Wideband tri‐port MIMO antenna with compact size and directional radiation pattern

2014 ◽  
Vol 50 (18) ◽  
pp. 1261-1262 ◽  
Author(s):  
Han Wang ◽  
Longsheng Liu ◽  
Zhijun Zhang ◽  
Zhenghe Feng
Keyword(s):  
Radiation Pattern ◽  
Mimo Antenna ◽  
Directional Radiation ◽  
Compact Size

A compact omnidirectional to directional frequency reconfigurable antenna for wireless sensor network applications

2021 ◽  
pp. 1-12
Author(s):  
Melvin Chamakalayil Jose ◽  
Radha Sankararajan ◽  
Balakrishnapillai Suseela Sreeja ◽  
Mohammed Gulam Nabi Alsath ◽  
Pratap Kumar
Keyword(s):  
Wireless Sensor Network ◽  
Sensor Network ◽  
Radiation Pattern ◽  
Antenna System ◽  
Wireless Sensor ◽  
Dual Band ◽  
Design Parameters ◽  
Pin Diodes ◽  
Band Frequency ◽  
Directional Radiation

Abstract In the proposed research paper, a novel compact, ultra-wideband electronically switchable dual-band omnidirectional to directional radiation pattern microstrip planar printed rectangular monopole antenna (PRMA) has been presented. The proposed antenna system has an optimum size of 0.26 λ0 × 0.28 λ0. A combination of radiators, reflectors, and two symmetrical grounds does place on the same layer of the rectangular microstrip PRMA. The frequency agility and the radiation pattern from omnidirectional to directional are achieved using two SMD PIN diodes (SMP1340-04LF). The directional radiation patterns with 180° phase shifts are achieved at the C-band frequency spectrum. The parametric study of the proposed antenna system was performed for different design parameters, and the antenna characteristics were analyzed. An antenna prototype is fabricated using the printed circuit board etching method by using RMI UV laser etching and cutting tools. The measurements of the proposed antenna are conducted in an anechoic chamber to validate the simulations. There are three states of operations due to two SMD PIN diodes being used in switching circuits. In state-I, the proposed antenna radiates at 6.185 GHz (5.275–6.6 75 GHz) in the Ф = 270° direction with a gain of 2.1 dBi, whereas in state-II, it radiates at 5.715 GHz (5.05–6.8 GHz) in the Ф = 90° direction with a gain of 2.1 dBi. In state-III, the antenna exhibits the X-band frequency with center frequency at 9.93 GHz (8.845–10.49 GHz), and the omnidirectional pattern offers a gain of 4.1 dBi. The features of the proposed antenna are suitable for high-speed wireless sensor network communication in industries such as chemical reactors in oil and gas and pharmaceuticals. It is also well suited for IoT and 5G-sub-6-GHz applications.

scholarly journals Smart optical cross dipole nanoantenna with multibeam pattern

2021 ◽  
Vol 11 (1) ◽  
Author(s):  
Seyyed Mohammad Mehdi Moshiri ◽  
Najmeh Nozhat
Keyword(s):  
Radiation Pattern ◽  
Chemical Potential ◽  
Monolayer Graphene ◽  
Absorption Characteristic ◽  
Radiation Beam ◽  
Directional Radiation ◽  
Chemical Potentials ◽  
Different Types ◽  
Absorption Power ◽  
Maximum Directivity

AbstractIn this paper, an optical smart multibeam cross dipole nano-antenna has been proposed by combining the absorption characteristic of graphene and applying different arrangements of directors. By introducing a cross dipole nano-antenna with two V-shaped coupled elements, the maximum directivity of 8.79 dBi has been obtained for unidirectional radiation pattern. Also, by applying various arrangements of circular sectors as director, different types of radiation pattern such as bi- and quad-directional have been attained with directivities of 8.63 and 8.42 dBi, respectively, at the wavelength of 1550 nm. The maximum absorption power of graphene can be tuned by choosing an appropriate chemical potential. Therefore, the radiation beam of the proposed multibeam cross dipole nano-antenna has been controlled dynamically by applying a monolayer graphene. By choosing a suitable chemical potential of graphene for each arm of the suggested cross dipole nano-antenna without the director, the unidirectional radiation pattern shifts ± 13° at the wavelength of 1550 nm. Also, for the multibeam nano-antenna with different arrangements of directors, the bi- and quad-directional radiation patterns have been smartly modified to uni- and bi-directional ones with the directivities of 10.1 and 9.54 dBi, respectively. It is because of the graphene performance as an absorptive or transparent element for different chemical potentials. This feature helps us to create a multipath wireless link with the capability to control the accessibility of each receiver.

