanwhile, pollutants were removed through nitrification, denitrification, filtration, adsorption, and interception by the filler. High removal rates of pollutants on the ecological filter proved that it is an effective wastewater-treatment technology for decentralized wastewater of mountainous towns.

Copper Coated Iron Powder Prepared by Chemical Reduction Process

2011 ◽  
Vol 275 ◽  
pp. 161-164
Author(s):  
Xiao Yun Zhu ◽  
Zhong Cheng Guo
Keyword(s):  
Iron Powder ◽  
Chemical Reduction ◽  
Reduction Process ◽  
Raw Material ◽  
Solution Temperature ◽  
X Ray Diffraction ◽  
Powder Surface ◽  
X Ray ◽  
Reduced Iron Powder ◽  
Plating Solution

Using reduced iron powder as raw material, Copper coated iron powder(CCIP) is prepared by electroless alkaline-based plating. We discuss the impacts of reductant concentration, plating solution temperature and main salt concentration on the properties of CCIP. Surface morphology and composition are studied by using scanning electron microscopy and X-ray diffraction. The results show that after coating, the iron powder surface is rougher and the copper layer is uniform in its simple metallic form without any oxide states.

Sign in / Sign up

Export Citation Format

Share Document