Hygroscopicity of Organic Aerosols Linked to Formation Mechanisms

2021 ◽  
Vol 48 (4) ◽  
Author(s):  
Jieyao Liu ◽  
Fang Zhang ◽  
Weiqi Xu ◽  
Yele Sun ◽  
Lu Chen ◽  
...  
Atmosphere ◽  
2021 ◽  
Vol 12 (7) ◽  
pp. 854
Author(s):  
Shiwei Zhang ◽  
Hao Tang ◽  
Qing Li ◽  
Liang Li ◽  
Chaojun Ge ◽  
...  

To investigate the concentration, seasonal variation, and sources of secondary organic aerosols (SOAs) in the inland areas of central China, 244 seasonal PM2.5 samples were collected from January to October 2019 at one urban site and one suburban site simultaneously in Bengbu of Anhui Province. Concentrations of organic carbon (OC), elemental carbon (EC), water-soluble organic carbon (WSOC), and typical organic tracers, including saccharides, tracers of SOAs from isoprene, terpenes, and toluene, were measured. Results showed that Bengbu has high pollution levels of organic aerosols, with annual average OC concentrations of about 9.5 μg m−3. About 60% of the OC in PM2.5 in Bengbu was water soluble. Different seasonal trends were found for the SOA tracers of isoprene, monoterpene, seisquiterpene, and toluene. The highest seasonal average concentration of the isoprene SOA tracers was observed in summer and of the monoterpene and seisquiterpene SOA tracers in autumn. A stronger correlation was found between the 2-methylglyceric acid-to-2-methyltetrol ratio (MGA/MTL) and ambient temperature than that between MGA/MTLs and NOX concentration, suggesting that temperature has an important impact on the MGA/MTL ratio besides NOX concentration. The OC/EC-based method, WSOC-based method, tracer yield method, and positive matrix factorization (PMF)-based method were used to estimate the concentration and sources of secondary organic carbon (SOC), and the PMF-based method was believed to be able to give reasonable results. SOC was the main contributor of WSOC in PM2.5 in Bengbu, while biomass burning made an important contribution to WSOC in autumn and winter (~40%). SOC was mainly associated with SOA tracers in summer and mainly associated with secondary ions in spring and winter, suggesting different formation mechanisms in different seasons.


2021 ◽  
Vol 21 (4) ◽  
pp. 2959-2980
Author(s):  
Yao Wang ◽  
Yue Zhao ◽  
Yuchen Wang ◽  
Jian-Zhen Yu ◽  
Jingyuan Shao ◽  
...  

Abstract. Organosulfates (OSs) are ubiquitous in the atmosphere and serve as important tracers for secondary organic aerosols (SOAs). Despite intense research over the years, the abundance, origin, and formation mechanisms of OSs in ambient aerosols, particularly in regions with severe anthropogenic pollution, are still not well understood. In this study, we collected filter samples of ambient fine particulate matter (PM2.5) over four seasons in both 2015–2016 and 2018–2019 at an urban site in Shanghai, China, and comprehensively characterized the OS species in these PM2.5 samples using an ultra-performance liquid chromatography quadrupole time-of-flight mass spectrometer equipped with an electrospray ionization (ESI) source (UPLC-ESI-QToFMS). Overall, we find that while the concentration of organic aerosols (OAs) decreased by 29 % in 2018–2019 compared to that in 2015–2016, mainly as a result of the reduction of anthropogenic pollutant emissions in eastern China, the annually averaged concentrations of 35 quantified OSs were similar in both years (65.5 ± 77.5 ng m−3, 0.57 % ± 0.56 % of OA in 2015–2016 vs. 59.4 ± 79.7 ng m−3, 0.66 % ± 0.56 % of OA in 2018–2019), suggesting an increased contribution of SOAs to OAs in 2018–2019 compared to 2015–2016. Isoprene- and monoterpene-derived OSs were the two most abundant OS families, on average, accounting for 36.3 % and 31.0 % of the quantified OS concentrations, respectively, during both sampling years, suggesting an important contribution of biogenic emissions to the production of OSs and SOAs in Shanghai. The abundance of biogenic OSs, particularly those arising from isoprene, exhibited strong seasonality (peaked in summer) but no significant interannual variability. In contrast, the quantified anthropogenic OSs had little seasonal variability and declined in 2018–2019 compared with those in 2015–2016. The C2 and C3 OS species that have both biogenic and anthropogenic origins contributed, on average, 19.0 % of the quantified OSs, with C2H3O6S−, C3H5O5S−, and C3H5O6S− being the most abundant species, together accounting for 76 % of the C2 and C3 OS concentrations in 2015–2016 and 2018–2019. 2-Methyltetrol sulfate (2-MTS, C5H11O7S−) and monoterpene-derived C10H16NO7S− were the most abundant OSs and nitrooxy OSs in summer, on average, contributing 31 % and 5 % of the quantified OSs, respectively, during the summertime of the sampling years. The substantially larger concentration ratio of 2-MTS to 2-methylglyceric acid sulfate (2-MAS, C4H7O7S−) in summer (6.8–7.8) compared to the other seasons (0.31–0.78) implies that low-NOx oxidation pathways played a dominant role in isoprene-derived SOA formation in summer, while high-NOx reaction pathways were more important in other seasons. We further find that the production of OSs was largely controlled by the level of Ox (Ox= O3+ NO2), namely the photochemistry of OS precursors, particularly in summer, though sulfate concentration, aerosol acidity, and aerosol liquid water content (ALWC) that could affect the heterogeneous chemistry of reactive intermediates leading to OS formation also played a role. Our study provides valuable insights into the characteristics and mechanisms of OS formation in a typical Chinese megacity and implies that the mitigation of Ox pollution can effectively reduce the production of OSs and SOAs in eastern China.


