Determination of Absorption Coefficient of a Solution by a Simple Experimental Setup

2011 ◽  
Author(s):  
Deepak Gopalakrishnan ◽  
C. Akhildev ◽  
P. V. Sreenivasan ◽  
K. K. Leelamma ◽  
Lyjo K. Joseph ◽  
...  
Keyword(s):  
Absorption Coefficient ◽  
Experimental Setup

The Use of Reverse Mirage Spectroscopy to Determine the Absorption Coefficient of Liquid Methanol at CO2 Laser Wavelengths

1989 ◽  
Vol 43 (1) ◽  
pp. 148-153 ◽  
Author(s):  
Dane Bićanić ◽  
Siegfried Krüger ◽  
Paul Torfs ◽  
Bruno Bein ◽  
Frans Harren
Keyword(s):  
Absorption Coefficient ◽  
Co2 Laser ◽  
Probe Beam ◽  
Laser Emission ◽  
Wavelength Region ◽  
Experimental Setup ◽  
Absorption Coefficients ◽  
Experimental Conditions ◽  
Liquid Samples

An experimental setup for performance of reverse mirage spectroscopy at CO2 laser wavelengths on liquid samples having high values of absorption coefficients is described. One and the same liquid is used as both the absorbing and deflecting medium. The Rosencwaig-Gersho theory has been applied, and the choice of experimental conditions that would enable determination of absorption coefficient β from the magnitude of photothermal signals measured at two different probe beam distances (probing locations) is discussed. The usefulness of this technique (essentially not inhibited by the requirements imposed on the sample's thickness) is tested on methanol having absorption coefficients β close to 300 cm−1 in the wavelength region covered by CO2 laser emission.

Quantitative photopyroelectric out-of-phase spectroscopy of amorphous silicon thin films deposited on crystalline silicon

1991 ◽  
Vol 69 (3-4) ◽  
pp. 317-323 ◽  
Author(s):  
Constantinos Christofides ◽  
Andreas Mandelis ◽  
Albert Engel ◽  
Michel Bisson ◽  
Gord Harling
Keyword(s):  
Thin Films ◽  
Optical Absorption ◽  
Absorption Coefficient ◽  
Dynamic Range ◽  
Crystalline Silicon ◽  
Optical Absorption Coefficient ◽  
Si Substrates ◽  
Silicon Thin Films ◽  
Background Compensation

A photopyroelectric spectrometer with real-time and(or) self-normalization capability was used for both conventional transmission and thermal-wave spectroscopic measurements of amorphous Si thin films, deposited on crystalline Si substrates. Optical-absorption-coefficient spectra were obtained from these measurements and the superior dynamic range of the out-of-phase (quadrature) photopyroelectric signal was established as the preferred measurement method, owing to its zero-background compensation capability. An extension of a photopyroelectric theoretical model was established and successfully tested in the determination of the optical absorption coefficient and the thermal diffusivity of the sample under investigation. Instrumental sensitivity limits of βt ≈ 5 × 10−3 were demonstrated.

scholarly journals A Generalized Method for Flat Plates Impact Detection and Location

2013 ◽  
Vol 543 ◽  
pp. 171-175
Author(s):  
Jose Andrés Somolinos ◽  
Rafael Morales ◽  
Carlos Morón ◽  
Alfonso Garcia
Keyword(s):  
Signal Processing ◽  
Flat Plate ◽  
Acoustic Signal ◽  
Experimental Results ◽  
Piezoelectric Sensors ◽  
Experimental Setup ◽  
Flat Plates ◽  
Impact Detection ◽  
Timing Difference

In the last years, many analyses from acoustic signal processing have been used for different applications. In most cases, these sensor systems are based on the determination of times of flight for signals from every transducer. This paper presents a flat plate generalization method for impact detection and location over linear links or bars-based structures. The use of three piezoelectric sensors allow to achieve the position and impact time while the use of additional sensors lets cover a larger area of detection and avoid wrong timing difference measurements. An experimental setup and some experimental results are briefly presented.

Simultaneous Determination of Layer Thickness, Composition, and Mass Absorption by X-Ray Diffraction

1992 ◽  
Vol 7 (4) ◽  
pp. 194-196 ◽  
Author(s):  
Stefano Battaglia ◽  
Marco Franzini ◽  
Leonardo Leoni
Keyword(s):  
Absorption Coefficient ◽  
Simultaneous Determination ◽  
Mass Absorption Coefficient ◽  
Crystalline Substance ◽  
X Ray Diffraction ◽  
Mass Thickness ◽  
Mass Absorption ◽  
Crystalline Substrate ◽  
Quantitative Results

AbstractThis paper describes a new method for the simultaneous determination of mineral composition, mass thickness and mass absorption coefficient of a thin layer of a crystalline substance deposited on a crystalline substrate.The samples were deposited on membrane disc filters, consisting of mixtures of cellulose acetate and cellulose nitrate. Quantitative results are achieved by measuring the diffraction intensity of the analyte and the attenuation of a reflection of the crystalline material supporting the deposited sample. The mean accuracy of the analysis was found to be: ≈ 3% for mass thickness, ≈ 1% for mass absorption coefficient and ≈ 4% for quantitative mineralogical determination.

scholarly journals Imaging Mueller matrix determination of transparent, unpolarizing samples using a classically entangled polarization state

2018 ◽  
Vol 64 (4) ◽  
pp. 407
Author(s):  
Jacqueline Isamar Muro-Ríos ◽  
R. Espinosa-Luna
Keyword(s):  
Open Space ◽  
Polarization State ◽  
Theoretical Work ◽  
Mueller Matrix ◽  
Experimental Setup ◽  
Wave Plate ◽  
Recent Theoretical Work ◽  
Study Results ◽  
Theoretical Proposal

Inspired in a recent theoretical work for the determination of the Mueller matrix, using as incidence a single classically entangled polarization state (F. Töppel et al., New J. Phys. 16 (2014) 073019), an experimental setup is proposed and tested.  The open space and two wave plate retarders are used as the transparent, nondepolarizing samples under study. Results show some experimental improvements are necessary in order to implement accurately the theoretical proposal in which this work is based.

Sign in / Sign up

Export Citation Format

Share Document