Current sampling in polarography without synchronization with the drop time

1979 ◽  
Vol 110 (1) ◽  
pp. 161-166 ◽  
Author(s):  
Antonín Trojánek ◽  
Igor Holub
Keyword(s):  
2013 ◽  
Vol 133 (7) ◽  
pp. 668-675
Author(s):  
Satoshi Sumita ◽  
Yasuo Notohara ◽  
Daisuke Maeda ◽  
Yoshiki Ito

1987 ◽  
Vol 52 (11) ◽  
pp. 2810-2818 ◽  
Author(s):  
Emil Paleček ◽  
František Jelen ◽  
Vladimír Vetterl

The behaviour of electrochemically reducible single-strand polynucleotides (poly(adenylic acid)) and poly(cytidylic acid)) was studied by the differential (derivative) pulse polarography (DPP) and by other methods. Measurements were performed with the help of the dropping mercury electrode under various conditions specified by the pulse width, pulse amplitude, drop time etc. For the faradaic and tensammetric DPP peaks the diagnostic criteria were proposed which make it possible to classify even very small DPP peaks of double helical polynucleotides.


Sensors ◽  
2020 ◽  
Vol 20 (17) ◽  
pp. 4699
Author(s):  
Minming Gu ◽  
Yajie Wei ◽  
Haipeng Pan ◽  
Yujia Ying

This paper presents a new algorithm based on model reference Kalman torque prediction algorithm combined with the sliding root mean square (SRMS). It is necessary to improve the accuracy and reliability of the pinch detection for avoiding collision with the height adjustable desk and accidents on users. Motors need to regulate their position and speed during the operation using different voltage by PWM (Pulse Width Modulation) to meet the requirement of position synchronization. It causes much noise and coupling information in the current sampling signal. Firstly, to analyze the working principle of an electric height adjustable desk control system, a system model is established with consideration of the DC (Direct Current) motor characteristics and the coupling of the system. Secondly, to precisely identify the load situation, a new model reference Kalman perdition method is proposed. The load torque signal is selected as a pinch state variable of the filter by comparing the current signal. Thirdly, to meet the need of the different loads of the electric table, the sliding root means square (SRMS) of the torque is proposed to be the criterion for threshold detection. Finally, to verify the effectiveness of the algorithm, the experiments are carried out in the actual system. Experimental results show that the algorithm proposed in this paper can detect the pinched state accurately under different load conditions.


2013 ◽  
Vol 347-350 ◽  
pp. 1358-1362
Author(s):  
Zi Сheng Li ◽  
Li Xu ◽  
Bao Shan Yuan

The purpose in this paper is the design of the control to switching power supply for small perturbations. By the theoretical analysis and calculation, with the output filter inductor current and filter capacitor voltage switching power supply as two state variables, the conclusion is that control of the output filter inductor current sampling do well in the anti-jamming. The simulation is made for verification. And comparing the results, the current control mode shows a very strong anti-interference ability.


2019 ◽  
Vol 16 (1) ◽  
pp. 18 ◽  
Author(s):  
João Pinto da Costa ◽  
Ana Paço ◽  
Patrícia S. M. Santos ◽  
Armando C. Duarte ◽  
Teresa Rocha-Santos

Environmental contextThere is increasing concern from both the general public and the scientific community about microplastic-related pollution. Despite the alarming and well-documented accumulation of plastics in the marine environment, little attention has been paid to the sources, fate and effects of microplastics in terrestrial settings. We overview the prevalence of microplastics in soils, evaluate their impacts, and appraise the current difficulties in their determinations in terms of sampling, isolation and identification. AbstractThere has been an increasing interest by both the general public and the scientific community in microplastic-related pollution. Owing to their physical and chemical characteristics, these highly ubiquitous contaminants may be ingested by numerous organisms at the base of food-webs. Furthermore, owing to their tendency to adsorb other chemical substances, such as persistent organic pollutants (POPs), these plastic particles can lead to bioaccumulation and bioamplification phenomena, which significantly increases their potential environmental effects. However, most of the current research available is focussed on the prevalence and effects of these materials in water, and, more precisely, in oceans. Although this is understandable, owing to the alarming accumulation of plastics in this environmental compartment, little attention has been paid to the sources, fate and effects of microplastics (MPs) in terrestrial settings. This is further complicated by the current lack of universally accepted methods for the assessment and identification of MPs, not only in liquid, but also in solid matrices. We overview the most current data regarding the presence and prevalence of MPs in soils and evaluate their recognised impacts and potential consequences. We also appraise the current sampling, isolation and identification methodologies and suggest methods that may contribute to the development of standard operating procedures (SOPs) for the sampling and characterisation of these pervasive pollutants in complex matrices, such as soils.


PeerJ ◽  
2020 ◽  
Vol 8 ◽  
pp. e9057 ◽  
Author(s):  
Pedro M. Pedro ◽  
Jandui Amorim ◽  
Martha V.R. Rojas ◽  
Ivy Luizi Sá ◽  
Allan Kardec Ribeiro Galardo ◽  
...  

A practical limitation to many metabarcoding initiatives is that sampling methods tend to collect many non-target taxa, which become “amplicon noise” that can saturate Next Generation Sequencing results and lead to both financial and resource inefficiencies. An available molecular tool that can significantly decrease these non-target amplicons and decrease the need for pre-DNA-extraction sorting of bycatch is the design of PCR primers tailored to the taxa under investigation. We assessed whether the D2 extension segment of the 28S ribosomal operon can limit this shortcoming within the context of mosquito (Culicidae) monitoring. We designed PCR primers that are fully conserved across mosquitos and exclude from amplification most other taxa likely to be collected with current sampling apparatuses. We show that, given enough sequencing depth, D2 is an effective marker for the detection of mosquito sequences within mock genomic DNA pools. As few as 3,050 quality-filtered Illumina reads were able to recover all 17 species in a bulk pool containing as little as 0.2% of constituent DNA from single taxa. We also mixed these mosquito DNA pools with high concentrations of non-Culicidae bycatch DNA and show that the component mosquito species are generally still recoverable and faithful to their original relative frequencies. Finally, we show that there is little loss of fidelity in abundance parameters when pools from degraded DNA samples were sequenced using the D2 primers.


Sign in / Sign up

Export Citation Format

Share Document