A novel retrograde-viewing auxiliary imaging device (Third Eye Retroscope) improves the detection of simulated polyps in anatomic models of the colon

2007 ◽  
Vol 2007 ◽  
pp. 101-102
Author(s):  
J.N. Shah
2007 ◽  
Vol 65 (1) ◽  
pp. 139-144 ◽  
Author(s):  
George Triadafilopoulos ◽  
H. David Watts ◽  
Jack Higgins ◽  
Jacques Van Dam

Author(s):  
D. Van Dyck

An (electron) microscope can be considered as a communication channel that transfers structural information between an object and an observer. In electron microscopy this information is carried by electrons. According to the theory of Shannon the maximal information rate (or capacity) of a communication channel is given by C = B log2 (1 + S/N) bits/sec., where B is the band width, and S and N the average signal power, respectively noise power at the output. We will now apply to study the information transfer in an electron microscope. For simplicity we will assume the object and the image to be onedimensional (the results can straightforwardly be generalized). An imaging device can be characterized by its transfer function, which describes the magnitude with which a spatial frequency g is transferred through the device, n is the noise. Usually, the resolution of the instrument ᑭ is defined from the cut-off 1/ᑭ beyond which no spadal information is transferred.


Author(s):  
N. Mori ◽  
T. Oikawa ◽  
Y. Harada ◽  
J. Miyahara ◽  
T. Matsuo

The Imaging Plate (IP) is a new type imaging device, which was developed for diagnostic x ray imaging. We have reported that usage of the IP for a TEM has many merits; those are high sensitivity, wide dynamic range, and good linearity. However in the previous report the reading system was prototype drum-type-scanner, and IP was also experimentally made, which phosphor layer was 50μm thick with no protective layer. So special care was needed to handle them, and they were used only to make sure the basic characteristics. In this article we report the result of newly developed reading, printing system and high resolution IP for practical use. We mainly discuss the characteristics of the IP here. (Precise performance concerned with the reader and other system are reported in the other article.)Fig.1 shows the schematic cross section of the IP. The IP consists of three parts; protective layer, phosphor layer and support.


2011 ◽  
Vol 44 (1) ◽  
pp. 32
Author(s):  
MICHELE G. SULLIVAN
Keyword(s):  

2021 ◽  
pp. bjophthalmol-2020-318236
Author(s):  
Ralene Sim ◽  
Gemmy Cheung ◽  
Daniel Ting ◽  
Edmund Wong ◽  
Tien Yin Wong ◽  
...  

Background/aimsTo explore if retinal findings are associated with COVID-19 infection.MethodsIn this prospective cross-sectional study, we recruited participants positive for COVID-19 by nasopharyngeal swab, with no medical history. Subjects underwent retinal imaging with an automated imaging device (3D OCT-1 Maestro, Topcon, Tokyo, Japan) to obtain colour fundus photographs (CFP) and optical coherence tomographic (OCT) scans of the macula. Data on personal biodata, medical history and vital signs were collected from electronic medical records.Results108 patients were recruited. Mean age was 36.0±5.4 years. 41 (38.0%) had symptoms of acute respiratory infection (ARI) at presentation. Of 216 eyes, 25 (11.6%) had retinal signs—eight (3.7%) with microhaemorrhages, six (2.8%) with retinal vascular tortuosity and two (0.93%) with cotton wool spots (CWS). 11 eyes (5.1%) had hyper-reflective plaques in the ganglion cell-inner plexiform layer layer on OCT, of which two also had retinal signs visible on CFP (CWS and microhaemorrhage, respectively). There was no significant difference in the prevalence of retinal signs in symptomatic versus asymptomatic patients (12 (15.0%) vs 13 (9.6%), p=0.227). Patients with retinal signs were significantly more likely to have transiently elevated blood pressure than those without (p=0.03).ConclusionOne in nine had retinal microvascular signs on ocular imaging. These signs were observed even in asymptomatic patients with normal vital signs. These retinal microvascular signs may be related to underlying cardiovascular and thrombotic alternations associated with COVID-19 infection.


