Repellency of Pyrethrum and Lethane Sprays to Mosquitos

1946 ◽  
Vol 37 (2) ◽  
pp. 163-172 ◽  
Author(s):  
C. R. Ribbands

(1) Spraying of huts with 0·1 per cent. pyrethrum in kerosene, at the rate of 25 c.c. per 1,000 cubic feet, deterred 90 per cent. of A. minimus from entry on the following night. The repellent effect persisted in diminished degree for at least four days.(2) A rather larger quantity of pyrethrum, sprayed in a Freon aerosol, produced a similar but somewhat less marked effect.(3) The repellent effects of Lethane 384 in kerosene were much less marked, and not discernible on the second night.(4) Different species varied greatly in their sensitivity to the repellents.(5) Two types of repellent effects were indicated. Repellent effects proper were the most important, and males were more sensitive to these than females of the same species. There was also a masking effect, to which anthropophilic females were sensitive, which resulted from obscuring of attractive human scents by the chemical odours.

2018 ◽  
Vol 8 (2) ◽  
pp. 334-336
Author(s):  
A. V. Matsyura

Here we presented the preliminary results of hawk kite usage against the feral pigeons in some grain processing factory. We studied the temporal and spatial patterns of repellent effect and bird behavior. We suggested the feral pigeons gradually increase the level of tolerance towards the hawk kite if no additional repellent measures were undertaken. Moreover, even initially the feral pigeons demonstrate higher tolerance towards the hawk kite compared to the Rooks or Hooded Crows.


2017 ◽  
Vol 76 (8) ◽  
pp. 685-708 ◽  
Author(s):  
O. I. Ieremeiev ◽  
N. N. Ponomarenko ◽  
V. V. Lukin ◽  
J. T. Astola ◽  
Karen O. Egiazarian
Keyword(s):  

1987 ◽  
Vol 49 (4) ◽  
pp. 727-729
Author(s):  
YUKIYA MARUGUCHI
Keyword(s):  

1993 ◽  
Author(s):  
Milind Tambe ◽  
Paul S. Rosenbloom
Keyword(s):  

2020 ◽  
Vol 14 (3) ◽  
pp. 216-226
Author(s):  
Priyanka Borah ◽  
Venkata S.K. Mattaparthi

Background: Aggregation of misfolded proteins under stress conditions in the cell might lead to several neurodegenerative disorders. Amyloid-beta (Aβ1-42) peptide, the causative agent of Alzheimer’s disease, has the propensity to fold into β-sheets under stress, forming aggregated amyloid plaques. This is influenced by factors such as pH, temperature, metal ions, mutation of residues, and ionic strength of the solution. There are several studies that have highlighted the importance of ionic strength in affecting the folding and aggregation propensity of Aβ1-42 peptide. Objective: To understand the effect of ionic strength of the solution on the aggregation propensity of Aβ1-42 peptide, using computational approaches. Materials and Methods: In this study, Molecular Dynamics (MD) simulations were performed on Aβ1-42 peptide monomer placed in (i) 0 M, (ii) 0.15 M, and (iii) 0.30 M concentration of NaCl solution. To prepare the input files for the MD simulations, we have used the Amberff99SB force field. The conformational dynamics of Aβ1-42 peptide monomer in different ionic strengths of the solutions were illustrated from the analysis of the corresponding MD trajectory using the CPPtraj tool. Results: From the MD trajectory analysis, we observe that with an increase in the ionic strength of the solution, Aβ1-42 peptide monomer shows a lesser tendency to undergo aggregation. From RMSD and SASA analysis, we noticed that Aβ1-42 peptide monomer undergoes a rapid change in conformation with an increase in the ionic strength of the solution. In addition, from the radius of gyration (Rg) analysis, we observed Aβ1-42 peptide monomer to be more compact at moderate ionic strength of the solution. Aβ1-42 peptide was also found to hold its helical secondary structure at moderate and higher ionic strengths of the solution. The diffusion coefficient of Aβ1-42 peptide monomer was also found to vary with the ionic strength of the solution. We observed a relatively higher diffusion coefficient value for Aβ1-42 peptide at moderate ionic strength of the solution. Conclusion: Our findings from this computational study highlight the marked effect of ionic strength of the solution on the conformational dynamics and aggregation propensity of Aβ1-42 peptide monomer.


2019 ◽  
pp. 17-33
Author(s):  
Joel Edney ◽  
Geoffrey Loveman ◽  
Fiona Seddon ◽  
Julian Thacker ◽  
Karen Jurd ◽  
...  

