Zn/Fe nanocomposite based efficient electrochemical sensor for the simultaneous detection of metal ions

2021 ◽  
Vol 130 ◽  
pp. 114671
Author(s):  
Esraa M. Bakhsh ◽  
Sher Bahadar Khan ◽  
Abdullah M. Asiri ◽  
Afzal Shah
RSC Advances ◽  
2019 ◽  
Vol 9 (30) ◽  
pp. 17325-17334 ◽  
Author(s):  
Wei Yi ◽  
Zihua He ◽  
Junjie Fei ◽  
Xiaohua He

A novel electrochemical sensor with high stability and good reproducibility for the simultaneous detection of heavy metal ions was prepared by using PGA/GO to modify the GCE, showing high sensitivity of superior to most of the reported values.


2014 ◽  
Vol 6 (15) ◽  
pp. 5760-5765 ◽  
Author(s):  
Guishen Liu ◽  
Jianpeng Chen ◽  
Xiaodong Hou ◽  
Wensheng Huang

It is quite important to develop sensitive and simple analytical methods for the detection of toxic heavy metal ions, such as Cd2+ and Pb2+.


Polymers ◽  
2019 ◽  
Vol 11 (5) ◽  
pp. 815 ◽  
Author(s):  
Mihray Abdulla ◽  
Ahmat Ali ◽  
Ruxangul Jamal ◽  
Tursunnisahan Bakri ◽  
Wei Wu ◽  
...  

Heavy metal ions in water, cosmetics, and arable land have become a world-wide issue as they cause a variety of diseases and even death to humans and animals when a certain level is exceeded. Therefore, it is necessary to development a new kind of sensor material for the determination of heavy metal ions. In this paper, we present an electrochemical sensor based on composite material (thiol(–SH) grafted poly(3,4-proplenedioxythiophene) (PProDOT(MeSH)2)/ porous silicon spheres (Si) composite, denoted as PProDOT(MeSH)2@Si) from the incorporation of thiol(–SH) grafted poly(3,4-proplenedioxythiophene) (PProDOT(MeSH)2) with porous silicon spheres (Si) for the electrochemical detection of heavy metal ions (Cd(II), Pb(II), and Hg(II)). The PProDOT(MeSH)2@Si composite was synthesized via a chemical oxidative polymerization method. The structure and morphology of PProDOT(MeSH)2@Si composite were characterized by Fourier transform infrared (FT-IR), Ultraviolet–visible spectroscopy (UV–Vis), X-ray diffraction (XRD), scanning electron microscope (SEM), Transmission electron microscope (TEM), and Brunauer−Emmett−Teller (BET). Furthermore, the electrochemical performance of PProDOT(MeSH)2@Si was evaluated by detecting of Cd(II), Pb(II), and Hg(II) ions using the differential pulse voltammetry (DPV) method. The relationship between structural properties and the electrochemical performance was systematically studied. The results showed that the entry of two thiol-based chains to the monomer unit resulted in an increase in electrochemical sensitivity in PProDOT(MeSH)2, which was related to the interaction between thiol group(-SH) and heavy metal ions. And, the combination of PProDOT(MeSH)2 with Si could improve the electrocatalytic efficiency of the electrode material. The PProDOT(MeSH)2@Si/GCE exhibited high selectivity and sensitivity in the rage of 0.04 to 2.8, 0.024 to 2.8, and 0.16 to 3.2 μM with the detection limit of 0.00575, 0.0027, and 0.0017 µM toward Cd(II), Pb(II), and Hg(II), respectively. The interference studies demonstrated that the PProDOT(MeSH)2@Si/GCE possessed a low mutual interference and high selectivity for simultaneous detection of Cd(II), Pb(II), and Hg(II) ions.


2021 ◽  
Vol 56 (13) ◽  
pp. 8172-8185
Author(s):  
Manh B. Nguyen ◽  
Dau Thi Ngoc Nga ◽  
Vu Thi Thu ◽  
Benoît Piro ◽  
Thuan Nguyen Pham Truong ◽  
...  

Membranes ◽  
2021 ◽  
Vol 11 (7) ◽  
pp. 517
Author(s):  
Siyamthanda Hope Mnyipika ◽  
Tshimangadzo Saddam Munonde ◽  
Philiswa Nosizo Nomngongo

The rapid detection of trace metals is one of the most important aspect in achieving environmental monitoring and protection. Electrochemical sensors remain a key solution for rapid detection of heavy metals in environmental water matrices. This paper reports the fabrication of an electrochemical sensor obtained by the simultaneous electrodeposition of MnO2 nanoparticles and RGO nanosheets on the surface of a glassy carbon electrode. The successful electrodeposition was confirmed by the enhanced current response on the cyclic voltammograms. The XRD, HR-SEM/EDX, TEM, FTIR, and BET characterization confirmed the successful synthesis of MnO2 nanoparticles, RGO nanosheets, and MnO2@RGO nanocomposite. The electrochemical studies results revealed that MnO2@RGO@GCE nanocomposite considerably improved the current response on the detection of Zn(II), Cd(II) and Cu(II) ions in surface water. These remarkable improvements were due to the interaction between MnO2 nanomaterials and RGO nanosheets. Moreover, the modified sensor electrode portrayed high sensitivity, reproducibility, and stability on the simultaneous determination of Zn(II), Cd(II), and Cu(II) ions. The detection limits of (S/N = 3) ranged from 0.002–0.015 μg L−1 for the simultaneous detection of Zn(II), Cd(II), and Cu(II) ions. The results show that MnO2@RGO nanocomposite can be successfully used for the early detection of heavy metals with higher sensitivity in water sample analysis.


Author(s):  
Yuqi Zhang ◽  
Wang Wang ◽  
Ran Li ◽  
Ensheng Zhang ◽  
Zhonghua Li ◽  
...  

RSC Advances ◽  
2014 ◽  
Vol 4 (43) ◽  
pp. 22463-22469 ◽  
Author(s):  
Hyun Kim ◽  
Yu Jeong Na ◽  
Eun Joo Song ◽  
Kyung Beom Kim ◽  
Jeong Mi Bae ◽  
...  

The receptor 1 provides a novel approach for the simultaneous colorimetric recognition of two metal ions Fe2+ and Cu2+.


Sign in / Sign up

Export Citation Format

Share Document