Smart DRA for beam width and orientation control

Frequenz ◽  
2020 ◽  
Vol 74 (11-12) ◽  
pp. 383-392
Author(s):  
Rajveer S. Yaduvanshi ◽  
Richa Gupta ◽  
Saurabh Katiyar
Keyword(s):  
Radiation Pattern ◽  
High Efficiency ◽  
Beam Width ◽  
Beam Control ◽  
Design Flexibility ◽  
Compact Size ◽  
Close Proximity ◽  
Cellular Communication Network ◽  
Arc Shape ◽  
Broadside Radiation

AbstractSmartdielectric resonator antenna (DRA) having beam control mechanism is anew area to be explored by antenna researchers. Proposed new geometry DRA has low loss, design flexibility, high efficiency, compact size and desired radiated beam control. Developing beam control in new geometry DRAs is investigated for the first time in this letter. Unique technique for beam control and beam width control is proposed using pit top and mount top DRA. Gain is controlled from 5.0 to 9.98 dBi and beam is controlled from ±30° to ±70° in broadside radiation pattern. U shape pit DRA has maximum directive gain of 9.98 dBi and efficiency 98% at 5.8 GHz frequency. Measured and simulated results of radiation pattern and reflection coefficient are found to be in close proximity. Hardware of U shape pit top DRA, mount top DRA, left side arc top DRA, right side arc shape top DRA is developed and investigated. Mobile and cellular communication network need wide coverage, hence large beam width is required. Narrowing of beam width at higher order mode is also achieved.

A compact dual-band D-CRLH-based antenna with self-isolation functionality

2021 ◽  
pp. 1-10
Author(s):  
Mahmoud A. Abdalla ◽  
Mohamed El Atrash ◽  
Ahmed A. Abdel Aziz ◽  
Mohamed I. Abdelnaser
Keyword(s):  
Patch Antenna ◽  
Planar Waveguide ◽  
Dual Band ◽  
Resonant Frequencies ◽  
Left Handed ◽  
Directional Radiation ◽  
Full Wave ◽  
Compact Size ◽  
Filtering Function ◽  
Filter Structures

Abstract This paper presents a compact dual-band filtering antenna without extra employing of filter structures. The antenna is designed using a planar dual-composite right/left-handed (D-CRLH) transmission line unit cell, where the filtering function is achieved through current cancellation between the D-CRLH resonators. The antenna is designed to function at 3.0 and 5.1 GHz, which can serve different WLAN applications. The antenna is a co-planar waveguide fed with a very compact size of only 30 × 16 mm2. Compared to the conventional patch antenna, the antenna size is only 17% at 3.0 GHz and 31% at 5.1 GHz. Despite the small size, the antenna preserves a good omni-directional radiation pattern at the two resonant frequencies with a measured realized gain of 2 and 2.7 dB, respectively. At the stopband in-between the two resonant bands, the reflection coefficient is almost 0 dB at 4.25 GHz and complete non-radiation is proved with a −11 dB measured realized gain. The different antenna filtering functions are verified by full-wave simulation and measurements.

scholarly journals UWB elliptical patch monopole antenna with dual-band notched characteristics

2019 ◽  
Vol 9 (5) ◽  
pp. 3591
Author(s):  
A H Majeed ◽  
K H Sayidmarie
Keyword(s):  
Radiation Pattern ◽  
Ground Plane ◽  
Monopole Antenna ◽  
Experimental Results ◽  
Dual Band ◽  
New Approach ◽  
Compact Size

