In-situ Raman spectroscopy and X-ray diffraction studies of the structural transformations leading to the SrCu2O2 phase from strontium–copper oxide thin films deposited by metalorganic chemical vapor deposition

2013 ◽  
Vol 541 ◽  
pp. 136-141 ◽  
Author(s):  
A. Khan ◽  
C. Jiménez ◽  
O. Chaix-Pluchery ◽  
H. Roussel ◽  
J.L. Deschanvres
Keyword(s):  
Vapor Deposition ◽  
Metalorganic Chemical Vapor Deposition ◽  
Chemical Vapor ◽  
Structural Transformations ◽  
X Ray Diffraction ◽  
In Situ Raman Spectroscopy ◽  
X Ray ◽  
In Situ Raman ◽  
Metalorganic Chemical

Real-Time Composition And Thickness Control Techniques In A Metalorganic Chemical Vapor Deposition Process

1995 ◽  
Vol 406 ◽  
Author(s):  
M. S. Gaffneyt ◽  
C. M. Reavesl ◽  
A. L Holmes ◽  
R. S. Smith ◽  
S. P. DenBaars
Keyword(s):  
Chemical Vapor Deposition ◽  
Real Time ◽  
Vapor Deposition ◽  
Metalorganic Chemical Vapor Deposition ◽  
Chemical Vapor ◽  
Normal Operation ◽  
Growth Monitoring ◽  
X Ray Diffraction ◽  
X Ray ◽  
Metalorganic Chemical

AbstractMetalorganic chemical vapor deposition (MOCVD) is a process used to manufacture electronic and optoelectronic devices that has traditionally lacked real-time growth monitoring and control. We have developed control strategies that incorporate monitors as real-time control sensors to improve MOCVD growth. An analog control system with an ultrasonic concentration monitor was used to reject bubbler concentration disturbances which exist under normal operation, during the growth of a four-period GaInAs/InP superlattice. Using X-ray diffraction, it was determined that the normally occurring concentration variations led to a wider GaInAs peak in the uncompensated growths as compared to the compensated growths, indicating that closed loop control improved GaInAs composition regulation. In further analysis of the X-ray diffraction curves, superlattice peaks were used as a measure of high crystalline quality. The compensated curve clearly displayed eight orders of satellite peaks, whereas the uncompensated curve shows little evidence of satellite peaks.

Characteristics of Gallium Oxide Nanowires Synthesized by the Metalorganic Chemical Vapor Deposition

2007 ◽  
Vol 539-543 ◽  
pp. 1230-1235 ◽  
Author(s):  
Hyoun Woo Kim ◽  
S.H. Shim
Keyword(s):  
Chemical Vapor Deposition ◽  
Cross Sections ◽  
Vapor Deposition ◽  
Metalorganic Chemical Vapor Deposition ◽  
Chemical Vapor ◽  
Silicon Substrates ◽  
X Ray Diffraction ◽  
X Ray ◽  
Transmission Electron ◽  
Metalorganic Chemical

We have synthesized the high-density Ga2O3 nanowires on gold (Au)-coated silicon substrates using metalorganic chemical vapor deposition. The nanowires exhibited one-dimensional structures having circular cross sections with diameters in the range of 30-200 nm. The energy dispersive x-ray spectroscopy revealed that the nanowires contained elements of Ga and O, without Au-related impurities. X-ray diffraction analysis and high-resolution transmission electron microscopy showed that the Ga2O3 nanowires were crystalline.

Monitoring of indium x-ray peak to optimize InxGa1-xN layer grown by metalorganic chemical vapor deposition

1996 ◽  
Vol 449 ◽  
Author(s):  
Hongqiang Lu ◽  
Malathi Thothathiri ◽  
Ziming Wu ◽  
Ishwara Bhat
Keyword(s):  
Chemical Vapor Deposition ◽  
Vapor Deposition ◽  
Metalorganic Chemical Vapor Deposition ◽  
Quantitative Measure ◽  
Chemical Vapor ◽  
Droplet Formation ◽  
X Ray Diffraction ◽  
Growth Technique ◽  
X Ray ◽  
Metalorganic Chemical

ABSTRACTIndium droplet formation during the epitaxial growth of InxGa1-xN films is a serious problem for achieving high quality films with high indium mole fraction. In this paper, we studied the formation of indium droplets on the InxGa1-xN films grown by metalorganic chemical vapor deposition (MOCVD) using single crystal x-ray diffraction. It is found that the indium (101) peak in the x-ray diffraction spectra can be utilized as a quantitative measure to determine the amounts of indium droplets on the film. It is shown by monitoring the indium diffraction peak that the density of indium droplets increases at lower growth temperature. To suppress these indium droplets, a modulation growth technique is used. Indium droplet formation in the modulation growth is investigated and it is revealed in our study that the indium droplets problem has been partially relieved by the modulation growth technique.

