Purple light-emitting diode (LED) lights controls chlorophyll degradation and enhances nutraceutical quality of postharvest broccoli florets

2021 ◽  
pp. 110768
Author(s):  
Chunyu Xie ◽  
Juan Tang ◽  
Junxia Xiao ◽  
Xin Geng ◽  
Liping Guo
HortScience ◽  
2019 ◽  
Vol 54 (10) ◽  
pp. 1745-1750 ◽  
Author(s):  
Cinthia Nájera ◽  
Miguel Urrestarazu

At present, trends exist in the production of food for the benefit of human health. The negative effect of an excessive intake of nitrates accumulated in vegetables is well known, causing worldwide concern. Light plays an important role in the accumulation of this ion. The objective of this work was to evaluate the effect of light-emitting diode (LED) spectra used in artificial lighting for horticulture on the accumulation of nitrates in leafy and root vegetables compared with the effects with white LED lights. Two independent experiments were carried out in the culture chamber. In Expt. 1, six species of nitrate accumulators were used: arugula, spinach, lettuce, endive, radish, and beetroot. In Expt. 2, four lettuce cultivars were used. In both experiments, the treatments were two spectra—T1 = AP67 Valoya® and the control (T0) = white Roblan®—at two illumination intensities [high (H) and low (L)] with a 16/8-hour (day/night) photoperiod. The fresh biomass and the concentration of nitrates were measured at 35 days of treatment posttransplantation. An important and significant increase of 50% of the mean fresh weight was obtained in all the species when the light intensity increased. Except for spinach in the low-intensity treatment, all nitrate content values were less than the maximum limits of European regulation. The nitrate content generally decreased with increasing intensity, and this benefit was greater in the T1 treatment. T0 showed a reduction in the nitrate content compared with T1 in only one case, which was the H in beetroot. A large and significant reduction was observed in the nitrate content in T1. For L in Expt. 1, the nitrate decrease was 18%, whereas for H, it was 35%. In Expt. 2, the decrease in the nitrate content was 10% for L and 21% for H. A greater benefit was derived when using the photosynthetic spectrum in the growing chambers under low light intensity.


Plants ◽  
2021 ◽  
Vol 10 (5) ◽  
pp. 960
Author(s):  
Jenny Manuela Tabbert ◽  
Hartwig Schulz ◽  
Andrea Krähmer

A light-emitting diode (LED) system covering plant-receptive wavebands from ultraviolet to far-red radiation (360 to 760 nm, “white” light spectrum) was investigated for greenhouse productions of Thymus vulgaris L. Biomass yields and amounts of terpenoids were examined, and the lights’ productivity and electrical efficiency were determined. All results were compared to two conventionally used light fixture types (high-pressure sodium lamps (HPS) and fluorescent lights (FL)) under naturally low irradiation conditions during fall and winter in Berlin, Germany. Under LED, development of Thymus vulgaris L. was highly accelerated resulting in distinct fresh yield increases per square meter by 43% and 82.4% compared to HPS and FL, respectively. Dry yields per square meter also increased by 43.1% and 88.6% under LED compared to the HPS and FL lighting systems. While composition of terpenoids remained unaffected, their quantity per gram of leaf dry matter significantly increased under LED and HPS as compared to FL. Further, the power consumption calculations revealed energy savings of 31.3% and 20.1% for LED and FL, respectively, compared to HPS. In conclusion, the implementation of a broad-spectrum LED system has tremendous potential for increasing quantity and quality of Thymus vulgaris L. during naturally insufficient light conditions while significantly reducing energy consumption.


Endoscopy ◽  
2016 ◽  
Vol 48 (10) ◽  
pp. 934-938 ◽  
Author(s):  
Sho Sasaki ◽  
Jun Nishikawa ◽  
Hideo Yanai ◽  
Munetaka Nakamura ◽  
Junichi Nishimura ◽  
...  

2009 ◽  
Vol 1192 ◽  
Author(s):  
Jesse J Cole ◽  
Heiko Jacobs

AbstractWe report a new integration approach to produce arrays of ZnO microcrystals for optoelectronic and photovoltaic applications. Demonstrated applications are n-ZnO/p-GaN heterojunction LEDs and photovoltaic cells. The integration process uses an oxygen plasma treatment in combination with a photoresist pattern on Magnesium doped GaN substrates to define a narrow sub-100nm width nucleation region. ZnO is synthesized in the defined areas by a hydrothermal technique using zinc acetate and hexamethylenetetramine precursors. Nucleation is followed by lateral epitaxial overgrowth producing single crystal disks of ZnO. The process provides control over the dimension and location of the ZnO crystals. The quality of the patterned ZnO is high; the commonly observed defect related emission in the electroluminescence spectra is suppressed and a single near-band-edge UV peak is observed. Transfer printing of the ZnO microcrystals onto a flexible substrate is also demonstrated in the context of transparent flexible electronics.


