Numerical study of the mooring system failure of aquaculture net cages under irregular waves and current

2020 ◽  
Vol 216 ◽  
pp. 108110
Author(s):  
Hung-Jie Tang ◽  
Po-Hung Yeh ◽  
Chai-Cheng Huang ◽  
Ray-Yeng Yang
Keyword(s):  
Numerical Study ◽  
Irregular Waves ◽  
Mooring System ◽  
System Failure ◽  
Net Cages

Numerical Study on Hydrodynamic Responses of a Two-Body System in Side-by-Side Operation

2016 ◽  
Author(s):  
Shaowu Ou ◽  
Shixiao Fu ◽  
Wei Wei ◽  
Tao Peng ◽  
Xuefeng Wang
Keyword(s):  
Numerical Study ◽  
Low Frequency ◽  
Optimal Operation ◽  
Hydrodynamic Interactions ◽  
Irregular Waves ◽  
Mooring System ◽  
Time Varying ◽  
Body System ◽  
The Time Domain ◽  
Two Bodies

Typically, in some side-by-side offshore operations, the speed of vessels is very low or even 0 and the headings are manually maneuvered. In this paper, the hydrodynamic responses of a two-body system in such operations under irregular seas are investigated. The numerical model includes two identical PSVs (Platform Supply Vessel) as well as the fenders and connection lines between them. A horizontal mooring system constraining the low frequency motions is set on one of the ships to simulate maneuver system. Accounting for the hydrodynamic interactions between two bodies, 3D potential theory is applied for the analysis of their hydrodynamic coefficients. With wind and current effects included, these coefficients are further applied in the time domain simulations in irregular waves. The relevant coefficients are estimated by experiential formulas. Time-varying loads on fenders and connection lines are analyzed. Meanwhile, the relative motions as well as the effects of the hydrodynamic interactions between ships are further discussed, and finally an optimal operation scheme in which operation can be safely performed is summarized.

scholarly journals Proposal and Performance Study of a Novel Mooring System with Six Mooring Lines for Spar-Type Offshore Wind Turbines

2021 ◽  
Vol 11 (24) ◽  
pp. 11665
Author(s):  
Shi Liu ◽  
Yi Yang ◽  
Chao Wang ◽  
Yuangang Tu
Keyword(s):  
Wind Turbine ◽  
Wind Turbines ◽  
Offshore Wind ◽  
Irregular Waves ◽  
Offshore Wind Turbine ◽  
Mooring System ◽  
Mooring Lines ◽  
Included Angle ◽  
Offshore Wind Turbines ◽  
Floating Offshore Wind Turbines

Spar-type floating offshore wind turbines commonly vibrate excessively when under the coupling impact of wind and wave. The wind turbine vibration can be controlled by developing its mooring system. Thus, this study proposes a novel mooring system for the spar-type floating offshore wind turbine. The proposed mooring system has six mooring lines, which are divided into three groups, with two mooring lines in the same group being connected to the same fairlead. Subsequently, the effects of the included angle between the two mooring lines on the mooring-system’s performance are investigated. Then, these six mooring lines are connected to six independent fairleads for comparison. FAST is utilized to calculate wind turbine dynamic response. Wind turbine surge, pitch, and yaw movements are presented and analyzed in time and frequency domains to quantitatively evaluate the performances of the proposed mooring systems. Compared with the mooring system with six fairleads, the mooring system with three fairleads performed better. When the included angle was 40°, surge, pitch, and yaw movement amplitudes of the wind turbine reduced by 39.51%, 6.8%, and 12.34%, respectively, when under regular waves; they reduced by 56.08%, 25.00%, and 47.5%, respectively, when under irregular waves. Thus, the mooring system with three fairleads and 40° included angle is recommended.

Coupled Dynamic Analyses of Deep-Water Semi-Submersible With New Spread Mooring System

2020 ◽  
Author(s):  
S. Chandrasekaran ◽  
Arvind Kumar Jain ◽  
Syed Azeem Uddin
Keyword(s):  
Fatigue Life ◽  
Deep Water ◽  
Production Systems ◽  
Irregular Waves ◽  
Mooring System ◽  
Mooring Lines ◽  
Dynamic Positioning System ◽  
Exploration And Production ◽  
Ocean Environment ◽  
Offshore Oil

Abstract Offshore complaint structures dominate the deepwater oil exploration and production due to their adaptive geometric form and well-established construction practices. Semi-submersible is one of the widely preferred, floating production systems due to its form-dominant ability, better stability characteristics, and best constructional features. It is usually position-restrained using a dynamic-positioning system (active-restraining) or mooring system (passive-restraining); being less-sensitive to freak ocean environment is an added advantage. The Semi-submersible, chosen for the present study is based on a similar configuration of a 6th generation deep-water Hai Yang Shi You (HYSY) – 981 platforms, commissioned by the China National Offshore Oil Corporation (CNOOC) in 2012. A sixteen-point, spread catenary-mooring without submerged buoy (case-1) in the form of chain-wire-chain type configuration is used for position-restraining. Response behavior of the semi-submersible with a conventional spread catenary-mooring system with a submerged buoy (case-2) is compared. API spectrum is used for computing wind loads, while the JONSWAP spectrum is used to represent irregular waves for various directions of wave heading. The effect of non-linearly varying current is considered up to 10% of water depth. Numerical analyses of the semi-submersible are carried out under 10-years, and 100-years return period events using Ansys Aqwa. Under wind, wave, and current loads, motion responses of the Semi-submersible at 1500 m and 2000 m water depths are investigated for both the cases in time-domain. Dynamic mooring tension variations arise from the environmental loads are further investigated for a fatigue failure using the S-N curve approach. It is found that the fatigue life of the mooring lines after the inclusion of the buoy is enhanced. It was also observed that, during failure of mooring lines there is an increase in tension of the mooring lines which are adjacent to the failed mooring lines and this is due to the transfer of mooring load and hence reducing their fatigue life.

