Anionic electrophoretic pattern of five ruthenium salts in fresh and sea water: effects of ageing and dilution

1973 ◽  
Vol 67 (2) ◽  
pp. 480-485 ◽  
Author(s):  
J. Vos ◽  
S. Van Puymbroeck ◽  
O.Van Der Borght ◽  
H. Peperstraete ◽  
M. D'Hont
Materials ◽  
2019 ◽  
Vol 12 (5) ◽  
pp. 807 ◽  
Author(s):  
Matteo Cavasin ◽  
Marco Sangermano ◽  
Barry Thomson ◽  
Stefanos Giannis

An innovative testing methodology to evaluate the effect of long-term exposure to a marine environment on Glass Fiber Reinforced Polymers (GFRPs) has been investigated and is presented in this paper. Up to one-year ageing was performed in seawater, to simulate the environment for offshore oil and gas applications. The performance of an epoxy and epoxy-based GFRP exposed at different temperatures from 25 to 80 °C was quantified. The materials were also aged in dry air, to de-couple the thermal effect from the seawater chemical action. Gravimetric testing and Dynamic Mechanical Analysis (DMA) were conducted in parallel on progressively aged specimens. The effect of specimen geometry and the anisotropic nature of diffusion are comprehensively discussed in this paper. For the quasi-infinite specimens, the results show an exponential increase in the seawater absorption rate with temperature. The methodology allowed for the prediction of the diffusivity at a temperature of 4 °C as 0.23 and 0.05 × 10−13 m2/s for the epoxy and the epoxy-based composite, respectively. The glass transition temperature reduces as sea water is absorbed, yet the sea water effects appear to be reversible upon drying.


1966 ◽  
Vol 88 (3) ◽  
pp. 203-208 ◽  
Author(s):  
D. B. Anderson ◽  
B. R. Richards

This paper contains a review of literature, field experience, and test data concerning control of fouling by chlorination and temperature and the effects of water treatments on metallic corrosion.


2004 ◽  
Vol 35 (6-8) ◽  
pp. 451-459 ◽  
Author(s):  
Xiaoming Li ◽  
Y.Jack Weitsman

2016 ◽  
Vol 724 ◽  
pp. 39-42 ◽  
Author(s):  
H. Mardin ◽  
I.N.G. Wardana ◽  
Kamil Kusno ◽  
Pratikto ◽  
S. Wahyono

Effects of sea water immersion for palm fiber in relation to surface morphology, roughness and bonding between the fiber and sago matrix were observed. Duration of immersion varied in 1, 2, 3 and 4 weeks, and then dried at room temperature for 3 hours continued by oven at 80 °C for 6 hours. SEM and roughness arithmetic tests were applied to see surface morphology, roughness and bonding between fiber and the matrix. Result shows fiber morphology and roughness varies by the duration of immersion. The surface roughness increases as immersion continues along with fiber - matrix bonding improvement. The maximum duration of 4 weeks fiber immersion resulted in the best interlocking of matrix and fibers, as the slits between them disappear.


1978 ◽  
Vol 5 (3) ◽  
pp. 387 ◽  
Author(s):  
HGM Dowden ◽  
MJ Lambert ◽  
R Truman

A disorder of Norfolk Island pines, Araucaria heterophylla (Salisb.) Franco, has occurred on certain urbanized parts of the coast of New South Wales. Observation and survey work suggested that the disorder was due to excessive foliar uptake of salt, induced by surfactants derived from sewage discharged into the sea. The work described in this paper was part of a programme of studies designed to test this hypothesis. Glasshouse experiments were carried out to test the effects of distilled water and deep-sea water both with and without added surfactants sprayed onto the foliage of young potted Norfolk Island pines. Whereas the distilled water effects were minimal, some needle and shoot necrosis occurred in all plants sprayed with sea water and this effect was markedly accentuated when surfactant was present. Shoot necrosis was highly significantly correlated with the concentration of sodium and chloride taken up by the foliage, and the foliar salt levels were very similar to those found in deteriorating trees located by the seaside. The results showed that a commonly used surfactant, when sprayed in a sea-water solution onto Norfolk Island pine foliage, caused damage similar to that observed in affected seaside trees.


The precise nature of the change which ushers in the development of the egg has been much discussed. Broadly speaking, the problem may be said to have been considered from two points of view, the chemical and the physical. According to the point of view, the spermatozoon or the parthenogenetic agent has been supposed to start a chemical change within or at the surface of the cell, or to alter the physical properties of the surface. Loeb, for instance, in a recently published book, ascribes development to the introduction of certain substances into the interior of the egg. Lillie, and McLendon, on the other hand, regard an increase in the permeability of the egg surface to electrolytes as the precursor of development. The experiments described in this paper favour in general the latter hypothesis; but as they do not support the theories of Lillie and McLendon in detail, it will be well to give at the outset a brief sketch of the work of these investigators. In 1910 Lillie showed that the unfertilised eggs of lose their pigment when placed in isotonic solutions of various sodium salts. The order of effectiveness of the anions was found to be Cl<Br<NO 3 <CNS<I; this is also the order in which these ions affect the state of aggregation of colloids. If the eggs are removed from these solutions after an appropriate interval, membranes are formed round the eggs and a certain number develop into larvae. In the following year he showed that the effect of these sodium salts can be inhibited by the addition of calcium salts to the solutions. Accepting the view of Hamburger, Höber, and others that the phenomena of cytolysis are primarily due to an increase in the permeability of the cell surface to ions, Lillie arrived at the following conception of the fundamental processes which attend the development of the unfertilised egg:— Before fertilisation the egg membrane is freely permeable to kations, but only very partially permeable to anions ; hence, the egg membrane must be the seat of an electrical charge which is determined by Nernst’s formula E = u‒v / u+v RT/F log c 2 / c 1 , where u is the velocity of the kation and v of the anion; RT/F is constant; c 2 and c 1 the concentration of electrolytes inside and outside the cell. After fertilisation, however, the value of v is increased, so that the surface polarisation is decreased. It is this loss of surface polarisation which is the fundamental factor in the develop­ment of the unfertilised egg. From various general conclusions Lillie concludes that no cell can withstand a sustained condition of increased permeability, for such a condition would disorganise the electrolytic contents of the cell. Hence, after fertilisation, the permeability must fairly quickly be reduced again to its former value. In the case of eggs which are treated with butyric acid Lillie holds that the subsequent treatment with hypertonic sea-water effects this decrease in permeability.


Sign in / Sign up

Export Citation Format

Share Document