Imaging Device Is 98% Sensitive for Melanoma

2011 ◽  
Vol 44 (1) ◽  
pp. 32
Author(s):  
MICHELE G. SULLIVAN
Keyword(s):  
Imaging Device

Ultimate resolution and information in electron microscopy

1991 ◽  
Vol 49 ◽  
pp. 496-497
Author(s):  
D. Van Dyck
Keyword(s):  
Electron Microscopy ◽  
Electron Microscope ◽  
Transfer Function ◽  
Information Transfer ◽  
Communication Channel ◽  
Structural Information ◽  
Information Rate ◽  
Noise Power ◽  
Signal Power ◽  
Imaging Device

An (electron) microscope can be considered as a communication channel that transfers structural information between an object and an observer. In electron microscopy this information is carried by electrons. According to the theory of Shannon the maximal information rate (or capacity) of a communication channel is given by C = B log2 (1 + S/N) bits/sec., where B is the band width, and S and N the average signal power, respectively noise power at the output. We will now apply to study the information transfer in an electron microscope. For simplicity we will assume the object and the image to be onedimensional (the results can straightforwardly be generalized). An imaging device can be characterized by its transfer function, which describes the magnitude with which a spatial frequency g is transferred through the device, n is the noise. Usually, the resolution of the instrument ᑭ is defined from the cut-off 1/ᑭ beyond which no spadal information is transferred.

Development of imaging plate for a TEM and its characteristics

1989 ◽  
Vol 47 ◽  
pp. 100-101
Author(s):  
N. Mori ◽  
T. Oikawa ◽  
Y. Harada ◽  
J. Miyahara ◽  
T. Matsuo
Keyword(s):  
Dynamic Range ◽  
Protective Layer ◽  
High Sensitivity ◽  
Imaging Plate ◽  
Phosphor Layer ◽  
Imaging Device ◽  
X Ray Imaging ◽  
New Type ◽  
Basic Characteristics ◽  
Reading System

The Imaging Plate (IP) is a new type imaging device, which was developed for diagnostic x ray imaging. We have reported that usage of the IP for a TEM has many merits; those are high sensitivity, wide dynamic range, and good linearity. However in the previous report the reading system was prototype drum-type-scanner, and IP was also experimentally made, which phosphor layer was 50μm thick with no protective layer. So special care was needed to handle them, and they were used only to make sure the basic characteristics. In this article we report the result of newly developed reading, printing system and high resolution IP for practical use. We mainly discuss the characteristics of the IP here. (Precise performance concerned with the reader and other system are reported in the other article.)Fig.1 shows the schematic cross section of the IP. The IP consists of three parts; protective layer, phosphor layer and support.

scholarly journals Retinal microvascular signs in COVID-19

2021 ◽  
pp. bjophthalmol-2020-318236
Author(s):  
Ralene Sim ◽  
Gemmy Cheung ◽  
Daniel Ting ◽  
Edmund Wong ◽  
Tien Yin Wong ◽  
...  
Keyword(s):  
Medical History ◽  
Vital Signs ◽  
Plexiform Layer ◽  
Nasopharyngeal Swab ◽  
Inner Plexiform Layer ◽  
Cross Sectional ◽  
Imaging Device ◽  
Asymptomatic Patients ◽  
Significant Difference ◽  
Retinal Microvascular Signs

Background/aimsTo explore if retinal findings are associated with COVID-19 infection.MethodsIn this prospective cross-sectional study, we recruited participants positive for COVID-19 by nasopharyngeal swab, with no medical history. Subjects underwent retinal imaging with an automated imaging device (3D OCT-1 Maestro, Topcon, Tokyo, Japan) to obtain colour fundus photographs (CFP) and optical coherence tomographic (OCT) scans of the macula. Data on personal biodata, medical history and vital signs were collected from electronic medical records.Results108 patients were recruited. Mean age was 36.0±5.4 years. 41 (38.0%) had symptoms of acute respiratory infection (ARI) at presentation. Of 216 eyes, 25 (11.6%) had retinal signs—eight (3.7%) with microhaemorrhages, six (2.8%) with retinal vascular tortuosity and two (0.93%) with cotton wool spots (CWS). 11 eyes (5.1%) had hyper-reflective plaques in the ganglion cell-inner plexiform layer layer on OCT, of which two also had retinal signs visible on CFP (CWS and microhaemorrhage, respectively). There was no significant difference in the prevalence of retinal signs in symptomatic versus asymptomatic patients (12 (15.0%) vs 13 (9.6%), p=0.227). Patients with retinal signs were significantly more likely to have transiently elevated blood pressure than those without (p=0.03).ConclusionOne in nine had retinal microvascular signs on ocular imaging. These signs were observed even in asymptomatic patients with normal vital signs. These retinal microvascular signs may be related to underlying cardiovascular and thrombotic alternations associated with COVID-19 infection.