Experimental and Numerical Study on Dynamic Response of FSRU-LNGC Side-by-Side Mooring System

2019 ◽  
Author(s):  
Jingxia Yue ◽  
Weili Kang ◽  
Wengang Mao ◽  
Pengfei Chen ◽  
Xi Wang
Keyword(s):  
Numerical Analysis ◽  
Dynamic Response ◽  
Numerical Study ◽  
Clean Energy ◽  
Coupled Analysis ◽  
Response Analysis ◽  
Mooring System ◽  
Test Results ◽  
Floating Bodies ◽  
Damping Parameter

Abstract Floating Storage and Regasification Unit (FSRU) becomes one of the most popular equipment in the industry for providing clean energy due to its technical, economic and environmental features. Under the combined loads from wind, wave and current, it is difficult for the prediction of the dynamic response for such FSRU-LNGC (Liquified Natural Gas Carrier) side-by-side mooring system, because of the complicated hydrodynamic interaction between the two floating bodies. In this paper, a non-dimensional damping parameter of the two floating bodies is obtained from a scaled model test. Then the numerical analysis is carried out based on the test results, and the damping lid method is applied to simulate the hydrodynamic interference between floating bodies. The dynamic response of the side-by-side mooring system including six degrees of freedom motion, cable tension and fender force are provided and analyzed. According to the comparisons between numerical results and the test results, it is shown that the proposed coupled analysis model is reliable, and the numerical analysis can properly describe the dynamic response of the multi-floating mooring system in the marine environment. Moreover, the non-dimensional damping parameter which is used in numerical analysis can act as a good reference to the dynamic response analysis of similar multi-floating mooring systems.

Experimental Investigation on a Point Absorber Moored by Taut Mooring System and Mooring Fatigue Analysis

2020 ◽  
Author(s):  
Sheng Xu ◽  
C. Guedes Soares
Keyword(s):  
Fatigue Damage ◽  
Spectral Methods ◽  
Irregular Waves ◽  
Mooring System ◽  
Wire Ropes ◽  
Irregular Wave ◽  
Point Absorber ◽  
Motion Responses ◽  
Linear Spring ◽  
Rainflow Counting

Abstract In this paper, a taut wire mooring system has been designed consisting of three wire ropes symmetrically arranged. The power take-off system is modelled by a linear spring and a heave plate to simulate the linear damping of the power take-off. A series of regular wave tests in head seas are performed to study the dynamics of the system. Irregular wave tests were then conducted to simulate the system performance in the operational sea states, where the irregular waves are modelled by the Jonswap spectrum. The WEC motion responses and mooring tensions are studied. The short term mooring fatigue damage estimated by different spectral methods are compared to the rainflow counting method. The spectral method for estimating fatigue damage include the Dirlik formula, Jiao-Moan method and Tovo-Benasciutti approach. The accuracy of spectral methods for predicting mooring fatigue damage are discussed.

Slowly Varying Wave Drift Forces Analyzed From Model Test Data on a Moored Ship in Shallow Water

2009 ◽  
Author(s):  
Carl Trygve Stansberg ◽  
Csaba Paˆkozdi
Keyword(s):  
Noise Reduction ◽  
Shallow Water ◽  
Model Test ◽  
Transfer Functions ◽  
Numerical Study ◽  
Wave Frequency ◽  
Irregular Waves ◽  
Spectral Peak ◽  
Frequency Range ◽  
Wave Drift

Model test estimation of quadratic transfer functions (QTFs) is investigated for slowly varying wave drift excitation on a large moored ship in shallow water. Cross-bi-spectral analysis in irregular waves is used. A numerical study is run first, with a known, synthetical QTF model characterized by a strong off-diagonal variation, combined with a very lightly damped linear slow-drift dynamical system. The purpose is to check the accuracy of the analysis. For this simple model, a good accuracy is obtained in the estimated QTF. This is because of a refined noise reduction method which works well in this case. The wave frequency range of valid estimates is where the wave spectrum S(f) is higher than 7% of the spectral peak. Without the refinement, the useful range is reduced to where S(f) is higher than 15% of the spectral peak, based on a 3-hour sea state simulation. The method is then applied on experimental surge motion records from 1:50 scaled model tests carried out in an offshore basin, simulating 15m water depth. It is found that the QTF estimation procedure works reasonably well, but the accuracy is lower than that in the numerical study because the refined noise reduction could not be used due to the particular characteristics of the QTF. Therefore a basic version without the refinement had to be used. Still, results appear to be fairly reliable in the reduced wave frequency range with S(f) > 15% of the spectral peak, i.e. from 0.07Hz to 0.10Hz in this case.

Sign in / Sign up

Export Citation Format

Share Document