scholarly journals A preliminary study on the element abundance in the Hulusimpang Formation, Way Kalianda, Pesawaran, Lampung, Indonesia

2021 ◽  
Vol 882 (1) ◽  
pp. 012078
Author(s):  
D G Harbowo ◽  
B Priadi ◽  
T Julian ◽  
R N Amelia ◽  
D J P Sihombing ◽  
...  
Keyword(s):  
Trace Elements ◽  
Element Abundance ◽  
X Ray ◽  
Hydrothermal Mineralization ◽  
Petrified Wood ◽  
Preliminary Study ◽  
Fluorescence Analyzer ◽  
Magma Series

Abstract Hulusimpang Formation.has known as Oligocene-Miocene rocks that consisted of volcanoclastic rock. Its scope was wide, especially in southern Sumatra. This formation is supposed as a prospect host of various hydrothermal mineralization. A preliminary study was carried out to examine the abundance of elements located in Way Kalianda River, Pesawaran, Lampung. This study was conducted by easuring its stratigraphy and analyzing its composition using an X-Ray fluorescence analyzer. The lithologies generally consist of lapilli tuffs, volcanic breccias, interbeded by claystone and sandstone; in addition, it is also frequently found petrified wood and andesitic-lithic fragments. As a result, the significant abundant elements are Fe (35.5%), Si (27.9%), Al (17.4%), K (6.7%), Cl (5.5%), Ti (1.7%), and Ca (1.5%) and also Mn, Ag, P, Mg, Sr, Zr, and Co. It also presents trace elements such as Rb, Zn, Pb, Te, V, Ba, Cr, Sn, Ni, Ga, Nb, Mo, and Eu. These elements are suggested from distal facies of intermediates-magma series Tertiary volcano.

Microanalytical Identification of a New Zr-Nb-Fe Phase

1990 ◽  
Vol 48 (2) ◽  
pp. 132-133
Author(s):  
O.T. Woo ◽  
G.J.C. Carpenter
Keyword(s):  
Trace Elements ◽  
Cold Rolling ◽  
Proportionality Factor ◽  
Tube Material ◽  
X Ray ◽  
Metal Foils ◽  
Arc Melting ◽  
Intermetallic Particles ◽  
Intermetallic Precipitates ◽  
Cold Worked

To study the influence of trace elements on the corrosion and hydrogen ingress in Zr-2.5 Nb pressure tube material, buttons of this alloy containing up to 0.83 at% Fe were made by arc-melting. The buttons were then annealed at 973 K for three days, furnace cooled, followed by ≈80% cold-rolling. The microstructure of cold-worked Zr-2.5 at% Nb-0.83 at% Fe (Fig. 1) contained both β-Zr and intermetallic precipitates in the α-Zr grains. The particles were 0.1 to 0.7 μm in size, with shapes ranging from spherical to ellipsoidal and often contained faults. β-Zr appeared either roughly spherical or as irregular elongated patches, often extending to several micrometres.The composition of the intermetallic particles seen in Fig. 1 was determined using Van Cappellen’s extrapolation technique for energy dispersive X-ray analysis of thin metal foils. The method was employed to avoid corrections for absorption and fluorescence via the Cliff-Lorimer equation: CA/CB = kAB · IA/IB, where CA and CB are the concentrations by weight of the elements A and B, and IA and IB are the X-ray intensities; kAB is a proportionality factor.

XRMF applications of a monolithic, polycapillary, focusing x-ray optic

1996 ◽  
Vol 54 ◽  
pp. 240-241
Author(s):  
D. A. Carpenter ◽  
Ning Gao ◽  
G. J. Havrilla
Keyword(s):  
Trace Elements ◽  
Point Source ◽  
Focal Spot ◽  
Fluorescence Analysis ◽  
X Rays ◽  
Focal Distance ◽  
Spot Diameter ◽  
X Ray ◽  
Focal Spot Diameter

A monolithic, polycapillary, x-ray optic was adapted to a laboratory-based x-ray microprobe to evaluate the potential of the optic for x-ray micro fluorescence analysis. The polycapillary was capable of collecting x-rays over a 6 degree angle from a point source and focusing them to a spot approximately 40 µm diameter. The high intensities expected from this capillary should be useful for determining and mapping minor to trace elements in materials. Fig. 1 shows a sketch of the capillary with important dimensions.The microprobe had previously been used with straight and with tapered monocapillaries. Alignment of the monocapillaries with the focal spot was accomplished by electromagnetically scanning the focal spot over the beveled anode. With the polycapillary it was also necessary to manually adjust the distance between the focal spot and the polycapillary.The focal distance and focal spot diameter of the polycapillary were determined from a series of edge scans.

Major and Trace Elements in the Humic Acid

2018 ◽  
Author(s):  
Zoltán Kis ◽  
Katalin Gméling ◽  
Tímea Kocsis ◽  
János Osán ◽  
Mihály András Pocsai ◽  
...  
Keyword(s):  
Trace Elements ◽  
Humic Acid ◽  
Activation Analysis ◽  
Analytical Techniques ◽  
Major And Trace Elements ◽  
Prompt Gamma Activation Analysis ◽  
Prompt Gamma ◽  
Gamma Activation ◽  
X Ray ◽  
Precise Analysis

We present precise analysis of major and trace elements of the humic acid. We used three different element analytical techniques in our investigations as prompt-gamma activation analysis (PGAA), neutron activation analysis (NAA) and X-ray fluorescence (XRF) analysis was carried out. We identified 42 elements in our sample.

scholarly journals Preliminary Study of the Targeted Cleaning of an Artificial Gypsum Layer on White Marble

Coatings ◽  
2021 ◽  
Vol 11 (1) ◽  
pp. 37
Author(s):  
Yan Liu ◽  
Taoling Dong ◽  
Kun Zhang ◽  
Fuwei Yang ◽  
Liqin Wang
Keyword(s):  
Electron Microscopy ◽  
Barium Carbonate ◽  
Color Difference ◽  
X Ray Diffraction ◽  
White Marble ◽  
Capillary Suction ◽  
Sulfate Ions ◽  
X Ray ◽  
Preliminary Study ◽  
Scanning Electron

Targeting cleaning of the artificial gypsum layer on white marble was studied. It was conducted by means of the specific depletion of the calcium and sulfate ions by the barium carbonate scavenger, which led to the continuous dissolution and clearance of gypsum layer. The cleaning effect was evaluated by scanning electron microscopy with energy dispersive X-ray spectroscopy (SEM/EDX), X-ray diffraction (XRD), capillary suction, and color difference measurement. By this method, only the gypsum layer was cleared away and the carbonate substrate of marble was left intact at the same time. This method will be highly useful for the conservation of marble relics from surface weathering.

Control of trace elements content in solid-phase extraction sorbent by x-ray fluorescence analysis

2020 ◽  
Author(s):  
E. V. Kochergina ◽  
A. O. Vagina ◽  
A. O. Taukin ◽  
A. V. Abramov ◽  
G. M. Bunkov ◽  
...  
Keyword(s):  
Trace Elements ◽  
Solid Phase Extraction ◽  
Solid Phase ◽  
Fluorescence Analysis ◽  
Phase Extraction ◽  
X Ray
Sign in / Sign up

Export Citation Format

Share Document