Measurement of alkalinity in concrete by a simple procedure, to investigate transport of alkaline material from the concrete slab to a self-levelling screed

2002 ◽  
Vol 16 (8) ◽  
pp. 535-542 ◽  
Author(s):  
Folke Björk ◽  
Carl Axel Eriksson
1995 ◽  
Vol 73 (03) ◽  
pp. 535-542 ◽  
Author(s):  
N Crawford ◽  
A Chajara ◽  
G Pfliegler ◽  
B EI Gamal ◽  
L Brewer ◽  
...  

SummaryDrugs can be electro-encapsulated within platelets and targeted to damaged blood vessels by exploiting the platelet’s natural haemostatic properties to adhere to collagen and other vessel wall constituents revealed by injury. A rat aorta balloon angioplasty model has been used to study the effect on platelet deposition of giving iloprost loaded platelets i.v. during the balloon injury. After labelling the circulating platelets with 111-Indium before balloon injury, time course studies showed maximum platelet deposition on the injured aorta occurred at about 1 h post-injury and the deposition remained stable over the next 2-3 h. When iloprost-loaded platelets were given i.v. during injury and the circulating platelet pool labelled with 111-Indium 30 min later, platelet deposition, measured at 2 h postinjury, was substantially and significantly reduced compared with control platelet treatment. Some antiproliferative effects of iloprost-loaded platelets given i.v. during injury have also been observed. Whereas the incorporation of [3H]-thymidine into aorta intima-media DNA at 3 days post injury was 62-fold higher in balloon injured rats than in control sham operated rats, thymidine incorporation into intima/media of rats which had received iloprost loaded platelets during injury was reduced as compared with rats subjected only to the injury procedure. The reduction was only of near significance, however, but at 14 days after injury the total DNA content of the aorta intima/media of rats given iloprost loaded platelets during injury was significantly reduced. Although iloprost loaded platelets can clearly inhibit excessive platelet deposition, other encapsulated agents may have greater anti-proliferative effects. These studies have shown that drug loaded platelets can be targeted to injured arteries, where they may be retained as depots for local release. We believe this novel drug delivery protocol may have therapeutic potential in reducing the incidence of occlusion and restenosis after angioplasty and thrombolysis treatment. Electro-encapsulation of drugs into platelets is a simple procedure and, using autologous and fully biocompatible and biodegradable platelets as delivery vehicles, might overcome some of the immunological and toxicological problems which have been encountered with other delivery vectors such as liposomes, microbeads, synthetic microcapsules and antibodies.


BioResources ◽  
2020 ◽  
Vol 15 (3) ◽  
pp. 7079-7099
Author(s):  
Jianying Chen ◽  
Guojing He ◽  
Xiaodong (Alice) Wang ◽  
Jiejun Wang ◽  
Jin Yi ◽  
...  

Timber-concrete composite beams are a new type of structural element that is environmentally friendly. The structural efficiency of this kind of beam highly depends on the stiffness of the interlayer connection. The structural efficiency of the composite was evaluated by experimental and theoretical investigations performed on the relative horizontal slip and vertical uplift along the interlayer between composite’s timber and concrete slab. Differential equations were established based on a theoretical analysis of combination effects of interlayer slip and vertical uplift, by using deformation theory of elastics. Subsequently, the differential equations were solved and the magnitude of uplift force at the interlayer was obtained. It was concluded that the theoretical calculations were in good agreement with the results of experimentation.


2018 ◽  
Vol 15 (1) ◽  
pp. 15
Author(s):  
AMIR SYAFIQ SAMSUDIN ◽  
MOHD HISBANY MOHD HASHIM ◽  
SITI HAWA HAMZAH ◽  
AFIDAH ABU BAKAR

Nowadays, demands in the application of fibre in concrete increase gradually as an engineering material. Rapid cost increment of material causes the increase in demand of new technology that provides safe, efficient and economical design for the present and future application. The introduction of ribbed slab reduces concrete materials and thus the cost, but the strength of the structure also reduces due to the reducing of material. Steel fibre reinforced concrete (SFRC) has the ability to maintain a part of its tensile strength prior to crack in order to resist more loading compared to conventional concrete. Meanwhile, the ribbed slab can help in material reduction. This research investigated on the bending strength of 2-ribbed and 3-ribbed concrete slab with steel fibre reinforcement under static loading with a span of 1500 mm and 1000 mm x 75 mm in cross section. An amount of 40 kg/m steel fibre of all total concrete volume was used as reinforcement instead of conventional bars with concrete grade 30 N/mm2. The slab was tested under three-point bending. Load versus deflection curve was plotted to illustrate the result and to compare the deflection between control and ribbed slab. This research shows that SFRC Ribbed Slab capable to withstand the same amount of load as normal slab structure, although the concrete volume reduces up to 20%.


2018 ◽  
Vol 14 (1) ◽  
pp. 6057-6061 ◽  
Author(s):  
Padmanaban M S ◽  
J Sreerambabu

A piled raft foundation consists of a thick concrete slab reinforced with steel which covers the entire contact area of the structure, in which the raft is supported by a group of piles or a number of individual piles. Bending moment on raft, differential and average settlement, pile and raft geometries are the influencing parameters of the piled raft foundation system. In this paper, a detailed review has been carried out on the issues on the raft foundation design. Also, the existing design procedure was explained.


2019 ◽  
Author(s):  
Kristina Eriksen ◽  
Bjarne Nielsen ◽  
Michael Pittelkow

<p>We present a simple procedure to make an augmented reality app to visualize any 3D chemical model. The molecular structure may be based on data from crystallographic data or from computer modelling. This guide is made in such a way, that no programming skills are needed and the procedure uses free software and is a way to visualize 3D structures that are normally difficult to comprehend in the 2D space of paper. The process can be applied to make 3D representation of any 2D object, and we envisage the app to be useful when visualizing simple stereochemical problems, when presenting a complex 3D structure on a poster presentation or even in audio-visual presentations. The method works for all molecules including small molecules, supramolecular structures, MOFs and biomacromolecules.</p>


Sign in / Sign up

Export Citation Format

Share Document