Detection and Analysis of Phase Separation in Metalorganic Chemical Vapor Deposition InGaN

1997 ◽  
Vol 482 ◽  
Author(s):  
E. L. Piner ◽  
N. A. El-Masry ◽  
S. X. Liu ◽  
S. M. Bedair
Keyword(s):  
Chemical Vapor Deposition ◽  
Phase Separation ◽  
Vapor Deposition ◽  
Metalorganic Chemical Vapor Deposition ◽  
Single Phase ◽  
Chemical Vapor ◽  
X Ray Diffraction ◽  
X Ray ◽  
Transmission Electron ◽  
Metalorganic Chemical

AbstractInGaN films in the 0–50% InN composition range have been analyzed for the occurrence of phase separation. The ñ0.5 jum thick InGaN films were grown by metalorganic chemical vapor deposition (MOCVD) in the 690 to 780°C temperature range and analyzed by θ−20 x-ray diffraction (XRD), transmission electron microscopy (TEM), and selected area diffraction (SAD). As-grown films with up to 21% InN were single phase. However, for films with 28% InN and higher, the samples showed a spinodally decomposed microstructure as confirmed by TEM and extra spots in SAD patterns that corresponded to multiphase InGaN. An explanation of the data based on the GaN-InN pseudo-binary phase diagram is discussed.

In Situ Heteroepitaxial Bi2Sr2CaCu2O8 Thin Films Prepared by Metalorganic Chemical Vapor Deposition

1993 ◽  
Vol 335 ◽  
Author(s):  
Frank Dimeo ◽  
Bruce W. Wessels ◽  
Deborah A. Neumayer ◽  
Tobin J. Marks ◽  
Jon L. Schindler ◽  
...  
Keyword(s):  
Thin Films ◽  
Chemical Vapor Deposition ◽  
Vapor Deposition ◽  
Metalorganic Chemical Vapor Deposition ◽  
Chemical Vapor ◽  
Oxide Phase ◽  
Growth Conditions ◽  
X Ray Diffraction ◽  
Metalorganic Chemical

AbstractBi2Sr2CaCu2O8 thin films have been prepared in situ by low pressure metalorganic chemical vapor deposition using fluorinated β–diketonate precursors. The influence of the growth conditions on the oxide phase stability and impurity phase formation was examined as well as the superconducting properties of the films. Thin films deposited on LaAIO3 substrates were epitaxial as confirmed by x-ray diffraction measurements, including θ-2θ and φ scans. Four probe resistivity measurements showed the films to be superconducting with a maximum Tc0 of 90 K without post annealing. This Tc0 is among the highest reported for thin films of the BSCCO (2212) phase, and approaches reported bulk values.

Epitaxial Growth of AlN on 3C-SiC and Al2O3 Substrates

1992 ◽  
Vol 242 ◽  
Author(s):  
B. S. Sywe ◽  
Z. J. Yu ◽  
J. H. Edgar
Keyword(s):  
Thin Film ◽  
Crystal Structure ◽  
Vapor Deposition ◽  
Metalorganic Chemical Vapor Deposition ◽  
Chemical Vapor ◽  
X Ray Diffraction ◽  
X Ray ◽  
Oriented Polycrystalline ◽  
Deposited Films ◽  
Metalorganic Chemical

ABSTRACTA1N films were grown on the (100) plane of 3C-SiC/Si and the (0001) plane of A12O3 substrates by metalorganic chemical vapor deposition (MOCVD) using trimethylaluminum (TMA) and ammonia (NH3) as the precursors. The deposited films were characterized by X-ray diffraction (XRD) and a Read thin film camera. At 1150°C, preferentially oriented polycrystalline AlN films were obtained on both substrates and the crystal structure was wurtzite. The epitaxial relations were (1010)AlN//(100)SiC//(100)Si and (0001)AlN// (0001)Al2O3. The attempt to grow cubic AlN on 3C-SiC/Si was not successful.

Sign in / Sign up

Export Citation Format

Share Document