<p><strong>Abstract.</strong> Lava dome changes detection during increasingly high volcanic activity are essential for hazard assessment purposes. However, it is challenging to conduct direct field measurement due to safety reason. Here, we investigate the lava dome changes of Mount Agung in Indonesia during the highest level of volcanic activity. On 22 September 2017, the rumbling and seismic activity in this volcano started increasing to the highest level for a period of time. We afterwards collected image data at lava dome area by using UAV over this time period. To accomplish the goal of change detection, we assembled and developed a fixed-wing UAV platform, i.e. Buffalo FX-79 to acquire images of Mount Agung whose elevation is roughly 3,142&thinsp;m above sea level. We acquired the UAV images on two dates, i.e. Oct 19 and Oct 21 of 2017. Due to an exclusion zone surround the volcano, we could only operate the UAV at 20&thinsp;km distance from the crater. With these data set, we produced three-dimensional point clouds, high-resolution Digital Elevation Model and orthophoto by using Structure from Motion (SfM) and Multi View Stereo (SfM-MVS) technique with Photoscan Pro software. From orthophoto data, we found two fluid areas at the crater's surface in NE direction (4,375.9&thinsp;sq-m) and SE direction (3,749.8&thinsp;sq-m). We also detected a fumarole which emitted steam and gases in the eastern part that continued for several days. In order to reveal the changes in lava dome surface, we used DEM to create cross-section profile. After that, we applied cloud to cloud comparison (C2C) algorithm to calculate the difference of lava dome based on two data set of point clouds and compared it with interferometric result from Sentinel-1A data. The data from the Sentinel-1A satellite (15 Oct &ndash; 27 Oct 2017) were processed to obtain the interferogram image of Mount Agung. This research therefore demonstrates a potential method to detect lava dome changes during high level of volcanic activity with photogrammetric methods by using UAV images. Within only two days the data were successfully acquired. From the DEM data and cross-section profile between two data set, we noticed that no significant surface change was found around the lava dome surface. Moreover, we also found that there was no significant lava dome changes and vertical displacement during these two time periods as the point cloud comparison and distance result. The average of difference distance is 2.27&thinsp;cm with a maximal and minimal displacement of 255&thinsp;cm and 0.37&thinsp;cm respectively. This result was then validated by using InSAR Sentinel that showed small displacement, i.e 6.88&thinsp;cm. It indicated that UAV photogrammetry showed a good performance to detect surface changes in centimeter fraction.</p>
INFLUENCE OF LASER BEAM PROFILE ON LIGHT SCATTERING BY HUMAN SKIN DURING PHOTOMETRY BY ELLIPSOIDAL REFLECTORS