Variability in growth and cadmium accumulation capacity among willow hybrids and their parents: implications for yield-based selection of Cd-efficient cultivars

2021 ◽  
Vol 299 ◽  
pp. 113643
Author(s):  
Shufeng Wang ◽  
Timothy A. Volk ◽  
Jin Xu
2004 ◽  
Vol 85 (1) ◽  
pp. 147-153 ◽  
Author(s):  
Jianguo Liu ◽  
Qingsen Zhu ◽  
Zujian Zhang ◽  
Jiakuan Xu ◽  
Jianchang Yang ◽  
...  

Soil Research ◽  
2002 ◽  
Vol 40 (8) ◽  
pp. 1331 ◽  
Author(s):  
Thierry Granel ◽  
Brett Robinson ◽  
Tessa Mills ◽  
Brent Clothier ◽  
Steve Green ◽  
...  

Elevated levels of cadmium are often found in the soil of New Zealand pasturelands due to the long-term use of Cd-contaminated fertilisers. The accumulation of Cd in willow biomass used as stock fodder could therefore adversely affect agricultural productivity and human health. Alternatively, willows may be used for phytoremediation of Cd-contaminated soil at polluted sites. An investigation was carried out to determine the variation in Cd as well as Zn, Mn, and Fe accumulation in 15 willow clones that had been bred for soil conservation purposes. These clones were grown under controlled conditions in 20-L pots of soil containing Cd, Zn, Mn, and Fe at concentrations of 0.3, 64, 597, and 56 000 mg/kg, respectively. Daily water use was measured over the final 2 weeks of the experiment and biomass accumulation was determined at the end of the experiment. We found that shrub willows had significantly higher leaf and stem Cd, Mn, and Zn concentrations than tree willows. Average leaf Cd concentrations varied widely between clones from 1.5 to 10 mg/kg. Clones with a high Cd accumulation capacity may be selected to improve the efficacy of Cd-phytoremediation, whereas clones that accumulated lower Cd concentrations may be used for stock fodder. Metal concentrations were not significantly correlated with plant water-use, or biomass production.


2021 ◽  
Vol 13 (12) ◽  
pp. 6555
Author(s):  
Jesús D. Peco ◽  
Pablo Higueras ◽  
Juan A. Campos ◽  
José M. Esbrí ◽  
Marta M. Moreno ◽  
...  

Abandoned mine lands (AMLs), which are considered some of the most dangerous anthropogenic activities in the world, are a source of hazards relating to potentially toxic elements (PTEs). Traditional reclamation techniques, which are expensive, time-consuming and not well accepted by the general public, cannot be used on a large scale. However, plant-based techniques have gained acceptance as an environmentally friendly alternative over the last 20 years. Plants can be used in AMLs for PTE phytoextraction, phytostabilization, and phytovolatilization. We reviewed these phytoremediation techniques, paying particular attention to the selection of appropriate plants in each case. In order to assess the suitability of plants for phytoremediation purposes, the accumulation capacity and tolerance mechanisms of PTEs was described. We also compiled a collection of interesting actual examples of AML phytoremediation. On-site studies have shown positive results in terms of soil quality improvement, reduced PTE bioavailability, and increased biodiversity. However, phytoremediation strategies need to better characterize potential plant candidates in order to improve PTE extraction and to reduce the negative impact on AMLs.


PeerJ ◽  
2019 ◽  
Vol 7 ◽  
pp. e7877 ◽  
Author(s):  
Yanhua Cao ◽  
Xiongwei Zhao ◽  
Yajuan Liu ◽  
Yalong Wang ◽  
Wenmei Wu ◽  
...  