Crew survival in a distressed submarine (DISSUB) scenario may be enhanced by the knowledge of the risks of different types of decompression sickness (DCS) should the crew attempt tower escape. Four models were generated through calibration against DCS outcome data from 3,919 pressure exposures, each for the prediction of one of four categories of DCS: neurological, limb pain, respiratory and cutaneous. The calibration data contained details of human, goat, sheep and pig exposures to raised pressure while breathing air or oxygen/nitrogen mixtures. No exposures had substantial staged decompression or cases of suspected pulmonary barotrauma. DCS risk was scaled between species and with body mass. A parameter was introduced to account for the possibility of the occurrence of some symptom types masking others. The calibrated models were used to estimate likelihood of DCS occurrence for each symptom category following submarine tower escape. Escape depth was found to have a marked effect only on predicted rates of neurological DCS. Saturation at raised internal DISSUB pressure prior to escape was found to affect predicted rates of all symptom types. The iso-risk curves presented are offered as guidance to submarine crews and rescue forces in preparation for, or in the event of, a DISSUB scenario.


Minerals ◽  
2021 ◽  
Vol 11 (2) ◽  
pp. 125
Author(s):  
Mariola Jabłońska ◽  
Janusz Janeczek ◽  
Beata Smieja-Król

For the first time, it is shown that inhaled ambient air-dust particles settled in the human lower respiratory tract induce lung calcification. Chemical and mineral compositions of pulmonary calcium precipitates in the lung right lower-lobe (RLL) tissues of 12 individuals who lived in the Upper Silesia conurbation in Poland and who had died from causes not related to a lung disorder were determined by transmission and scanning electron microscopy. Whereas calcium salts in lungs are usually reported as phosphates, calcium salts precipitated in the studied RLL tissue were almost exclusively carbonates, specifically Mg-calcite and calcite. These constituted 37% of the 1652 mineral particles examined. Mg-calcite predominated in the submicrometer size range, with a MgCO3 content up to 50 mol %. Magnesium plays a significant role in lung mineralization, a fact so far overlooked. The calcium phosphate (hydroxyapatite) content in the studied RLL tissue was negligible. The predominance of carbonates is explained by the increased CO2 fugacity in the RLL. Carbonates enveloped inhaled mineral-dust particles, including uranium-bearing oxides, quartz, aluminosilicates, and metal sulfides. Three possible pathways for the carbonates precipitation on the dust particles are postulated: (1) precipitation of amorphous calcium carbonate (ACC), followed by its transformation to calcite; (2) precipitation of Mg-ACC, followed by its transformation to Mg-calcite; (3) precipitation of Mg-free ACC, causing a localized relative enrichment in Mg ions and subsequent heterogeneous nucleation and crystal growth of Mg-calcite. The actual number of inhaled dust particles may be significantly greater than was observed because of the masking effect of the carbonate coatings. There is no simple correlation between smoking habit and lung calcification.


2020 ◽  
Vol 4 (1) ◽  
pp. 46-63
Author(s):  
Hanan ElNaghy ◽  
Leo Dorst

AbstractWhen fitting archaeological artifacts, one would like to have a representation that simplifies fragments while preserving their complementarity. In this paper, we propose to employ the scale-spaces of mathematical morphology to hierarchically simplify potentially fitting fracture surfaces. We study the masking effect when morphological operations are applied to selected subsets of objects. Since fitting locally depends on the complementarity of fractures only, we introduce ‘Boundary Morphology’ on surfaces rather than volumes. Moreover, demonstrating the Lipschitz nature of the terracotta fractures informs our novel extrusion method to compute both closing and opening operations simultaneously. We also show that in this proposed representation the effects of abrasion and uncertainty are naturally bounded, justifying the morphological approach. This work is an extension of our contribution earlier published in the proceedings of ISMM2019 [10].


2014 ◽  
Vol 118 (1203) ◽  
pp. 523-539 ◽  
Author(s):  
R. Zardashti ◽  
A. A. Nikkhah ◽  
M. J. Yazdanpanah

AbstractThis paper focuses on the trajectory planning for a UAV on a low altitude terrain following/threat avoidance (TF/TA) mission. Using a grid-based approximated discretisation scheme, the continuous constrained optimisation problem into a search problem is transformed over a finite network. A variant of the Minimum Cost Network Flow (MCNF) to this problem is then applied. Based on using the Digital Terrain Elevation Data (DTED) and discrete dynamic equations of motion, the four-dimensional (4D) trajectory (three spatial and one time dimensions) from a starting point to an end point is obtained by minimising a cost function subject to dynamic and mission constraints of the UAV. For each arc in the grid, a cost function is considered as the combination of the arc length, fuel consumption and flight time. The proposed algorithm which considers dynamic and altitude constraints of the UAV explicitly is then used to obtain the feasible trajectory. The resultant trajectory can increase the survivability of the UAV using the threat region avoidance and the terrain masking effect. After obtaining the feasible trajectory, an improved algorithm is proposed to smooth the trajectory. The numeric results are presented to verify the capability of the proposed approach to generate admissible trajectory in minimum possible time in comparison to the previous works.


Sign in / Sign up

Export Citation Format

Share Document