scholarly journals Effect of butanol on fuel consumption and smoke emission of direct injection diesel engine fueled by jatropha oil and diesel fuel blends with cold EGR system

2018 ◽  
Vol 49 ◽  
pp. 02010
Author(s):  
Syarifudin ◽  
Syaiful ◽  
Eflita Yohana
Keyword(s):  
Diesel Engine ◽  
Fuel Consumption ◽  
Diesel Fuel ◽  
Diesel Engines ◽  
Alternative Fuels ◽  
Fossil Fuels ◽  
Direct Injection ◽  
Jatropha Oil ◽  
Fuel Blend ◽  
Direct Injection Diesel Engine

Diesel engines are widely used in industry, automotive, power generation due to better reliability and higher efficiency. However, diesel engines produce high smoke emissions. The main problem of diesel engine is actually the use of fossil fuels as a source of energy whose availability is diminishing. Therefore alternative fuels for diesel fuels such as jatropha and butanol are needed to reduce dependence on fossil fuels. In this study, the effect of butanol usage on fuel consumption and smoke emissions of direct injection diesel engine fueled by jatropha oil and diesel fuel with cold EGR system was investigated. The percentage of butanol was in the range of 5 to 15%, jatropha oil was in the range of 10 to 30% and the balance was diesel fuel. Cold EGR was varied through valve openings from 0 to 100% with 25% intervals. The experimental data shows that the BSFC value increases with increasing percentage of butanol. In addition, the use of EGR results in a higher increase of BSFC than that without EGR. While the addition of butanol into a blend of jatropha oil and diesel fuel causes a decrease in smoke emissions. The results also informed that the use of EGR in the same fuel blend led to increased smoke emissions.

Utilization of Low-Calorific Gaseous Fuel in a Direct-Injection Diesel Engine

2005 ◽  
Vol 128 (4) ◽  
pp. 915-920 ◽  
Author(s):  
Ali Mohammadi ◽  
Masahiro Shioji ◽  
Takuji Ishiyama ◽  
Masato Kitazaki
Keyword(s):  
Power Generation ◽  
Diesel Engine ◽  
Fuel Consumption ◽  
Diesel Fuel ◽  
Diesel Engines ◽  
Direct Injection ◽  
Engine Performance ◽  
Chemical Processes ◽  
Solid Wastes ◽  
Direct Injection Diesel Engine

Low-calorific gases with a small portion of hydrogen are produced in various chemical processes, such as gasification of solid wastes or biomass. The aim of this study is to clarify the efficient usage of these gases in diesel engines used for power generation. Effects of amount and composition of low-calorific gases on diesel engine performance and exhaust emissions were experimentally investigated adding hydrogen-nitrogen mixtures into the intake gas of a single-cylinder direct-injection diesel engine. The results indicate that optimal usage of low-calorific gases improves NOx and Smoke emissions with remarkable saving in diesel fuel consumption.

scholarly journals Study on the Greenhouse Gases Generated by the Direct Injection Diesel Engines Running on Biodiesel

2016 ◽  
Vol 22 (3) ◽  
pp. 616-621
Author(s):  
Doru Coşofreţ ◽  
Cătălin Popa ◽  
Marian Ristea
Keyword(s):  
Diesel Engine ◽  
Greenhouse Gases ◽  
Carbon Content ◽  
Fuel Consumption ◽  
Laboratory Study ◽  
Diesel Fuel ◽  
Diesel Engines ◽  
Fossil Fuels ◽  
Direct Injection ◽  
Specific Fuel Consumption

Abstract The formation of CO2 emissions is largely dependent on the carbon content of the fuel used in diesel engines and on the fuel consumption. The mixture of biodiesel in fossil fuels is in line with most of the research presented in the specialty literature, a method of reducing CO2 emissions from diesel engines. Due to these controversies on the obtained results, the research of the biodiesel effects blended with fossil fuels is still a matter of study. Therefore, a laboratory study has been conducted on a naturally aspirated 4-stroke diesel engine, using different mixtures (10, 15, 20, 25, 30, 40 and 50%) of diesel with biodiesel produced from oil rape. The results of the study revealed the fact that CO2 emissions of the blends used are lower than the same emissions produced when powering the engine with diesel fuel. Furthermore, of all blends used in the study, the 15% biodiesel mixture in diesel fuel was marked by a major decrease of CO2 emissions and of specific fuel consumption.

