Narrowband Optical Coupler Using Fano Interference in First Order Diffraction

ACS Photonics ◽  
2021 ◽  
Author(s):  
Giorgio Quaranta ◽  
Fabian Lütolf ◽  
Olivier J. F. Martin ◽  
Benjamin Gallinet
2007 ◽  
Vol 364-366 ◽  
pp. 719-723
Author(s):  
Quan Liu ◽  
Jian Hong Wu ◽  
Ling Ling Fang ◽  
Chao Ming Li

A fused silica phase mask with the period of 1069nm, and ruled area 50×50mm2 has been fabricated by a new technique, which combines holographic-ion beam etching and reactive ion beam etching. This involves several steps: coating of substrates with controlled thickness of photoresist, formation of a grating mask by holograph interference exposure and development, and finally transferring etching of this mask into the fused silica substrate to form a permanent phase mask. Experimental measurements have shown that the zero order diffraction efficiency is less than 4% and the plus and minus first-order diffraction efficiency is more than 35%. Theoretical analysis has shown that these phase masks can be used for fabricating UV written Fiber Bragg Gratings.


Polymers ◽  
2020 ◽  
Vol 12 (9) ◽  
pp. 1929 ◽  
Author(s):  
Shuan-Yu Huang ◽  
Bing-Yau Huang ◽  
Chi-Chung Kang ◽  
Chie-Tong Kuo

This work demonstrates an electrically-tunable nematic liquid crystal (NLC) diffraction grating with a periodic electrode structure, and discusses the polarization properties of its diffraction. The efficiency of the first-order diffraction can be gradually controlled by applying external electric fields cross the NLC, and the maximum diffraction efficiency of the first-order diffraction that can be obtained is around 12.5% under the applied voltage of 5.0 V. In addition to the applied electric field, the efficiency of the first-order diffraction can also vary by changing the polarized state of the incident beam. Antisymmetric polarization states with symmetrical intensities in the diffractions corresponding to the +1 and −1 order diffraction signals are also demonstrated.


2004 ◽  
Vol 126 (2) ◽  
pp. 147-155 ◽  
Author(s):  
Bert Sweetman

Two new methods are proposed to predict airgap demand. Airgap demand is the maximum expected increase in the water surface elevation caused incident waves interacting with an offshore structure. The first new method enables inclusion of some second-order effects, though it is based on only first-order diffraction results. The method is simple enough to be practical for use as a hand-calculation in the early stages of design. Two existing methods of predicting airgap demand based on first-order diffraction are also briefly presented and results from the three methods are compared with model test results. All three methods yield results superior to those based on conventional post-processing of first-order diffraction results, and comparable to optimal post-processing of second-order diffraction results. A second new method is also presented; it combines extreme value theory with statistical regression to predict extreme airgap events using model test data. Estimates of extreme airgap events based on this method are found to be more reliable than estimates based on extreme observations from a single model test. This second new method is suitable for use in the final stages of design.


Crystals ◽  
2019 ◽  
Vol 9 (10) ◽  
pp. 542 ◽  
Author(s):  
Vladimir A. Belyakov ◽  
Sergei V. Semenov

Most studies of the localized edge (EM) and defect (DM) modes in cholesteric liquid crystals (CLC) are related to the localized modes in a collinear geometry, i.e., for the case of light propagation along the spiral axis. It is due to the fact that all photonic effects in CLC are most pronounced just for a collinear geometry, and also partially due to the fact that a simple exact analytic solution of the Maxwell equations is known for a collinear geometry, whereas for a non-collinear geometry, there is no exact analytic solution of the Maxwell equations and a theoretical description of the experimental data becomes more complicated. It is why in papers related to the localized modes in CLC for a non-collinear geometry and observing phenomena similar to the case of a collinear geometry, their interpretation is not so clear. Recently, an analytical theory of the conical modes (CEM) related to a first order of light diffraction was developed in the framework of the two-wave dynamic diffraction theory approximation ensuring the results accuracy of order of δ, the CLC dielectric anisotropy. The corresponding experimental results are reasonably well described by this theory, however, some numerical problems related to the CEM polarization properties remain. In the present paper, an analytical theory of a second order diffraction CEM is presented with results that are qualitatively similar to the results for a first order diffraction order CEM and have the accuracy of order of δ2, i.e., practically exact. In particular, second order diffraction CEM polarization properties are related to the linear σ and π polarizations. The known experimental results on the CEM are discussed and optimal conditions for the second order diffraction CEM observations are formulated.


2019 ◽  
Vol 9 (20) ◽  
pp. 4390
Author(s):  
Yan Wang ◽  
Hao Wu ◽  
Chao Chen ◽  
Yinli Zhou ◽  
Yubing Wang ◽  
...  

In this paper, a widely tunable external cavity diode laser (ECDL) with an ultra-high side mode suppression ratio (SMSR) was fabricated. Three configurations were constructed to investigate the relationship between the grating features and the SMSR. When a 1200 grooves/mm grating with a first order diffraction efficiency of 91% is utilized in the external-cavity laser system, a maximum SMSR of 65 dB can be achieved. In addition, the tunable range reaches 209.9 nm. The results show that the laser performance can be improved by proper high grating groove number and first-order diffraction efficiency.


Sign in / Sign up

Export Citation Format

Share Document