Plants ◽  
2020 ◽  
Vol 9 (10) ◽  
pp. 1351
Author(s):  
Chia-Chen Chen ◽  
Maw-Rong Lee ◽  
Chi-Rei Wu ◽  
Hsin-Ju Ke ◽  
Hui-Min Xie ◽  
...  

Investigations were carried out to study the effects of light-emitting diode (LED) lights on growth and development of isosteroidal alkaloids in embryogenic calli of Fritillaria cirrhosa D. Don, an important traditional Chinese medicine herb. Calli were cultured in glass bottles, each containing 100 mL of Murashige and Skoog’s basal medium supplemented with 2% sucrose and 0.4% gellan gum powder, a gelling agent. These bottles were incubated in a specially designed plant growth chamber equipped with eight different LED lights consisting of single or combinations of four different light spectra emitting blue (450 nm), green (525 nm), red (660 nm), and far-red (730 nm) light. After three months of incubation, morphological changes in embryogenic calli were recorded, and LC-MS/MS analysis of cultures was carried out for peimisine, sipeimine, peiminine, and peimine. The highest number of somatic embryos and the maximum fresh weight was recorded in calli incubated under red (9R), infrared (9IR), and a combination of red+blue+infrared (3R3B3IR), respectively, in decreasing order. The highest contents of peimisine, peiminine, and peimine were recorded under red (9R) and infrared (9IR) lights, respectively. Eight LED lights had significant effects on the morphogenesis of embryogenic calli of F. cirrhosa D. Don and contents of isosteroidal alkaloids.


2020 ◽  
Vol 3 (1) ◽  
pp. 12
Author(s):  
Noah de Castro ◽  
Robin Lewis Cooper

Monitoring movements of larval Drosophila with electrical detection allows one to record the behaviors without the use of lights and cameras. This is a suitable technique when studying the use of light-sensitive proteins in optogenetic studies. Electrical measures are feasible to use in determining when a larva starts to move or continues to move after a light induced activation of channelrhodopsin. We have developed a technique using an electrical measure of the media as an index of larval movement. As a proof of concept, recordings with an infrared camera of the larval movement were simultaneous made with electrical measures. The two techniques parallel each other in their ability to index larval movements. Bright light-emitting diode (LED) lights used in optogenetic experiments tend to saturate the detectors of the camera unless filters are used and different filters maybe necessary depending on the LED spectrum and sensitivity of the camera. Impedance measures are independent of the type of LED or brightness. We also assessed the use of a non-solvent based glue (3M Vetbond) to hold larvae in place while measuring synaptic function of neuromuscular junctions, cardiac function and influence of modulators, or activation of light-sensitive channels.


2017 ◽  
Vol 50 (6) ◽  
pp. 921-936 ◽  
Author(s):  
WJ Huang ◽  
Y Yang ◽  
M Ronnier Luo

This paper describes an experiment to investigate discomfort glare caused by white light-emitting diode (LED) lights having different spectral power distributions. It included two groups: a ‘Metamerism’ group and a ‘correlated colour temperatures (CCT)’ group. In the former group, it was found that white lights at 7000 K constructed from different blue LEDs and the same red and green LEDs gave about the same glare perception. In the latter group, there was a significant difference in glare perception between white lights having different CCTs. Finally, glare models, including unified glare rating (UGR) and the newly derived QUGRspd, and mUGRspd models, were tested using the data from the experiment. All of them gave quite accurate predictions of the data.


2013 ◽  
Vol 378 ◽  
pp. 440-443
Author(s):  
Chiu Jung Yang ◽  
Chien Sheng Huang ◽  
Chih Wei Chen ◽  
Po Wen Chen

Thepaperis discussedin coloruniformity study.The experiment divided into two steps in this study,first is modules design and simulation. Second is fabrication and measurement.After measure the LEDs property, calculating the ratio of each colored LEDs by using Grassmanns Law,modeling by Solidworks, and simulating the front study by optical software TracePro.Using four-color mixing with self-developed formula to avoid the present white light emitting diode patent, and the four-color grains are Red, Green, Blue and adding Y to modify the overall quality of the mixed light.The phosphorproduceSteabler-Wronsk hardly in the high temperatureas compared tofour-color mixing.Using four-color mixing to producehigher color rendering index than yellow phosphor.Series-parallel array of grain arrangement adopted to achieve the high demand for uniformity, while simplifying the design conditions by a certain current instead of the general mixed light-driven complex driver circuit,the completion of the mixing module using integrating sphere, light spectrum on the spectrophotometer, optical power, color coordinates values, such as mixing uniformity measurements.The chromaticity coordinates errors after complete results of the mixing module measurement and simulation can be controlled under (0.01x, 0.01y).