Evaluation of set-up errors and estimation of set-up margin during external beam radiation therapy of prostate cancer using electronic portal imaging device (EPID)

2021 ◽  
pp. 1-8
Author(s):  
Daryoush Khoramian ◽  
Soroush Sistani ◽  
Bagher Farhood
Keyword(s):  
Prostate Cancer ◽  
Radiation Therapy ◽  
Target Volume ◽  
External Beam Radiation ◽  
Beam Radiation ◽  
Cancer Radiotherapy ◽  
Imaging Device ◽  
Portal Images ◽  
Set Up ◽  
Prostate Cancer Radiotherapy

Abstract Aim: In radiation therapy, accurate dose distribution in target volume requires accurate treatment setup. The set-up errors are unwanted and inherent in the treatment process. By achieving these errors, a set-up margin (SM) of clinical target volume (CTV) to planning target volume (PTV) can be determined. In the current study, systematic and random set-up errors that occurred during prostate cancer radiotherapy were measured by an electronic portal imaging device (EPID). The obtained values were used to propose the optimum CTV-to-PTV margin in prostate cancer radiotherapy. Materials and methods: A total of 21 patients with prostate cancer treated with external beam radiation therapy (EBRT) participated in this study. A total of 280 portal images were acquired during 12 months. Gross, population systematic (Σ) and random (σ) errors were obtained based on the portal images in Anterior–Posterior (AP), Medio-Lateral (ML) and Superior–Inferior (SI) directions. The SM of CTV to PTV were then calculated and compared by using the formulas presented by the International Commission on Radiation Units and Measurements (ICRU) 62, Stroom and Heijmen and Van Herk et al. Results: The findings showed that the population systematic errors during prostate cancer radiotherapy in AP, ML and SI directions were 1·40, 1·95 and 1·94 mm, respectively. The population random errors in AP, ML and SI directions were 2·09, 1·85 and 2·29 mm, respectively. The SM of CTV to PTV calculated in accordance with the formula of ICRU 62 in AP, ML and SI directions were 2·51, 2·68 and 3·00 mm, respectively. And according to Stroom and Heijmen, formula were 4·23, 5·19 and 5·48 mm, respectively. And Van Herk et al. formula were 4·96, 6·17 and 6·45 mm, respectively. Findings: The SM of CTV to PTV in all directions, based on the formulas of ICRU 62, Stroom and Heijmen and van Herk et al., were equal to 2·73, 4·98 and 5·86 mm, respectively; these values were obtained by averaging the margins in all directions.

scholarly journals Mobile snapshot hyperspectral imaging device for skin evaluation using diffractive optical elements

2021 ◽  
Author(s):  
Christian Kern ◽  
Uwe Speck ◽  
Rainer Riesenberg ◽  
Carina Reble ◽  
Georg Khazaka ◽  
...  
Keyword(s):  
Hyperspectral Imaging ◽  
Diffractive Optical Elements ◽  
Optical Elements ◽  
Imaging Device

Guided image filtering based ℓ0 gradient minimization for limited-angle CT image reconstruction

2021 ◽  
Vol 0 (0) ◽  
Author(s):  
Tianyi Wang ◽  
Chengxiang Wang ◽  
Kequan Zhao ◽  
Wei Yu ◽  
Min Huang
Keyword(s):  
Iteration Process ◽  
Real Data ◽  
Image Filtering ◽  
Reconstruction Technique ◽  
Ct Reconstruction ◽  
Imaging Device ◽  
Practical Applications ◽  
Guided Image Filtering ◽  
Simultaneous Algebraic Reconstruction Technique ◽  
Limited Angle

