Transition of graphene oxide-coated fiber bundles from insulator to conductor by chemical reduction

2015 ◽  
Vol 204 ◽  
pp. 90-94 ◽  
Author(s):  
Dong Han Ha ◽  
Suyong Jung ◽  
Ho-Jong Kim ◽  
Daehee Kim ◽  
Wan-Joong Kim ◽  
...  
Keyword(s):  
Graphene Oxide ◽  
Chemical Reduction ◽  
Fiber Bundles ◽  
Coated Fiber

Preparation for Graphene Coated Polyvinyl Alcohol Based Conductive Fiber Containing Silver Nanowires

2019 ◽  
Vol 807 ◽  
pp. 171-175
Author(s):  
Chao Xiao ◽  
Xi Ke Xiong ◽  
Jun Sun ◽  
Li Xing Dai
Keyword(s):  
Electrical Conductivity ◽  
Graphene Oxide ◽  
Synergistic Effect ◽  
Polyvinyl Alcohol ◽  
Silver Nanowires ◽  
Chemical Reduction ◽  
Fiber Surface ◽  
Coated Fiber ◽  
Conductive Fiber ◽  
Pva Fiber

Graphene oxide (GO) coated fiber via deposition of GO sheets on polyvinyl alcohol (PVA) fiber containing silver nanowires (AgNWs) was fabricated, and chemical reduction for GO on the fiber surface was carried out to obtain reduced GO (rGO) coated PVA-AgNWs (rGO/PVA-AgNWs) fiber. The results showed that the rGO sheets were closely adhered on the surface of fiber, the electrical conductivity of the fiber increased with coating times of GO, and the conductivity was high up to 2.05×10-3 S/m when GO was coated 3 times on the fiber and reduced. The synergistic effect of rGO and AgNWs for the conductivity was also clearly indicated.

scholarly journals Low Surface Roughness Graphene Oxide Film Reduced with Aluminum Film Deposited by Magnetron Sputtering

Nanomaterials ◽  
2021 ◽  
Vol 11 (6) ◽  
pp. 1428
Author(s):  
Xiaowei Fan ◽  
Xuguo Huai ◽  
Jie Wang ◽  
Li-Chao Jing ◽  
Tao Wang ◽  
...  
Keyword(s):  
Surface Roughness ◽  
Electron Transfer ◽  
Graphene Oxide ◽  
Magnetron Sputtering ◽  
Chemical Reduction ◽  
Graphene Film ◽  
Conductivity Measurement ◽  
Electrical Conductivity Measurement ◽  
Vis Spectroscopy ◽  
Hcl Solution

Graphene film has wide applications in optoelectronic and photovoltaic devices. A novel and facile method was reported for the reduction of graphene oxide (GO) film by electron transfer and nascent hydrogen produced between aluminum (Al) film deposited by magnetron sputtering and hydrochloric acid (HCl) solution for only 5 min, significantly shorter than by other chemical reduction methods. The thickness of Al film was controlled utilizing a metal detection sensor. The effect of the thickness of Al film and the concentration of HCl solution during the reduction was explored. The optimal thickness of Al film was obtained by UV-Vis spectroscopy and electrical conductivity measurement of reduced GO film. Atomic force microscope images could show the continuous film clearly, which resulted from the overlap of GO flakes, the film had a relatively flat surface morphology, and the surface roughness reduced from 7.68 to 3.13 nm after the Al reduction. The film sheet resistance can be obviously reduced, and it reached 9.38 kΩ/sq with a high transmittance of 80% (at 550 nm). The mechanism of the GO film reduction by electron transfer and nascent hydrogen during the procedure was also proposed and analyzed.

scholarly journals A Facile and Green Synthesis of a MoO2-Reduced Graphene Oxide Aerogel for Energy Storage Devices

Materials ◽  
2020 ◽  
Vol 13 (3) ◽  
pp. 594 ◽  
Author(s):  
Mara Serrapede ◽  
Marco Fontana ◽  
Arnaud Gigot ◽  
Marco Armandi ◽  
Glenda Biasotto ◽  
...  
Keyword(s):  
Graphene Oxide ◽  
Reduced Graphene Oxide ◽  
Photoelectron Spectroscopy ◽  
Electrochemical Impedance ◽  
Chemical Reduction ◽  
Low Cost ◽  
Xps Analysis ◽  
3D Scaffold ◽  
Energy Storage Devices ◽  
Reduced Graphene

