Standby switch can strongly turn off all the high threshold voltage transistors, which enhances the effectiveness of a dual threshold voltage CMOS technology to reduce sub-threshold leakage current. Sub-threshold leakage currents are especially important in burst mode type integrated circuits where the system is in an idle mode in the majority of the time. The standby switch allows a domino system to enter and leave a low leakage standby mode within a single clock cycle. In addition, we combine domino dynamic logic with pass transistor XNOR and pass transistor NAND gates to achieve logic 1 output during its precharge phase without affecting circuits operation in its evaluation and standby phase. The required process for dual threshold voltage circuit configuration involves only one additional ion implant step to provide an extra threshold voltage. SPICE simulation for our proposed circuits is made using a 0.18 μm CMOS processes from TSMC, with 10 fF capacitive loads in all output nodes, and parameters for typical process corner at 25°C. Layout is designed, wafer is fabricate and measured. The measurement results of fabricated chips are listed and verify that our designed 8-bit carry look-ahead adders (CLAs) reduced power consumption and propagation delay time by more than 15% and around 20%, respectively, when compared with the prior work.
Sleep switch dual threshold Voltage domino logic with reduced standby leakage current