Low and High Purity Methanol Effect on Performance and Smoke Emission of Direct Injection Diesel Engine with Cooled EGR Fueled by Diesel Fuel and Jatropha Oil Blends

2014 ◽  
Vol 660 ◽  
pp. 426-430 ◽  
Author(s):  
Syaiful ◽  
Sobri ◽  
Nathanael P. Tandian
Keyword(s):  
Diesel Engine ◽  
Diesel Fuel ◽  
High Purity ◽  
Direct Injection ◽  
Jatropha Oil ◽  
Smoke Emission ◽  
Fuel Blend ◽  
Oil Blends ◽  
Fuel Blends ◽  
Oil Blend

The aim of this study is to experimentally investigate an effect of low and high purity methanol on a performance and smoke emission of diesel engine with cooled EGR system fueled by diesel fuel and jatropha oil blend. A four-stroke water cooled direct injection (DI) diesel engine with cooled EGR system was used in this work. The diesel engine was fueled by diesel fuel, jatropha oil and low (LPM) or high (HPM) purity methanol blends at the ratio of 100/0/0, 75/20/5, 70/20/10 and 65/20/15 % on volume basis respectively for the variation of engine loads in the range of 25 to 100% with 25% increments at 2000 rpm. Each load for every fuel blend was given by the 0% and 16.5% EGR rates. The results are found that the brake power for diesel engine fueled by diesel fuel, jatropha oil and LPM is approximately 8% lower than that of diesel engine fueled with the neat diesel, while it increases to 5.24% at the low load and reduces to 6.11% at the high load by injecting HPM in the fuel blends. At the same case, BSFC increases approximately 4.5% by injecting LPM in the fuel blends. The brake thermal efficiency rises approximately by 3.3% with LPM in the fuel blends, whereas it increases approximately 6% by injecting HPM. The smoke opacity reduces approximately by 70% with LPM or HPM in the fuel blends.

Effect of diesel fuel blend with n-butanol on the emission of a turbocharged common rail direct injection diesel engine

2015 ◽  
Vol 146 ◽  
pp. 20-28 ◽  
Author(s):  
Byungchul Choi ◽  
Xiaolong Jiang ◽  
Young Kwon Kim ◽  
Gilsung Jung ◽  
Chunhwan Lee ◽  
...  
Keyword(s):  
Diesel Engine ◽  
Diesel Fuel ◽  
Direct Injection ◽  
Common Rail ◽  
Fuel Blend ◽  
Direct Injection Diesel Engine

Effect of altitude conditions on combustion and performance of a turbocharged direct-injection diesel engine

2021 ◽  
pp. 095440702110262
Author(s):  
Zhentao Liu ◽  
Jinlong Liu
Keyword(s):  
Diesel Engine ◽  
High Altitude ◽  
Diesel Engines ◽  
Direct Injection ◽  
Pressure Rise ◽  
Ambient Conditions ◽  
Allowable Limit ◽  
Spray Formation ◽  
Direct Injection Diesel Engine ◽  
And Performance

Market globalization necessitates the development of heavy duty diesel engines that can operate at altitudes up to 5000 m without significant performance deterioration. But the current scenario is that existing studies on high altitude effects are still not sufficient or detailed enough to take effective measures. This study applied a single cylinder direct injection diesel engine with simulated boosting pressure to investigate the performance degradation at high altitude, with the aim of adding more knowledge to the literature. Such a research engine was conducted at constant speed and injection strategy but different ambient conditions from sea level to 5000 m in altitude. The results indicated the effects of altitude on engine combustion and performance can be summarized as two aspects. First comes the extended ignition delay at high altitude, which would raise the rate of pressure rise to a point that can exceed the maximum allowable limit and therefore shorten the engine lifespan. The other disadvantage of high-altitude operation is the reduced excess air ratio and gas density inside cylinder. Worsened spray formation and mixture preparation, together with insufficient and late oxidation, would result in reduced engine efficiency, increased emissions, and power loss. The combustion and performance deteriorations were noticeable when the engine was operated above 4000 m in altitude. All these findings support the need for further fundamental investigations of in-cylinder activities of diesel engines working at plateau regions.

