The dynamic response of sites with earth fissures as revealed by microtremor analysis——A case study in the Linfen Basin, China

2020 ◽  
Vol 132 ◽  
pp. 106076
Author(s):  
Jiang Chang ◽  
Yahong Deng ◽  
You Xuan ◽  
Zuofei Yan ◽  
Wei Wu ◽  
...  
Author(s):  
S. Ye ◽  
Y. Wang ◽  
J. Wu ◽  
P. Teatini ◽  
J. Yu ◽  
...  

Abstract. The Suzhou-Wuxi-Changzhou (known as "Su-Xi-Chang") area, located in the southern part of Jiangsu Province, China, experienced serious land subsidence caused by overly exploitation of groundwater. The largest cumulative land subsidence has reached 3 m. With the rapid progress of land subsidence since the late 1980s, more than 20 earth fissures developed in Su-Xi-Chang area, although no pre-existing faults have been detected in the surroundings. The mechanisms of earth fissure generation associated with excessive groundwater pumping are: (i) differential land subsidence, (ii) differences in the thickness of the aquifer system, and (iii) bedrock ridges and cliffs at relatively shallow depths. In this study, the Guangming Village Earth Fissures in Wuxi area are selected as a case study to discuss in details the mechanisms of fissure generation. Aquifer exploitation resulted in a drop of groundwater head at a rate of 5–6 m yr−1 in the 1990s, with a cumulative drawdown of 40 m. The first earth fissure at Guangming Village was observed in 1998. The earth fissures, which developed in a zone characterized by a cumulative land subsidence of approximately 800 mm, are located at the flank of a main subsidence bowl with differential subsidence ranging from 0 to 1600 mm in 2001. The maximum differential subsidence rate amounts to 5 mm yr−1 between the two sides of the fissures. The fissure openings range from 30 to 80 mm, with a cumulative length of 1000 m. Depth of bed rock changes from 60 to 140 m across the earth fissure. The causes of earth fissure generation at Guangming Village includes a decrease in groundwater levels, differences in the thickness of aquifer system, shallow depths of bedrock ridges and cliffs, and subsequent differential land subsidence.


2014 ◽  
Vol 36 (4) ◽  
pp. 245-254
Author(s):  
N. T. Khiem ◽  
P. T. Hang

In present paper, the spectral approach is proposed for analysis of multiple cracked beam subjected to general moving load that allows us to obtain explicitly dynamic response of the beam in frequency domain. The obtained frequency response is straightforward to calculate time history response by using the FFT algorithm and provides a novel tool to investigate effect of position and depth of multiple cracks on the dynamic response. The analysis is important to develop the spectral method for identification of multiple cracked beam by using its response to moving load. The theoretical development is illustrated and validated by numerical case study.


2018 ◽  
Vol 9 (1) ◽  
pp. 862-880 ◽  
Author(s):  
Jishan Xu ◽  
Jianbing Peng ◽  
Yahong Deng ◽  
Hongqian He ◽  
Lingchao Meng ◽  
...  

Author(s):  
Krishna Chytanya Chinnam ◽  
Arnaldo Casalotti ◽  
Giulia Lanzara

Abstract In this paper the dynamic response of an electrospun nanocomposite piezoelectric microfiber is investigated. The microfiber is formed by magnetic nanoparticles dispersed in Polyvinylidene (PVDF) matrix. Focus is given on the influence of an AC electric field on the dynamic response of the microfiber. In particular, the resonance frequency of the fiber was assessed under an increasing AC electric field at a wide range of frequencies. The electromechanical test results show that the resonance frequency of the fiber is influenced by the applied voltage and, for this case study, it decreases with increasing voltage. The results reported in this paper suggest that, once the mechanism behind such response is fully understood, composite piezoelectric microfibers can be used to fine-tune the resonance frequency of hosting devices.


Mining Revue ◽  
2021 ◽  
Vol 27 (4) ◽  
pp. 33-49
Author(s):  
Ildiko Brînaş

Abstract The paper deals with the analysis of the dynamic response over time of the excavator boom during operation. For a start, we determined the variation in time of the forces acting on the rotor shaft, due to the excavation. These forces have high values and a slow variation over time, which depends on the rotation speed of the bucket wheel and the number of buckets installed on it. A virtual model of the BWE boom was proposed, for which the dynamic response in time due to the excavation forces was determined, for a point in the main cabin of the BWE. A virtual sensor has been attached to this point corresponding to seat of the operator. The simulation of the dynamic response over time was performed taking into account a global damping of 2% of the critical damping. The simulation was performed both for the excavation of a homogeneous material and for the case of a shock (a sudden appearance of an inclusion of hard material during the cutting of the homogeneous material).


2017 ◽  
Vol 35 (1) ◽  
pp. 131-143 ◽  
Author(s):  
Lj. B. Kevac ◽  
M. M. Filipovic

AbstractThe general form of mathematical model of cable winding/unwinding system is defined for several different constructions. The novelty of this mathematical model is detection and mathematical formulation of influence of new dynamic variables: winding/unwinding radius and cable length on dynamic response of cable winding/unwinding system. The validity of the obtained theoretical contribution has been illustrated through one case study by using a newly developed software package CWUSOFT which was generated in MATLAB. Theoretical and simulation results are confirmed through the experimental analysis of one novel construction of the cable winding/unwinding system.


Sign in / Sign up

Export Citation Format

Share Document