Event Manager and Control Structure for High Performance Three-Phase Grid-tied Inverters

2019 ◽  
Author(s):  
Victor E. S. Barbosa ◽  
Rodrigo A. S. Kraemer ◽  
Emerson G. Carati ◽  
Jean P. da Costa ◽  
Rafael Cardoso ◽  
...  
Keyword(s):  
High Performance ◽  
Control Structure ◽  
Three Phase ◽  
And Control

VERSATILE MOTION ESTIMATION PROCESSOR WITH SCALABILITY AND HIGH THROUGHPUT

2005 ◽  
Vol 14 (01) ◽  
pp. 1-14
Author(s):  
YOUNGSAN SUH ◽  
INSEON KOH ◽  
JAEHEE YOU
Keyword(s):  
Motion Estimation ◽  
High Performance ◽  
Control Structure ◽  
Image Data ◽  
Data Reuse ◽  
Search Point ◽  
Object Based ◽  
Precision Motion ◽  
And Control ◽  
Computation Speed

A high-performance versatile motion estimation processor with regular hardware and control structure capable of MP@HL is presented. It can compute 1920 × 1080 pels in 4096 cycles within search point range 64 with eight identical processors. The presented processor has 100% hardware utilization by eliminating the computation delay between stages, and the capability to compute half pel precision motion estimation. Also, by enhancing image data reuse, the I/O bottleneck problem is alleviated. With efficient scalability, the amount of hardware and computation speed can be easily adjusted for a variety of application areas. The proposed edge effect hardware can be used for object-based coding for MPEG-4. The processor was verified with C ++ and VHDL based on actual image data and implemented with 0.6μm gate array. Also, a motion estimator system with image memories and PC host interface was designed.

Identificación de polaridad de los devanados en un motor trifásico de 6 terminales

2019 ◽  
pp. 13-19
Author(s):  
José Luis Viramontes-Reyna ◽  
Josafat Moreno-Silva ◽  
José Guadalupe Montelongo-Sierra ◽  
Erasmo Velazquez-Leyva
Keyword(s):  
Low Cost ◽  
Voltage Reference ◽  
Three Phase ◽  
Voltage Phase ◽  
The Law ◽  
And Control

This document presents the results obtained from the application of the law of Lens to correctly identify the polarity of the windings in a three-phase motor with 6 exposed terminals, when the corresponding labeling is not in any situation; Prior to identifying the polarity, it should be considered to have the pairs of the three windings located. For the polarity, it is proposed to feed with a voltage of 12 Vrms to one of the windings, which are identified randomly as W1 and W2, where W1 is connected to the voltage phase of 12 Vrms of the signal and W2 to the voltage reference to 0V; by means of voltage induction and considering the law of Lens, the remaining 4 terminals can be identified and labeled as V1, V2, U1 and U2. For this process a microcontroller and control elements with low cost are used.

A Novel Two-phase Soft Starter Used for Three-phase Asynchronous Motors

2020 ◽  
Vol 13 (8) ◽  
pp. 1175-1182
Author(s):  
Jingwen Chen ◽  
Hongshe Dang
Keyword(s):  
Pulse Generation ◽  
Power Module ◽  
Two Phase ◽  
Power Semiconductor ◽  
Starting Current ◽  
Semiconductor Switches ◽  
Soft Starter ◽  
Three Phase ◽  
And Control ◽  
Driving Circuit

Background: Traditional thyristor-based three-phase soft starters of induction motor often suffer from high starting current and heavy harmonics. Moreover, both the trigger pulse generation and driving circuit design are usually complicated. Methods: To address these issues, we propose a novel soft starter structure using fully controlled IGBTs in this paper. Compared to approaches of traditional design, this structure only uses twophase as the input, and each phase is controlled by a power module that is composed of one IGBT and four diodes. Results: Consequently, both driving circuit and control design are greatly simplified due to the requirement of fewer controlled power semiconductor switches, which leads to the reduction of the total cost. Conclusion: Both Matlab/Simulink simulation results and experimental results on a prototype demonstrate that the proposed soft starter can achieve better performances than traditional thyristorbased soft starters for Starting Current (RMS) and harmonics.

scholarly journals Reduction of Polycyclic Aromatic Hydrocarbons (PAHs) in Sesame Oil Using Cellulosic Aerogel

Foods ◽  
2021 ◽  
Vol 10 (3) ◽  
pp. 644
Author(s):  
Do-Yeong Kim ◽  
Boram Kim ◽  
Han-Seung Shin
Keyword(s):  
Polycyclic Aromatic Hydrocarbons ◽  
Aromatic Hydrocarbons ◽  
High Performance ◽  
Oil Quality ◽  
Acid Value ◽  
Quality Parameters ◽  
Sesame Oil ◽  
Miscanthus Sinensis ◽  
Polycyclic Aromatic ◽  
And Control

The effect of cellulosic aerogel treatments used for adsorption of four polycyclic aromatic hydrocarbons (PAHs)—benzo[a]anthracene, chrysene, benzo[b]fluoranthene, and benzo[a]pyrene [BaP])—generated during the manufacture of sesame oil was evaluated. In this study, eulalia (Miscanthus sinensis var. purpurascens)-based cellulosic aerogel (adsorbent) was prepared and used high performance liquid chromatography with fluorescence detection for determination of PAHs in sesame oil. In addition, changes in the sesame oil quality parameters (acid value, peroxide value, color, and fatty acid composition) following cellulosic aerogel treatment were also evaluated. The four PAHs and their total levels decreased in sesame oil samples roasted under different conditions (p < 0.05) following treatment with cellulosic aerogel. In particular, highly carcinogenic BaP was not detected after treatment with cellulosic aerogel. Moreover, there were no noticeable quality changes in the quality parameters between treated and control samples. It was concluded that eulalia-based cellulosic aerogel proved suitable for the reduction of PAHs from sesame oil and can be used as an eco-friendly adsorbent.

Sign in / Sign up

Export Citation Format

Share Document