scholarly journals Variation Resistance of different operation temperature of NO2 and NH3 gases for the Ag-doped SiC gas sensor

2021 ◽  
Vol 1973 (1) ◽  
pp. 012140
Author(s):  
H H Khudher ◽  
J A Abd
Materials ◽  
2022 ◽  
Vol 15 (2) ◽  
pp. 399
Author(s):  
Kee-Ryung Park ◽  
Ryun Na Kim ◽  
Yoseb Song ◽  
Jinhyeong Kwon ◽  
Hyeunseok Choi

Herein, a facile fabrication process of ZnO-ZnFe2O4 hollow nanofibers through one-needle syringe electrospinning and the following calcination process is presented. The various compositions of the ZnO-ZnFe2O4 nanofibers are simply created by controlling the metal precursor ratios of Zn and Fe. Moreover, the different diffusion rates of the metal oxides and metal precursors generate a hollow nanostructure during calcination. The hollow structure of the ZnO-ZnFe2O4 enables an enlarged surface area and increased gas sensing sites. In addition, the interface of ZnO and ZnFe2O4 forms a p-n junction to improve gas response and to lower operation temperature. The optimized ZnO-ZnFe2O4 has shown good H2S gas sensing properties of 84.5 (S = Ra/Rg) at 10 ppm at 250 ∘C with excellent selectivity. This study shows the good potential of p-n junction ZnO-ZnFe2O4 on H2S detection and affords a promising sensor design for a high-performance gas sensor.


2002 ◽  
Vol 84 (2-3) ◽  
pp. 258-264 ◽  
Author(s):  
J.F. Chang ◽  
H.H. Kuo ◽  
I.C. Leu ◽  
M.H. Hon

Crystals ◽  
2020 ◽  
Vol 10 (11) ◽  
pp. 968
Author(s):  
Yaping Yan ◽  
Tae-yil Eom ◽  
Shiyu Xu ◽  
Pil J. Yoo ◽  
Changzeng Yan ◽  
...  

This study reports the employment of Co(OH)xF2−x nanosheets, a new material in the sensor field, for gas sensor applications. We synthesize Co(OH)xF2−x nanosheets via a hydrothermal route using SiO2 sphere templates. Our material characterization confirms that the material is a densely clustered Co(OH)xF2−x nanosheet with an amorphous microstructure with some short-range ordering. Sensors based on the nanosheets demonstrate a high response of 269% toward 4.5 ppm of acetone gas at an operation temperature of 200 °C and a very low minimum detection limit of 40 ppb. It functions effectively up to a temperature below 300 °C, above which F is found to start to evaporate. Our discussion suggests that an excellent sensor performance arises from the high catalytic function of F incorporated in a high concentration in the material as well as the high specific surface area due to the morphology of densely clustered nanosheets.


Chemosensors ◽  
2021 ◽  
Vol 9 (12) ◽  
pp. 340
Author(s):  
Nikolay Samotaev ◽  
Pavel Dzhumaev ◽  
Konstantin Oblov ◽  
Alexander Pisliakov ◽  
Ivan Obraztsov ◽  
...  

A reduced size thermocatalytic gas sensor was developed for the detection of methane over the 20% of the explosive concentration. The sensor chip is formed from two membranes with a 150 µm diameter heated area in their centers and covered with highly dispersed nano-sized catalyst and inert reference, respectively. The power dissipation of the chip is well below 70 mW at the 530 °C maximum operation temperature. The chip is mounted in a novel surface mounted metal-ceramic sensor package in the form-factor of SOT-89. The sensitivity of the device is 10 mV/v%, whereas the response and recovery times without the additional carbon filter over the chip are <500 ms and <2 s, respectively. The tests have shown the reliability of the new design concerning the hotplate stability and massive encapsulation, but the high degradation rate of the catalyst coupled with its modest chemical power limits the use of the sensor only in pulsed mode of operation. The optimized pulsed mode reduces the average power consumption below 2 mW.


Sign in / Sign up

Export Citation Format

Share Document