Author(s):  
B. Cunningham ◽  
D.G. Ast

There have Been a number of studies of low-angle, θ < 4°, [10] tilt boundaries in the diamond lattice. Dislocations with Burgers vectors a/2<110>, a/2<112>, a<111> and a<001> have been reported in melt-grown bicrystals of germanium, and dislocations with Burgers vectors a<001> and a/2<112> have been reported in hot-pressed bicrystals of silicon. Most of the dislocations were found to be dissociated, the dissociation widths being dependent on the tilt angle. Possible dissociation schemes and formation mechanisms for the a<001> and a<111> dislocations from the interaction of lattice dislocations have recently been given.The present study reports on the dislocation structure of a 10° [10] tilt boundary in chemically vapor deposited silicon. The dislocations in the boundary were spaced about 1-3nm apart, making them difficult to resolve by conventional diffraction contrast techniques. The dislocation structure was therefore studied by the lattice-fringe imaging technique.


Author(s):  
Eal H. Lee ◽  
Helmut Poppa

The formation of thin films of gold on mica has been studied in ultra-high vacuum (5xl0-10 torr) . The mica substrates were heat-treated for 24 hours at 375°C, cleaved, and annealed for 15 minutes at the deposition temperature of 300°C prior to deposition. An impingement flux of 3x1013 atoms cm-2 sec-1 was used. These conditions were found to give high number densities of multiple twin particles and are based on a systematic series of nucleation experiments described elsewhere. Individual deposits of varying deposition time were made and examined by bright and dark field TEM after "cleavage preparation" of highly transparent specimens. In the early stages of growth, the films generally consist of small particles which are either single crystals or multiply twinned; a strong preference for multiply twinned particles was found whenever the particle number densities were high. Fig. 1 shows the stable cluster density ns and the variation with deposition time of multiple twin particle and single crystal particle densities, respectively. Corresponding micrographs and diffraction patterns are shown in Fig. 2.


Author(s):  
Д.А. Юрченко ◽  
М.Е. Миньженкова ◽  
Е.Л. Дадали ◽  
Н.В. Шилова

Синдром инвертированной дупликации короткого плеча хромосомы 8 со смежной терминальной делециенй (inv dup del(8p), ORPHA 96092) - редкая хромосомная аномалия (ХА) с частотой 1/10000-1/30000 живорожденных. В статье представлены клинические и молекулярно-цитогенетические характеристики двух неродственных пациентов с синдромом inv dup del(8p) и уточнены механизмы формирования хромосомного дисбаланса. Inverted duplication deletion 8p syndrome (inv dup del(8p), ORPHA 96092) is a rare chromosomal abnormality with a frequency of 1:10,000 - 30,000 newborns. Clinical manifestations of this syndrome include mental retardation, facial anomalies, hypoplasia/agenesis of corpus callosum, scoliosis and/or kyphosis, hypotonia, congenital heart defects. The article presents the clinical and molecular cytogenetic characteristics of two patients with inv dup del (8p) syndrome and clarifies the formation mechanisms.


2019 ◽  
Author(s):  
James Ewen ◽  
Carlos Ayestaran Latorre ◽  
Arash Khajeh ◽  
Joshua Moore ◽  
Joseph Remias ◽  
...  

<p>Phosphate esters have a wide range of industrial applications, for example in tribology where they are used as vapour phase lubricants and antiwear additives. To rationally design phosphate esters with improved tribological performance, an atomic-level understanding of their film formation mechanisms is required. One important aspect is the thermal decomposition of phosphate esters on steel surfaces, since this initiates film formation. In this study, ReaxFF molecular dynamics simulations are used to study the thermal decomposition of phosphate esters with different substituents on several ferrous surfaces. On Fe<sub>3</sub>O<sub>4</sub>(001) and α-Fe(110), chemisorption interactions between the phosphate esters and the surfaces occur even at room temperature, and the number of molecule-surface bonds increases as the temperature is increased from 300 to 1000 K. Conversely, on hydroxylated, amorphous Fe<sub>3</sub>O<sub>4</sub>, most of the molecules are physisorbed, even at high temperature. Thermal decomposition rates were much higher on Fe<sub>3</sub>O<sub>4</sub>(001) and particularly α-Fe(110) compared to hydroxylated, amorphous Fe<sub>3</sub>O<sub>4</sub>. This suggests that water passivates ferrous surfaces and inhibits phosphate ester chemisorption, decomposition, and ultimately film formation. On Fe<sub>3</sub>O<sub>4</sub>(001), thermal decomposition proceeds mainly through C-O cleavage (to form surface alkyl and aryl groups) and C-H cleavage (to form surface hydroxyls). The onset temperature for C-O cleavage on Fe<sub>3</sub>O<sub>4</sub>(001) increases in the order: tertiary alkyl < secondary alkyl < primary linear alkyl ≈ primary branched alkyl < aryl. This order is in agreement with experimental observations for the thermal stability of antiwear additives with similar substituents. The results highlight surface and substituent effects on the thermal decomposition of phosphate esters which should be helpful for the design of new molecules with improved performance.</p>


Sign in / Sign up

Export Citation Format

Share Document