A simple, low cost, and “green” method of hydrothermal synthesis, based on the addition of l-ascorbic acid (l-AA) as a reducing agent, is presented in order to obtain reduced graphene oxide (rGO) and hybrid rGO-MoO2 aerogels for the fabrication of supercapacitors. The resulting high degree of chemical reduction of graphene oxide (GO), confirmed by X-Ray Photoelectron Spectroscopy (XPS) analysis, is shown to produce a better electrical double layer (EDL) capacitance, as shown by cyclic voltammetric (CV) measurements. Moreover, a good reduction yield of the carbonaceous 3D-scaffold seems to be achievable even when the precursor of molybdenum oxide is added to the pristine slurry in order to get the hybrid rGO-MoO2 compound. The pseudocapacitance contribution from the resulting embedded MoO2 microstructures, was then studied by means of CV and electrochemical impedance spectroscopy (EIS). The oxidation state of the molybdenum in the MoO2 particles embedded in the rGO aerogel was deeply studied by means of XPS analysis and valuable information on the electrochemical behavior, according to the involved redox reactions, was obtained. Finally, the increased stability of the aerogels prepared with l-AA, after charge-discharge cycling, was demonstrated and confirmed by means of Field Emission Scanning Electron Microscopy (FESEM) characterization.

Chemically reduced graphene oxide-coated knitted fabric imparted conductivity and outstanding hydrophobicity

2021 ◽  
pp. 004051752199547
Author(s):  
Min Hou ◽  
Xinghua Hong ◽  
Yanjun Tang ◽  
Zimin Jin ◽  
Chengyan Zhu ◽  
...  
Keyword(s):  
Electrical Conductivity ◽  
Graphene Oxide ◽  
Reduced Graphene Oxide ◽  
Chemical Reduction ◽  
Knitted Fabric ◽  
Mesh Structure ◽  
Reduced Graphene ◽  
Chemically Reduced Graphene Oxide ◽  
Modified Hummers Method

Functionalized knitted fabric, as a kind of flexible, wearable, and waterproof material capable of conductivity, sensitivity and outstanding hydrophobicity, is valuable for multi-field applications. Herein, the reduced graphene oxide (RGO)-coated knitted fabric (polyester/spandex blended) is prepared, which involves the use of graphite oxide (GO) by modified Hummers method and in-situ chemical reduction with hydrazine hydrate. The treated fabric exhibits a high electrical conductivity (202.09 S/cm) and an outstanding hydrophobicity (140°). The outstanding hydrophobicity is associated with the morphology of the fabric and fiber with reference to pseudo-infiltration. These properties can withstand repeated bending and washing without serious deterioration, maintaining good electrical conductivity (35.70 S/cm) and contact angle (119.39°) after eight standard washing cycles. The material, which has RGO architecture and continuous loop mesh structure, can find wide use in smart garment applications.

Well-Aligned Graphene Oxide Nanosheets Decorated with Zinc Oxide Nanocrystals for High Performance Photocatalytic Application

2015 ◽  
Vol 14 (03) ◽  
pp. 1550007 ◽  
Author(s):  
K. Kaviyarasu ◽  
C. Maria Magdalane ◽  
E. Manikandan ◽  
M. Jayachandran ◽  
R. Ladchumananandasivam ◽  
...  
Keyword(s):  
Zinc Oxide ◽  
Graphene Oxide ◽  
High Performance ◽  
Chemical Reduction ◽  
Visible Region ◽  
Single Layer ◽  
Single Layer Graphene ◽  
Graphene Oxides ◽  
X Ray ◽  
Nanoscale Structures

Graphene oxide (GO) nanosheets modified with zinc oxide nanocrystals were achieved by a green wet-chemical approach. As-obtained products were characterized by XRD, Raman spectra, XPS, HR-TEM, EDS, PL and Photocatalytic studies. XRD studies indicate that the GO nanosheet have the same crystal structure found in hexagonal form of ZnO . The enhanced Raman spectrum of 2D bands confirmed formation of single layer graphene oxides. The gradual photocatalytic reduction of the GO nanosheet in the GO : ZnO suspension of ethanol was studied by using X-ray photoelectron (XPS) spectroscopy. The nanoscale structures were observed and confirmed using high resolution transmission electron microscopy (HR-TEM). The evolution of the elemental composition, especially the various numbers of layers were determined from energy dispersive X-ray spectra (EDS). PL properties of GO : ZnO nanosheet were found to be dependent on the growth condition and the resultant morphology revealed that GO nanosheet were highly transparent in the visible region. The photocatalytic performance of GO : ZnO nanocomposites was performed under UV irradiation. Therefore, the ZnO nanocrystals in the GO : ZnO composite could be applied in gradual chemical reduction and consequently tuning the electrical conductivity of the graphene oxide nanosheet.

