Quantum dots in photocatalytic applications: efficiently enhancing visible light photocatalytic activity by integrating CdO quantum dots as sensitizers

2017 ◽  
Vol 19 (36) ◽  
pp. 24915-24927 ◽  
Author(s):  
A. H. Reshak

The amalgamation of a wide optical band gap photocatalyst with visible-light-active CdO quantum dots (QDs) as sensitizers is one of the most efficient ways to improve photocatalytic performance under visible light irradiation.

RSC Advances ◽  
2015 ◽  
Vol 5 (112) ◽  
pp. 92033-92041 ◽  
Author(s):  
Xin Liu ◽  
Ailing Jin ◽  
Yushuai Jia ◽  
Junzhe Jiang ◽  
Na Hu ◽  
...  

An efficient composite photocatalyst fabricated by dispersing ultrafine Fe2O3 nanocrystals onto g-C3N4 nanosheets via a facile deposition-precipitation method shows significantly enhanced photocatalytic performance under visible light irradiation.


2016 ◽  
Vol 45 (35) ◽  
pp. 13944-13950 ◽  
Author(s):  
Gang Yan ◽  
Hongfei Shi ◽  
Huaqiao Tan ◽  
Wanbin Zhu ◽  
Yonghui Wang ◽  
...  

A new 2D sheet composite Bi2OxS3−x/Nb6O17 has been prepared, which shows good visible light photocatalytic performance for the degradation of methyl orange.


RSC Advances ◽  
2016 ◽  
Vol 6 (48) ◽  
pp. 42581-42588 ◽  
Author(s):  
Zahra Hosseinpour ◽  
Sara Hosseinpour ◽  
Malik Maaza ◽  
Alice Scarpellini

Co2+ and Ho3+ doped CuS nanostructures have been synthesized by a hydrothermal method. The nature of dopants influence the morphology, photocatalytic performance and the band gap values.


RSC Advances ◽  
2016 ◽  
Vol 6 (11) ◽  
pp. 8651-8660 ◽  
Author(s):  
Sachin Kumar ◽  
Animesh K. Ojha

The recombination rate of photo-induced electrons and holes for Ni–Co codoped CeO2 nanostructures is reduced significantly, which essentially improve the photocatalytic activity for photo-degradation of MB dye.


2021 ◽  
Author(s):  
Di Liu ◽  
Liping CHEN ◽  
Wenbin Chen ◽  
Mengtao Qin ◽  
Siqi Wei

Well-dispersed Pt quantum dots (QDs) was first to be successfully deposited on PDI supramolecular nanorods surface via a simple in situ chemical reduction. Under visible light irradiation, Pt QDs/PDI composites...


RSC Advances ◽  
2015 ◽  
Vol 5 (29) ◽  
pp. 22740-22752 ◽  
Author(s):  
Menglin Sun ◽  
Qihang Zhao ◽  
Chunfang Du ◽  
Zhiliang Liu

A series of BiOCl/SnO2 heterojunctions exhibiting exceptional visible light photocatalytic performance has been successfully prepared using a two-step solution route.


Materials ◽  
2019 ◽  
Vol 12 (23) ◽  
pp. 3948
Author(s):  
Lingfang Qiu ◽  
Zhiwei Zhou ◽  
Mengfan Ma ◽  
Ping Li ◽  
Jinyong Lu ◽  
...  

Novel visible-light responded aluminosilicophosphate-5 (SAPO-5)/g-C3N4 composite has been easily constructed by thermal polymerization for the mixture of SAPO-5, NH4Cl, and dicyandiamide. The photocatalytic activity of SAPO-5/g-C3N4 is evaluated by degrading RhB (30 mg/L) under visible light illumination (λ > 420 nm). The effects of SAPO-5 incorporation proportion and initial RhB concentration on the photocatalytic performance have been discussed in detail. The optimized SAPO-5/g-C3N4 composite shows promising degradation efficiency which is 40.6% higher than that of pure g-C3N4. The degradation rate improves from 0.007 min−1 to 0.022 min−1, which is a comparable photocatalytic performance compared with other g-C3N4-based heterojunctions for dye degradation. The migration of photo-induced electrons from g-C3N4 to the Al site of SAPO-5 should promote the photo-induced electron-hole pairs separation rate of g-C3N4 efficiently. Furthermore, the redox reactions for RhB degradation occur on the photo-induced holes in the g-C3N4 and Al sites in SAPO-5, respectively. This achievement not only improves the photocatalytic activity of g-C3N4 efficiently, but also broadens the application of SAPOs in the photocatalytic field.


2021 ◽  
Vol 50 (9) ◽  
pp. 3253-3260 ◽  
Author(s):  
Shan Zhao ◽  
Junbiao Wu ◽  
Yan Xu ◽  
Xia Zhang ◽  
Yide Han ◽  
...  

CdS/Ag2S/g-C3N4 ternary composites showed excellent photocatalytic performance toward H2 evolution. Their improved photocatalytic activity could be attributed not only to the synergic effect, but also to the introduction of Ag2S.


RSC Advances ◽  
2016 ◽  
Vol 6 (95) ◽  
pp. 93048-93055 ◽  
Author(s):  
R. Giovannetti ◽  
E. Rommozzi ◽  
M. Zannotti ◽  
C. A. D'Amato ◽  
S. Ferraro ◽  
...  

Graphene dispersion (GR) was prepared by liquid-phase sonication of graphite and evaluated by XRD, DLS and UV-Vis analysis. It was used to prepare PP@mgGR–TiO2, showing positive effects on ARS photodegradation under visible light irradiation.


Sign in / Sign up

Export Citation Format

Share Document