Abstract Limited-angle computed tomography (CT) reconstruction problem arises in some practical applications due to restrictions in the scanning environment or CT imaging device. Some artifacts will be presented in image reconstructed by conventional analytical algorithms. Although some regularization strategies have been proposed to suppress the artifacts, such as total variation (TV) minimization, there is still distortion in some edge portions of image. Guided image filtering (GIF) has the advantage of smoothing the image as well as preserving the edge. To further improve the image quality and protect the edge of image, we propose a coupling method, that combines ℓ 0 {\ell_{0}} gradient minimization and GIF. An intermediate result obtained by ℓ 0 {\ell_{0}} gradient minimization is regarded as a guidance image of GIF, then GIF is used to filter the result reconstructed by simultaneous algebraic reconstruction technique (SART) with nonnegative constraint. It should be stressed that the guidance image is dynamically updated as the iteration process, which can transfer the edge to the filtered image. Some simulation and real data experiments are used to evaluate the proposed method. Experimental results show that our method owns some advantages in suppressing the artifacts of limited angle CT and in preserving the edge of image.

scholarly journals A New Approach for Design Optimization and Parametric Analysis of Symmetric Compound Parabolic Concentrator for Photovoltaic Applications

2021 ◽  
Vol 13 (9) ◽  
pp. 4606
Author(s):  
Faisal Masood ◽  
Perumal Nallagownden ◽  
Irraivan Elamvazuthi ◽  
Javed Akhter ◽  
Mohammad Azad Alam
Keyword(s):  
Parametric Analysis ◽  
Concentration Ratio ◽  
Synergistic Effects ◽  
Geometric Optimization ◽  
Design Parameters ◽  
Imaging Device ◽  
Compound Parabolic Concentrator ◽  
Photovoltaic Applications ◽  
Half Angle ◽  
The Impact

A compound parabolic concentrator (CPC) is a non-imaging device generally used in PV, thermal, or PV/thermal hybrid systems for the concentration of solar radiation on the target surface. This paper presents the geometric design, statistical modeling, parametric analysis, and geometric optimization of a two-dimensional low concentration symmetric compound parabolic concentrator for potential use in building-integrated and rooftop photovoltaic applications. The CPC was initially designed for a concentration ratio of “2×” and an acceptance half-angle of 30°. A MATLAB code was developed in house to provoke the CPC reflector’s profile. The height, aperture width, and concentration ratios were computed for different acceptance half-angles and receiver widths. The interdependence of optical concentration ratio and acceptance half-angle was demonstrated for a wide span of acceptance half-angles. The impact of the truncation ratio on the geometric parameters was investigated to identify the optimum truncation position. The profile of truncated CPC for different truncation positions was compared with full CPC. A detailed statistical analysis was performed to analyze the synergistic effects of independent design parameters on the responses using the response surface modeling approach. A set of optimized design parameters was obtained by establishing specified optimization criteria. A 50% truncated CPC with an acceptance half-angle of 21.58° and receiver width of 193.98 mm resulted in optimum geometric dimensions.

scholarly journals Density Distribution Maps: A Novel Tool for Subcellular Distribution Analysis and Quantitative Biomedical Imaging

Sensors ◽  
2021 ◽  
Vol 21 (3) ◽  
pp. 1009
Author(s):  
Ilaria De Santis ◽  
Michele Zanoni ◽  
Chiara Arienti ◽  
Alessandro Bevilacqua ◽  
Anna Tesei
Keyword(s):  
Density Distribution ◽  
Large Scale ◽  
Super Resolution ◽  
Spatial Location ◽  
Relative Displacement ◽  
Distribution Analysis ◽  
Laboratory Equipment ◽  
Imaging Device ◽  
Distribution Maps ◽  
Super Resolution Microscopy

Subcellular spatial location is an essential descriptor of molecules biological function. Presently, super-resolution microscopy techniques enable quantification of subcellular objects distribution in fluorescence images, but they rely on instrumentation, tools and expertise not constituting a default for most of laboratories. We propose a method that allows resolving subcellular structures location by reinforcing each single pixel position with the information from surroundings. Although designed for entry-level laboratory equipment with common resolution powers, our method is independent from imaging device resolution, and thus can benefit also super-resolution microscopy. The approach permits to generate density distribution maps (DDMs) informative of both objects’ absolute location and self-relative displacement, thus practically reducing location uncertainty and increasing the accuracy of signal mapping. This work proves the capability of the DDMs to: (a) improve the informativeness of spatial distributions; (b) empower subcellular molecules distributions analysis; (c) extend their applicability beyond mere spatial object mapping. Finally, the possibility of enhancing or even disclosing latent distributions can concretely speed-up routine, large-scale and follow-up experiments, besides representing a benefit for all spatial distribution studies, independently of the image acquisition resolution. DDMaker, a Software endowed with a user-friendly Graphical User Interface (GUI), is also provided to support users in DDMs creation.

Sign in / Sign up

Export Citation Format

Share Document