2016 ◽  
Vol 41 (3) ◽  
pp. E13 ◽  
Author(s):  
Sunil Manjila ◽  
Margherita Mencattelli ◽  
Benoit Rosa ◽  
Karl Price ◽  
Georgios Fagogenis ◽  
...  

OBJECTIVE Rigid endoscopes enable minimally invasive access to the ventricular system; however, the operative field is limited to the instrument tip, necessitating rotation of the entire instrument and causing consequent tissue compression while reaching around corners. Although flexible endoscopes offer tip steerability to address this limitation, they are more difficult to control and provide fewer and smaller working channels. A middle ground between these instruments—a rigid endoscope that possesses multiple instrument ports (for example, one at the tip and one on the side)—is proposed in this article, and a prototype device is evaluated in the context of a third ventricular colloid cyst resection combined with septostomy. METHODS A prototype neuroendoscope was designed and fabricated to include 2 optical ports, one located at the instrument tip and one located laterally. Each optical port includes its own complementary metal-oxide semiconductor (CMOS) chip camera, light-emitting diode (LED) illumination, and working channels. The tip port incorporates a clear silicone optical window that provides 2 additional features. First, for enhanced safety during tool insertion, instruments can be initially seen inside the window before they extend from the scope tip. Second, the compliant tip can be pressed against tissue to enable visualization even in a blood-filled field. These capabilities were tested in fresh porcine brains. The image quality of the multiport endoscope was evaluated using test targets positioned at clinically relevant distances from each imaging port, comparing it with those of clinical rigid and flexible neuroendoscopes. Human cadaver testing was used to demonstrate third ventricular colloid cyst phantom resection through the tip port and a septostomy performed through the lateral port. To extend its utility in the treatment of periventricular tumors using MR-guided laser therapy, the device was designed to be MR compatible. Its functionality and compatibility inside a 3-T clinical scanner were also tested in a brain from a freshly euthanized female pig. RESULTS Testing in porcine brains confirmed the multiport endoscope's ability to visualize tissue in a blood-filled field and to operate inside a 3-T MRI scanner. Cadaver testing confirmed the device's utility in operating through both of its ports and performing combined third ventricular colloid cyst resection and septostomy with an endoscope rotation of less than 5°. CONCLUSIONS The proposed design provides freedom in selecting both the number and orientation of imaging and instrument ports, which can be customized for each ventricular pathological entity. The lightweight, easily manipulated device can provide added steerability while reducing the potential for the serious brain distortion that happens with rigid endoscope navigation. This capability would be particularly valuable in treating hydrocephalus, both primary and secondary (due to tumors, cysts, and so forth). Magnetic resonance compatibility can aid in endoscope-assisted ventricular aqueductal plasty and stenting, the management of multiloculated complex hydrocephalus, and postinflammatory hydrocephalus in which scarring obscures the ventricular anatomy.


Author(s):  
Suzi Seroja Sarnin ◽  
Nur Jumaatul Hidayati Binti Mohammad ◽  
Nani Fadzlina Naim ◽  
Norsuzila Ya’acob ◽  
Azlina Idris ◽  
...  

<span>One of the key issues for those involved in farming and greenhouse is the use of pesticides. In a recent headline, there has been an epidemic of insect infestation that has destroyed 211 hectares of rice plants. These concerns have led to the discussion of possible over-use of pesticides that are not just killing dangerous pests, but also other animals that help combat the pest. In order to overcome the problem, a research was conducted by introducing a smart insect killer.  In this developing project, Pyroelectric (PIR) sensor will be using as a motion detector towards insects. This sensor plays a role to transmit the signal for action in taking care of the plant. The IR sensors will install around the plant, so that it has good range to detect any motion. As a result, suitable chemical spray will trigger to repel these insects. A light emitting diode as an indicator of functional to the system.  "Smart Insect Repeller" will work when certain pests are detected and this will reduce the use of poisons and the quality of the crop will be preserved due to the use of minimal poisons.</span>


Sign in / Sign up

Export Citation Format

Share Document