<p class="Default">In this paper, a new approach to the design of an UWB monopole antenna with dual band-notched characteristics is presented.   The antenna has the form of an elliptical monopole over a ground plane having an elliptical slot to achieve the UWB. The dual-band notch function is created by inserting a U-shaped and a C-shaped slots on the radiating patch, thus no extra size is needed. The proposed antenna shows a good omnidirectional radiation pattern across the band from 3.2 to more than 14 GHz. The dual band-rejection is for 4.88-5.79GHz centered at 5.4GHz and 7.21-8.46 GHz centered at 7.8 GHz. The antenna prototype using the FR-4 substrate with ε<sub>r</sub>=4.3 has a compact size of 25mm×25 mm ×1.45mm. The fabricated prototype showed experimental results comparable to those obtained from the simulations.</p>

scholarly journals Design and Analysis of MIMO Dual Band Patch Antenna for 5G New Radio Applications in Mobile Terminals

2021 ◽  
Vol 9 (VI) ◽  
pp. 5446-5451
Author(s):  
Swati Dhandade
Keyword(s):  
Mobile Communications ◽  
Antenna Design ◽  
Dual Band ◽  
Slight Variation ◽  
Band Frequency ◽  
Mimo Antenna ◽  
High Isolation ◽  
New Radio ◽  
Compact Size ◽  
5G Mobile Communications

This paper presents a dual-band MIMO antenna design with compact size for 5G communication under 6 GHz band frequency. The metallic monopole stub structure is used to miniaturization of antenna. The L-shape monopole antenna is modified by adding semi-circular element in radiating structure of monopole to obtain dual-band resonance. The High isolation is achieved by employing T-shaped stub in ground plane.It has compact size is 45 mm × 25 mm × 1.6 mm3. The proposed Dual Band MIMO antenna has been design on FR4 material with ɛr = 4.4 with 1.6 thickness. The proposed antenna has 5G application in the bands of 2.5 GHz (2.34 GHz-2.62 GHz) and 3.5 GHz (3.20 GHz-5.20 GHz). The bandwidth of antenna getting 320MHz and 2500MHz at 2.5GHz and 3.5GHz respectively. The Isolation (S21) of proposed antenna is -31.2 dB at 2.5 GHz and -19.5 dB at 3.5 GHz. VSWR is less than 1.06 for both the bands. The designed dual band MIMO antenna covers 5G bands of 2.3-2.4GHz (n30/n40), 2.4-2.5GHz (n7/n38/n41/n90), and 3.2-5.2GHz (n77/n78/n80). The experimental and simulated results observed good matching except some slight variation. This proposed dual band MIMO antenna is suitable for 5G mobile Communications.

scholarly journals Low Cost Circularly Polarized Antenna for IoT Space Applications

Electronics ◽  
2020 ◽  
Vol 9 (10) ◽  
pp. 1564
Author(s):  
Le Huy Trinh ◽  
Nguyen Vu Truong ◽  
Fabien Ferrero
Keyword(s):  
Circular Polarization ◽  
Radiation Pattern ◽  
Insertion Loss ◽  
Low Cost ◽  
Total Efficiency ◽  
Area Network ◽  
Wide Area Network ◽  
Space Applications ◽  
Circularly Polarized ◽  
Compact Size

This work presents the use of a three-element radiating structure for circularly polarized Low-Power Wide Area Network (LP-WAN) communication with space. The proposed structure has a 72 mm × 72 mm × 12 mm compact size with Right-Handed Circular Polarization (RHCP) and a 120∘ wide beamwidth radiation pattern. Printed on low-cost FR4 Epoxy substrate, a feeding network circuit based on Quasi Lumped Quadrature Coupler (QLQC), it achieves a −0.6 dB insertion loss and a very compact size. The final structure has a 69% total efficiency and a 3.14 dBic realized gain.

Sign in / Sign up

Export Citation Format

Share Document