Explorative Investigation on Cashew Nut Shell Liquid Biodiesel blended with Ethanol and Hydrogen in Direct Injection (DI) Diesel Engine and prediction through Artificial Neural Network

2021 ◽  
Author(s):  
Thanigaivelan V ◽  
Lavanya R
Keyword(s):  
Diesel Engine ◽  
Diesel Fuel ◽  
Direct Injection ◽  
Cashew Nut Shell Liquid ◽  
Single Cylinder ◽  
Direct Injection Diesel Engine ◽  
Cashew Nut ◽  
Di Diesel Engine ◽  
Artificial Neural ◽  
Cashew Nut Shell

Abstract Emission from the DI diesel engine is series setback for environment viewpoint. Intended for that investigates for alternative biofuel is persuaded. The important hitches with the utilization of biofuels and their blends in DI diesel engines are higher emanations and inferior brake-thermal efficiency as associated to sole diesel fuel. In this effort, Cashew nut shell liquid (CNSL) biodiesel, hydrogen and ethanol (BHE) mixtures remained verified in a direct-injection diesel engine with single cylinder to examine the performance and discharge features of the engine. The ethanol remained supplemented 5%, 10% and 15% correspondingly through enhanced CNSL as well as hydrogen functioned twin fuel engine. The experiments done in a direct injection diesel engine with single-cylinder at steadystate conditions above the persistent RPM (1500RPM). Throughout the experiment, emissions of pollutants such as fuel consumption rate (SFC), hydrocarbons (HC), carbon monoxide (CO), nitrogen oxides (NOx) and pressure of the fuel were also measured. cylinders. The experimental results show that, compared to diesel fuel, the braking heat of the biodiesel mixture is reduced by 26.79-24% and the BSFC diminutions with growing addition of ethanol from the CNSL hydrogen mixture. The BTE upsurges thru a rise in ethanol proportion with CNSL hydrogen mixtures. Finally, the optimum combination of ethanol with CNSL hydrogen blends led to the reduced levels of HC and CO emissions with trivial upsurge in exhaust gas temperature and NOx emissions. This paper reconnoiters the routine of artificial neural networks (ANN) to envisage recital, ignition and discharges effect.

Effect of n-heptane and n-decane on exhaust odour in direct injection diesel engines

2005 ◽  
Vol 219 (4) ◽  
pp. 565-571 ◽  
Author(s):  
M M Roy
Keyword(s):  
Direct Effect ◽  
Diesel Fuel ◽  
Diesel Engines ◽  
Ignition Delay ◽  
Boiling Point ◽  
Alternative Fuels ◽  
Direct Injection ◽  
Cetane Number ◽  
Mixture Formation ◽  
Incomplete Combustion

This study investigated the effect of n-heptane and n-decane on exhaust odour in direct injection (DI) diesel engines. The prospect of these alternative fuels to reduce wall adherence and overleaning, major sources of incomplete combustion, as well as odorous emissions has been investigated. The n-heptane was tested as a low boiling point fuel that can improve evaporation as well as wall adherence. However, the odour is a little worse with n-heptane and blends than that of diesel fuel due to overleaning of the mixture. Also, formaldehyde (HCHO) and total hydrocarbon (THC) in the exhaust increase with increasing n-heptane content. The n-decane was tested as a fuel with a high cetane number that can improve ignition delay, which has a direct effect on wall adherence and overleaning. However, with n-decane and blends, the odour rating is about 0.5-1 point lower than for diesel fuel. Moreover, the aldehydes and THC are significantly reduced. This is due to less wall adherence and proper mixture formation.

Sign in / Sign up

Export Citation Format

Share Document