The role of incidence angle in the morphology evolution of Ge surfaces irradiated by medium-energy Au ions

2018 ◽  
Vol 30 (32) ◽  
pp. 324001
Author(s):  
Rossana Dell’Anna ◽  
Erica Iacob ◽  
Mario Barozzi ◽  
Lia Vanzetti ◽  
René Hübner ◽  
...  
1981 ◽  
Vol 106 (1-2) ◽  
pp. 29-32 ◽  
Author(s):  
J. Dubach ◽  
W.M. Kloet ◽  
A. Cass ◽  
R.R. Silbar

2019 ◽  
Vol 26 (2) ◽  
pp. 024502 ◽  
Author(s):  
Brett Scheiner ◽  
Mark Schmitt

Author(s):  
S. Chauhan ◽  
R. Darvishzadeh ◽  
M. Boschetti ◽  
A. Nelson

Abstract. Crop lodging – the bending of crop stems from the vertical – is a major yield-reducing factor in cereal crops and causes deterioration in grain quality. Accurate assessment of crop lodging is important for improving estimates of crop yield losses, informing insurance loss adjusters and influencing management decisions for subsequent seasons. The role of remote sensing data, particularly synthetic aperture radar (SAR) data has been emphasized in the recent literature for crop lodging assessment. However, the effect of lodging on SAR scattering mechanisms is still unknown. Therefore, this research aims to understand the possible change in scattering mechanisms due to lodging by investigating SAR image pairs before and after lodging. We conducted the study in 26 wheat fields in the Bonifiche Ferraresi farm, located in Jolanda di Savoia, Ferrara, Italy. We measured temporal crop biophysical (e.g. crop angle) parameters and acquired multi-incidence angle RADARSAT-2 (R-2 FQ8-27° and R-2 FQ21-41°) and Sentinel-1 (S-1 40°) images corresponding to the time of field observations. We extracted metrics of SAR scattering mechanisms from RADARSAT-2 and Sentinel-1 image pairs in different zones using the unsupervised H/α decomposition algorithm and Wishart classifier. Contrasting results were obtained at different incidence angles. Bragg surface scattering increased in the case of S-1 (6.8%), R-2 FQ8 (1.8%) while at R-2 FQ21, it decreased (8%) after lodging. The change in double bounce scattering was more prominent at low incidence angle. These observations can guide future use of SAR-based information for operational crop lodging assessment in particular, and sustainable agriculture in general.


2012 ◽  
Vol 2012 ◽  
pp. 1-7 ◽  
Author(s):  
B. Kapilevich ◽  
B. Litvak ◽  
M. Anisimov ◽  
D. Hardon ◽  
Y. Pinhasi

The paper describes the complex permittivity measurements of textiles and leathers in a free space at 330 GHz. The destructive role of the Rayleigh scattering effect is considered and the angular-invariant limit for an incidence angle has been found out experimentally within 25–30 degrees. If incidence angle exceeds this critical parameter, the uncertainty caused by the Rayleigh scattering is drastically increased preventing accurate measurements of the real and imaginary parts of a bulky material. The phenomenon must be taken into consideration in predicting shielding effectiveness of materials covering hidden object in concealed threat detection with millimeter-wave radar systems.


MRS Advances ◽  
2017 ◽  
Vol 2 (4) ◽  
pp. 247-252
Author(s):  
Narasimhan Srinivasan ◽  
Katrina Rook ◽  
Ivan Berry ◽  
Binyamin Rubin ◽  
Frank Cerio

ABSTRACTWe investigate the feasibility of inert ion beam etch (IBE) for subtractive patterning of ReRAM-type structures. We report on the role of the angle-dependent ion beam etch rates in device area control and the minimization of sidewall re-deposition. The etch rates of key ReRAM materials are presented versus incidence angle and ion beam energy. As the ion beam voltage is increased, we demonstrate a significant enhancement in the relative etch rate at glancing incidence (for example, by a factor of 2 for HfO2). Since the feature sidewall is typically exposed to glancing incidence, this energy-dependence plays a role in optimization of the feature shape and in sidewall re-deposition removal.We present results of SRIM simulations to estimate depth of ion-bombardment damage to the TMO sidewall. Damage is minimized by minimizing ion energy; its depth can be reduced by roughly a factor of 5 over typical IBE energy ranges. For example, ion energies of less than ∼250 eV are indicated to maintain damage below ∼1nm. Multi-angle and multi-energy etch schemes are proposed to maximize sidewall angle and minimize damage, while eliminating re-deposition across the TMO. We utilize 2-D geometry/3-D etch model to simulate IBE patterning of tight-pitched ReRAM features, and generate etched feature shapes.


2020 ◽  
Vol 8 (12) ◽  
pp. 965
Author(s):  
Jaime Arriaga ◽  
Francesca Ribas ◽  
Albert Falqués ◽  
Jantien Rutten ◽  
Gerben Ruessink

Concentrated mega-nourishments, built as coastal protection measures for decadal time scales, are intended to diffuse, that is to erode and to supply sand to the nearby beaches and dunes by profiting of the natural drivers. Here, we aim to quantify the role of the wave incidence angle and initial geometry on the long-term evolution of mega-nourishments, in particular the Zandmotor (the Netherlands), using a nonlinear morphodynamic model for large-scale shoreline dynamics. Synthetic wave climates based on measurements are created to systematically vary the wave conditions. Simulations show that mega-nourishment diffusivity decreases linearly with an increasing percentage of high-angle waves (>45° incidence with respect to the global shoreline orientation in deep water). For wave climates with more than 80% of high-angle waves, erosional hotspots develop at the sides of the mega-nourishment. In unimodal high-angle wave climates, hotspot growth rates are large and alongshore migration of the nourishment can increase up to 40 m/year. The role of initial geometry is studied by creating synthetic nourishments that vary in shape, asymmetry, and volume. Slender initial shapes are less diffusive than wider shapes. The initial asymmetry influences the asymmetry in sand feeding to adjacent beaches throughout 50 years, which for symmetric nourishments is controlled by the imbalance in the wave climate. Smaller nourishments than the Zandmotor are more diffusive. This work contributes to a more general understanding of mega-nourishment evolution and may serve as guide for future mega-nourishment design.


2014 ◽  
Vol 317 ◽  
pp. 476-479 ◽  
Author(s):  
S.K. Garg ◽  
D.P. Datta ◽  
J. Ghatak ◽  
S.R. Tripathy ◽  
D. Kanjilal ◽  
...  

1998 ◽  
Vol 167 ◽  
pp. 41-44
Author(s):  
F. Portier-Fozzani ◽  
A.J. Maucherat ◽  
EIT Team

AbstractSince January 1996 (EIT first light) the Extreme Ultraviolet Telescope aboard SOHO has produced about 20,000 wide-field images of the corona and transition regions. Four different emission lines (He II, Fe IX/X, Fe XII, Fe XV) were selected to detail morphologies of magnetic structures in the corona. They show the different structures present in the corona with information about their topologies (Neupert et al. 1998). They provide the global temperature distribution in the quiet corona in the range 0.5 to 3 × 106 K.The evolution of the corona during the first year of the SOHO mission revealed its nonuniform aspect and the nonregularity of the appearance of new active regions. Changes observed in active regions and coronal holes (e.g., August–September 1996) showed the complex role of magnetic fields including magnetic interactions and possible reconnections needed to explain some loop morphology evolution.


Sign in / Sign up

Export Citation Format

Share Document