scholarly journals Application of atomic force microscopy in biology and medicine

2021 ◽  
Vol 2058 (1) ◽  
pp. 012029
Author(s):  
V G Nikitaev ◽  
A N Pronichev ◽  
T K Markov ◽  
N Esaulov

Abstract This article presents the main areas of application of atomic force microscopy in biology and medicine, describes the principle of an atomic force microscope and the main modes of its operation. The works and results of the leading laboratories in the stated topic are considered. There are a number of proposals for generalizing the considered results into a unified knowledge base on diseases and the general state of health of the human body.

1995 ◽  
Vol 10 (9) ◽  
pp. 2159-2161 ◽  
Author(s):  
J.H. Schneibel ◽  
L. Martínez

Fe–40 at. % Al–0.1 at. % B specimens were polished flat, strained at room temperature, and examined in an atomic force microscope. The angles of height contours perpendicular to the slip lines were interpreted as shear strains and were statistically evaluated. The frequency distributions of these shear strains correlated well with the macroscopic strains. The maximum shear strains found were not much larger than the macroscopic strains. In particular, no steep slip steps corresponding to large local shears were found.


2013 ◽  
Vol 378 ◽  
pp. 466-471
Author(s):  
Po Jen Shih ◽  
Shang Hao Cai

The dynamic behaviors of carbon nanotube probes applied in Atomic Force Microscope measurement are of interest in advanced nanoscalar topography. In this paper, we developed the characteristic equations and applied the model analysis to solve the eigenvalues of the microcantilever and the carbon nanotube. The eigenvalues were then used in the tapping mode system to predict the frequency responses against the tip-sample separations. It was found that the frequency drop steeply if the separation was less than certain distances. This instability of frequency is deduced from the jump of microcantilever or the jump of the carbon nanotube. Various lengths and binding angles of the carbon nanotube were considered, and the results indicated that the binding angle dominated the frequency responses and jumps.


1996 ◽  
Vol 424 ◽  
Author(s):  
Francis P. Fehlner ◽  
Chad B. Moore ◽  
J. Greg Couillard

AbstractA simplified technique for characterizing crystallites in polysilicon films has been demonstrated based on use of the atomic force microscope (AFM). The crystallization of films deposited by two different techniques was examined.


1995 ◽  
Vol 3 (4) ◽  
pp. 6-7
Author(s):  
Stephen W. Carmichael

For biologic studies, atomic force microscopy (AFM) has been prevailing over scanning tunneling microscopy (STM) because it has the capability of imaging non-conducting biologic specimens. However, STM generally gives better resolution than AFM, and we're talking about resolution on the atomic scale. In a recent article, Franz Giessibl (Atomic resolution of the silicon (111)- (7X7) surface by atomic force microscopy, Science 267:68-71, 1995) has demonstrated that atoms can be imaged by AFM.


2021 ◽  
Vol 2086 (1) ◽  
pp. 012204
Author(s):  
D J Rodriguez ◽  
A V Kotosonova ◽  
H A Ballouk ◽  
N A Shandyba ◽  
O I Osotova ◽  
...  

Abstract In this work, we carried out an investigation of commercial atomic force microscope (AFM) probes for contact and semi-contact modes, which were modified by focused ion beam (FIB). This method was used to modify the original tip shape of silicon AFM probes, by ion-etching and ion-enhance gas deposition. we show a better performance of the FIB-modified probes in contrast with the non-modified commercial probes. These results were obtained after using both probes in semi-contact mode in a calibration grating sample.


1999 ◽  
Vol 181 (22) ◽  
pp. 6865-6875 ◽  
Author(s):  
X. Yao ◽  
M. Jericho ◽  
D. Pink ◽  
T. Beveridge

ABSTRACT Atomic force microscopy was used to measure the thickness of air-dried, collapsed murein sacculi from Escherichia coliK-12 and Pseudomonas aeruginosa PAO1. Air-dried sacculi from E. coli had a thickness of 3.0 nm, whereas those fromP. aeruginosa were 1.5 nm thick. When rehydrated, the sacculi of both bacteria swelled to double their anhydrous thickness. Computer simulation of a section of a model single-layer peptidoglycan network in an aqueous solution with a Debye shielding length of 0.3 nm gave a mass distribution full width at half height of 2.4 nm, in essential agreement with these results. When E. colisacculi were suspended over a narrow groove that had been etched into a silicon surface and the tip of the atomic force microscope used to depress and stretch the peptidoglycan, an elastic modulus of 2.5 × 107 N/m2 was determined for hydrated sacculi; they were perfectly elastic, springing back to their original position when the tip was removed. Dried sacculi were more rigid with a modulus of 3 × 108 to 4 × 108N/m2 and at times could be broken by the atomic force microscope tip. Sacculi aligned over the groove with their long axis at right angles to the channel axis were more deformable than those with their long axis parallel to the groove axis, as would be expected if the peptidoglycan strands in the sacculus were oriented at right angles to the long cell axis of this gram-negative rod. Polar caps were not found to be more rigid structures but collapsed to the same thickness as the cylindrical portions of the sacculi. The elasticity of intactE. coli sacculi is such that, if the peptidoglycan strands are aligned in unison, the interstrand spacing should increase by 12% with every 1 atm increase in (turgor) pressure. Assuming an unstressed hydrated interstrand spacing of 1.3 nm (R. E. Burge, A. G. Fowler, and D. A. Reaveley, J. Mol. Biol. 117:927–953, 1977) and an internal turgor pressure of 3 to 5 atm (or 304 to 507 kPa) (A. L. Koch, Adv. Microbial Physiol. 24:301–366, 1983), the natural interstrand spacing in cells would be 1.6 to 2.0 nm. Clearly, if large macromolecules of a diameter greater than these spacings are secreted through this layer, the local ordering of the peptidoglycan must somehow be disrupted.


2019 ◽  
Vol 55 (86) ◽  
pp. 12920-12923 ◽  
Author(s):  
Adam Xiao ◽  
Hongbin Li

We report the direct observation of equilibrium folding–unfolding dynamics of a mechanically labile, three helix bundle protein GA using a commercial atomic force microscope (AFM).


2018 ◽  
Vol 20 (37) ◽  
pp. 24434-24443 ◽  
Author(s):  
Wanyi Fu ◽  
Wen Zhang

A scanning probe method based on atomic force microscopy (AFM) was used to probe the nanoscale hydrophobicity of nanomaterials in liquid environments.


Sign in / Sign up

Export Citation Format

Share Document