P1B-type ATPases, known as heavy metal ATPases (HMAs), play an important role in the control of cadmium (Cd) accumulation in plants. In this study, a total of 12 ZmHMA genes were identified in the maize genome and particularly classified into six clusters based on their phylogenetic relationship and motif compositions. Furthermore, the expression patterns of different ZmHMA genes varied with developmental stages, and were tissue specific under normal conditions. ZmHMA2 and ZmHMA3 genes exhibited significant up-regulation under Cd treatment. Eventually, the association analysis between 103 inbred lines and alleles in ZmHMA2 and ZmHMA3 revealed that one insertion–deletion (InDel) in the intron from ZmHMA2 was associated with leaf Cd concentration under low Cd condition at the seedling stage. Twenty polymorphisms in ZmHMA3 were significantly associated with leaf Cd concentration under various Cd levels at seedling and maturing stages. Five single nucleotide polymorphisms (SNPs) and two InDels of these significantly associated polymorphic loci from ZmHMA3 caused the amino acid substitutions and insertion or deletion events. Importantly, the proteins encoded by ZmHMA2 and ZmHMA3 genes were located in the plasma membrane. This comprehensive analysis will provide an important theoretical basis for future functional verification of ZmHMA genes to unravel the mechanisms of Cd accumulation in leaves of maize. Additionally, the favorable alleles in ZmHMA3 will lay a foundation for the marker-assisted selection of low Cd accumulation in maize.


2019 ◽  
Vol 42 ◽  
Author(s):  
Gian Domenico Iannetti ◽  
Giorgio Vallortigara

Abstract Some of the foundations of Heyes’ radical reasoning seem to be based on a fractional selection of available evidence. Using an ethological perspective, we argue against Heyes’ rapid dismissal of innate cognitive instincts. Heyes’ use of fMRI studies of literacy to claim that culture assembles pieces of mental technology seems an example of incorrect reverse inferences and overlap theories pervasive in cognitive neuroscience.


1975 ◽  
Vol 26 ◽  
pp. 395-407
Author(s):  
S. Henriksen

The first question to be answered, in seeking coordinate systems for geodynamics, is: what is geodynamics? The answer is, of course, that geodynamics is that part of geophysics which is concerned with movements of the Earth, as opposed to geostatics which is the physics of the stationary Earth. But as far as we know, there is no stationary Earth – epur sic monere. So geodynamics is actually coextensive with geophysics, and coordinate systems suitable for the one should be suitable for the other. At the present time, there are not many coordinate systems, if any, that can be identified with a static Earth. Certainly the only coordinate of aeronomic (atmospheric) interest is the height, and this is usually either as geodynamic height or as pressure. In oceanology, the most important coordinate is depth, and this, like heights in the atmosphere, is expressed as metric depth from mean sea level, as geodynamic depth, or as pressure. Only for the earth do we find “static” systems in use, ana even here there is real question as to whether the systems are dynamic or static. So it would seem that our answer to the question, of what kind, of coordinate systems are we seeking, must be that we are looking for the same systems as are used in geophysics, and these systems are dynamic in nature already – that is, their definition involvestime.


1978 ◽  
Vol 48 ◽  
pp. 515-521
Author(s):  
W. Nicholson

SummaryA routine has been developed for the processing of the 5820 plates of the survey. The plates are measured on the automatic measuring machine, GALAXY, and the measures are subsequently processed by computer, to edit and then refer them to the SAO catalogue. A start has been made on measuring the plates, but the final selection of stars to be made is still a matter for discussion.


Author(s):  
P.J. Killingworth ◽  
M. Warren

Ultimate resolution in the scanning electron microscope is determined not only by the diameter of the incident electron beam, but by interaction of that beam with the specimen material. Generally, while minimum beam diameter diminishes with increasing voltage, due to the reduced effect of aberration component and magnetic interference, the excited volume within the sample increases with electron energy. Thus, for any given material and imaging signal, there is an optimum volt age to achieve best resolution.In the case of organic materials, which are in general of low density and electric ally non-conducting; and may in addition be susceptible to radiation and heat damage, the selection of correct operating parameters is extremely critical and is achiev ed by interative adjustment.


Author(s):  
P. M. Lowrie ◽  
W. S. Tyler

The importance of examining stained 1 to 2μ plastic sections by light microscopy has long been recognized, both for increased definition of many histologic features and for selection of specimen samples to be used in ultrastructural studies. Selection of specimens with specific orien ation relative to anatomical structures becomes of critical importance in ultrastructural investigations of organs such as the lung. The uantity of blocks necessary to locate special areas of interest by random sampling is large, however, and the method is lacking in precision. Several methods have been described for selection of specific areas for electron microscopy using light microscopic evaluation of paraffin, epoxy-infiltrated, or epoxy-embedded large blocks from which thick sections were cut. Selected areas from these thick sections were subsequently removed and re-embedded or attached to blank precasted blocks and resectioned for transmission electron microscopy (TEM).


Sign in / Sign up

Export Citation Format

Share Document