Preparation and characterization of biomass-alumina composite as adsorbent for safranine-o dye from aqueous solution at different temperatures

2021 ◽  
Author(s):  
Mohammed Ahmed Jasim ◽  
Ahmed Mohammed Abbas ◽  
Israa Mohammed Radhi
2013 ◽  
Vol 770 ◽  
pp. 68-71 ◽  
Author(s):  
Supphadate Sujinnapram ◽  
Uraiphorn Termsuk ◽  
Atcharawan Charoentam ◽  
Sutthipoj Sutthana

The nanocrystalline ZnO powders were synthesized by a direct thermal decomposition using zinc nitrate hexahydrate as starting materials. The precursor was characterized by TG-DTA to determine the thermal decomposition and crystallization temperature which was found to be at 325 oC. The precursors were calcined at different temperatures of 400, 500, and 600°C for 4 h. The structure of the prepared samples was studied by XRD, confirming the formation of wurtzite structure. The synthesized powders exhibited the UV absorption below 400 nm (3.10 eV) with a well defined absorption peak at around 285 nm (4.35 eV). The estimated direct bandgaps were obtained to be 3.19, 3.16, and 3.14 eV for the ZnO samples thermally decomposed at 400, 500, and 600°C, respectively.


2014 ◽  
Vol 12 (0) ◽  
pp. 404-409 ◽  
Author(s):  
Fumihiko Ogata ◽  
Daisuke Imai ◽  
Megumu Toda ◽  
Masashi Otani ◽  
Naohito Kawasaki

2019 ◽  
Vol 943 ◽  
pp. 95-99
Author(s):  
Li Jun Wang ◽  
Kazuo Umemura

Optical absorption spectroscopy provides evidence for individually dispersed carbon nanotubes. A common method to disperse SWCNTs into aqueous solution is to sonicate the mixture in the presence of a double-stranded DNA (dsDNA). In this paper, optical characterization of dsDNA-wrapped HiPco carbon nanotubes (dsDNA-SWCNT) was carried out using near infrared (NIR) spectroscopy and photoluminescence (PL) experiments. The findings suggest that SWCNT dispersion is very good in the environment of DNA existing. Additionally, its dispersion depends on dsDNA concentration.


2013 ◽  
Vol 4 (7) ◽  
pp. 49-54
Author(s):  
Elahaj Babiker Mohamed ◽  
Shehab Naglaa Ahmed ◽  
Ali Heyam Saad

1983 ◽  
Vol 27 ◽  
Author(s):  
R. Martinella ◽  
G. Chevallard ◽  
C. Tosello

ABSTRACTMechanically polished Ti6Al4V samples were implanted with 100 key nitrogen ions to a fluence of 5.1017 ions/cm2 at two different bulk tenneratures: 370°C and 470°C. Wear tests were carried out with a reciprocating slidina tribotester. Structural modifications and wear morphologies were studied by TEM and SEM. 370°C implanted sample showed the same wear behavior as unimplanted ones, while 470°C implanted sample showed better wear resistance because of a TiN hardened layer. Correlations- between microstructural modifications, wear behavior and mechanisms are reported: results agree with the delamination theory. Comparison with ion- and gas-nitrided samples are presented.


Sign in / Sign up

Export Citation Format

Share Document