2020 ◽  
Vol 4 ◽  
pp. 288-297
Author(s):  
Seshiru Nakazawa ◽  
Kimihiro Shimizu ◽  
Natsuko Kawatani ◽  
Kai Obayashi ◽  
Yoichi Ohtaki ◽  
...  
Keyword(s):  

Author(s):  
Daryoush Khoramian ◽  
Soroush Sistani ◽  
Bagher Farhood

Abstract Aim: In radiation therapy, accurate dose distribution in target volume requires accurate treatment setup. The set-up errors are unwanted and inherent in the treatment process. By achieving these errors, a set-up margin (SM) of clinical target volume (CTV) to planning target volume (PTV) can be determined. In the current study, systematic and random set-up errors that occurred during prostate cancer radiotherapy were measured by an electronic portal imaging device (EPID). The obtained values were used to propose the optimum CTV-to-PTV margin in prostate cancer radiotherapy. Materials and methods: A total of 21 patients with prostate cancer treated with external beam radiation therapy (EBRT) participated in this study. A total of 280 portal images were acquired during 12 months. Gross, population systematic (Σ) and random (σ) errors were obtained based on the portal images in Anterior–Posterior (AP), Medio-Lateral (ML) and Superior–Inferior (SI) directions. The SM of CTV to PTV were then calculated and compared by using the formulas presented by the International Commission on Radiation Units and Measurements (ICRU) 62, Stroom and Heijmen and Van Herk et al. Results: The findings showed that the population systematic errors during prostate cancer radiotherapy in AP, ML and SI directions were 1·40, 1·95 and 1·94 mm, respectively. The population random errors in AP, ML and SI directions were 2·09, 1·85 and 2·29 mm, respectively. The SM of CTV to PTV calculated in accordance with the formula of ICRU 62 in AP, ML and SI directions were 2·51, 2·68 and 3·00 mm, respectively. And according to Stroom and Heijmen, formula were 4·23, 5·19 and 5·48 mm, respectively. And Van Herk et al. formula were 4·96, 6·17 and 6·45 mm, respectively. Findings: The SM of CTV to PTV in all directions, based on the formulas of ICRU 62, Stroom and Heijmen and van Herk et al., were equal to 2·73, 4·98 and 5·86 mm, respectively; these values were obtained by averaging the margins in all directions.


Author(s):  
Christian Kern ◽  
Uwe Speck ◽  
Rainer Riesenberg ◽  
Carina Reble ◽  
Georg Khazaka ◽  
...  

2021 ◽  
Vol 0 (0) ◽  
Author(s):  
Tianyi Wang ◽  
Chengxiang Wang ◽  
Kequan Zhao ◽  
Wei Yu ◽  
Min Huang

Abstract Limited-angle computed tomography (CT) reconstruction problem arises in some practical applications due to restrictions in the scanning environment or CT imaging device. Some artifacts will be presented in image reconstructed by conventional analytical algorithms. Although some regularization strategies have been proposed to suppress the artifacts, such as total variation (TV) minimization, there is still distortion in some edge portions of image. Guided image filtering (GIF) has the advantage of smoothing the image as well as preserving the edge. To further improve the image quality and protect the edge of image, we propose a coupling method, that combines ℓ 0 {\ell_{0}} gradient minimization and GIF. An intermediate result obtained by ℓ 0 {\ell_{0}} gradient minimization is regarded as a guidance image of GIF, then GIF is used to filter the result reconstructed by simultaneous algebraic reconstruction technique (SART) with nonnegative constraint. It should be stressed that the guidance image is dynamically updated as the iteration process, which can transfer the edge to the filtered image. Some simulation and real data experiments are used to evaluate the proposed method. Experimental results show that our method owns some advantages in suppressing the artifacts of limited angle CT and in preserving the edge of image.


Sign in / Sign up

Export Citation Format

Share Document