scholarly journals Antibacterial Property of Composites of Reduced Graphene Oxide with Nano-Silver and Zinc Oxide Nanoparticles Synthesized Using a Microwave-Assisted Approach

2019 ◽  
Vol 20 (21) ◽  
pp. 5394 ◽  
Author(s):  
Yi-Huang Hsueh ◽  
Chien-Te Hsieh ◽  
Shu-Ting Chiu ◽  
Ping-Han Tsai ◽  
Chia-Ying Liu ◽  
...  
Keyword(s):  
Zinc Oxide ◽  
Antibacterial Activity ◽  
Graphene Oxide ◽  
Reductase Activity ◽  
Chemical Reduction ◽  
Membrane Integrity ◽  
Zno Nps ◽  
Nano Silver ◽  
E Coli ◽  
Microwave Assisted

Graphene oxide (GO) composites with various metal nanoparticles (NPs) are attracting increasing interest owing to their broad scope in biomedical applications. Here, microwave-assisted chemical reduction was used to deposit nano-silver and zinc oxide NPs (Ag and ZnO NPs) on the surface of reduced GO (rGO) at the following weight percentages: 5.34% Ag/rGO, 7.49% Ag/rGO, 6.85% ZnO/rGO, 16.45% ZnO/rGO, 3.47/34.91% Ag/ZnO/rGO, and 7.08/15.28% Ag/ZnO/rGO. These materials were tested for antibacterial activity, and 3.47/34.91% Ag/ZnO/rGO and 7.08/15.28% Ag/ZnO/rGO exhibited better antibacterial activity than the other tested materials against the gram-negative bacterium Escherichia coli K12. At 1000 ppm, both these Ag/ZnO/rGO composites had better killing properties against both E. coli K12 and the gram-positive bacterium Staphylococcus aureus SA113 than Ag/rGO and ZnO/rGO did. RedoxSensor flow cytometry showed that 3.47/34.91% Ag/ZnO/rGO and 7.08/15.28% Ag/ZnO/rGO decreased reductase activity and affected membrane integrity in the bacteria. At 100 ppm, these two composites affected membrane integrity more in E. coli, while 7.08/15.28% Ag/ZnO/rGO considerably decreased reductase activity in S. aureus. Thus, the 3.47/34.91% and 7.08%/15.28% Ag/ZnO/rGO nanocomposites can be applied not only as antibacterial agents but also in a variety of biomedical materials such as sensors, photothermal therapy, drug delivery, and catalysis, in the future.

scholarly journals Synthesis and Characterization of Reduced Graphene Oxide (rGO) Started from Graphene Oxide (GO) Using the Tour Method with Different Parameters

2019 ◽  
Vol 2019 ◽  
pp. 1-9 ◽  
Author(s):  
Adere Tarekegne Habte ◽  
Delele Worku Ayele
Keyword(s):  
Graphene Oxide ◽  
Reduced Graphene Oxide ◽  
Potassium Permanganate ◽  
Chemical Reduction ◽  
Volume Ratio ◽  
Graphite Powder ◽  
Green Approach ◽  
Synthesis Strategy ◽  
Reduced Graphene ◽  
Diffraction Patterns

A new approach to synthesize graphene is oxidizing graphite powder with a mixture of H2SO4/H3PO4 acids and potassium permanganate. Parameters such as reaction time, reaction temperature, and amount of concentration were varied to study the degree of oxidation of graphite to graphene oxide. Currently, an improved method for the preparation of graphene oxide was the most common one. A mixture of H2SO4/H3PO4 (9 : 1 volume ratio) instead of only H2SO4 resulted in increased hydrophilic and oxidized GO without the emission of toxic gas, which differs from the traditional Hummers’ method. The graphene oxide (GO) was converted to reduced graphene oxide (rGO) by chemical reduction using ascorbic acid as the reducing agent. The GO and rGO were characterized by UV-visible spectroscopy, FTIR spectroscopy, and X-ray diffraction patterns. The result showed that treating graphite powder with potassium permanganate (1 : 9) and a mixture of concentrated H2SO4/H3PO4 acids at 50°C for 12 hours resulted in a better oxidation degree. The designed synthesis strategy could be easily controlled and is an alternative green approach for the production of graphene oxide and reduced graphene oxide.

Sign in / Sign up

Export Citation Format

Share Document