Surface microstructure preparation offers a promising approach for overcoming the shortcomings of Al alloy, such as poor friction resistance, low hardness and weak corrosion resistance to corrosive liquid. Though many methods for the surface microstructure preparation of Al alloy have been developed, it is difficult for most of the reported methods to regulate the as-prepared microstructure, meaning that the properties of Al alloy cannot be improved efficiently by the microstructure. Thus, the application of microstructure surface of Al alloy and microstructure preparation technology is severely limited. Aimed at this issue, a simple, convenient, high-efficient, low-cost micro-scale roughness structure construction approach that is suitable for engineering application (laser micro-engraving) was developed. The as-prepared microstructure on Al alloy surface formed by laser micro-engraving was investigated systemically. The morphology and formation mechanism of the microstructure were examined. Meanwhile, the effect of laser parameters on morphology, geometrical dimensions and composition of microstructure was investigated. The results indicate that the morphology of microstructure is affected by the overlap degree of molten pool greatly. When each molten pool does not overlap with others, successive individual pits can be constructed. When each molten pool overlaps with others for one time, successive overlapping pits will form. As the overlap degree of the molten pool further increases (overlapping with others for more than one time), the successive pits can become grooved. Because of the influence of laser beam pulse frequency and scanning speed on the diameter and distance of the molten pools, the morphology and geometrical dimensions of microstructure can vary greatly with laser parameters. As the laser beam scanning speed increases, the geometrical dimensions of as-prepared microstructure reduce significantly. In contrast, with the increase of laser beam pulse frequency, the geometrical dimensions change in a complicated manner. However, the chemical composition of microstructure is slightly affected by laser parameters. More importantly, a relationship model was successfully established, which could be used to predict and regulate the geometrical dimensions of microstructure treated by laser micro-engraving. Controllable preparation of microstructure on Al alloy is realized, leading that specific microstructure can be prepared rapidly and accurately instead of suffering from long-time experimental investigation in the future.
Reducing defects on multi-walled carbon nanotube surfaces induced by low-power ultrasonic-assisted hydrochloric acid treatment
