A Low Voltage NMOS current bleeding down conversion Mixer with source degeneration in 0.18µm CMOS Technology

2021 ◽  
Author(s):  
M A Raheem ◽  
M Mohamed Sabir Hussain
Keyword(s):  
Low Voltage ◽  
Cmos Technology ◽  
Current Bleeding ◽  
Down Conversion ◽  
Source Degeneration

A High-Linear CMOS Down Conversion Mixer Using Adjusting the Second and Third-Order Harmonic in Transconductance Stage

2014 ◽  
Vol 24 (01) ◽  
pp. 1550002 ◽  
Author(s):  
Mina Amiri ◽  
Adib Abrishamifar
Keyword(s):  
Low Voltage ◽  
Supply Voltage ◽  
Circuit Simulation ◽  
Cmos Technology ◽  
Conversion Gain ◽  
Third Order ◽  
Cmos Mixer ◽  
Simulation Results ◽  
Down Conversion ◽  
Pmos Transistor

In this paper a new high-linear CMOS mixer is proposed. A well-known low voltage CMOS multiplier structure is used for mixer application in this paper and its linearity is provided by adjusting the value of a resistor, sizing the aspect ratio of a PMOS transistor and adding a proper value of inductor at the input stage. In simulation, a supply voltage as low as 1 V is applied to the circuit. Simulation results of improved mixer in a 0.18-μm CMOS technology illustrate 14 dB increases in IIP3 and also an increase around 1.4 dB is obtained in conversion gain. Furthermore, additional components which are used for improving linearity would not increase the power consumption and area significantly.

scholarly journals Ultra-Low-Voltage CMOS-Based Current Bleeding Mixer with High LO-RF Isolation

2014 ◽  
Vol 2014 ◽  
pp. 1-5 ◽  
Author(s):  
Gim Heng Tan ◽  
Roslina Mohd Sidek ◽  
Harikrishnan Ramiah ◽  
Wei Keat Chong ◽  
De Xing Lioe
Keyword(s):  
Low Voltage ◽  
Supply Voltage ◽  
Cmos Technology ◽  
Third Order ◽  
Chip Area ◽  
Integrated Inductors ◽  
Low Voltage Operation ◽  
Dc Power ◽  
Current Bleeding ◽  
Intercept Point

This journal presents an ultra-low-voltage current bleeding mixer with high LO-RF port-to-port isolation, implemented on 0.13 μm standard CMOS technology for ZigBee application. The architecture compliments a modified current bleeding topology, consisting of NMOS-based current bleeding transistor, PMOS-based switching stage, and integrated inductors achieving low-voltage operation and high LO-RF isolation. The mixer exhibits a conversion gain of 7.5 dB at the radio frequency (RF) of 2.4 GHz, an input third-order intercept point (IIP3) of 1 dBm, and a LO-RF isolation measured to 60 dB. The DC power consumption is 572 µW at supply voltage of 0.45 V, while consuming a chip area of 0.97 × 0.88 mm2.

scholarly journals 1.0 V-0.18 µm CMOS Tunable Low Pass Filters with 73 dB DR for On-Chip Sensing Acquisition Systems

Electronics ◽  
2021 ◽  
Vol 10 (5) ◽  
pp. 563
Author(s):  
Jorge Pérez-Bailón ◽  
Belén Calvo ◽  
Nicolás Medrano
Keyword(s):  
Power Consumption ◽  
Dynamic Range ◽  
Low Voltage ◽  
Cutoff Frequency ◽  
Cmos Technology ◽  
Active Area ◽  
Current Steering ◽  
Low Pass ◽  
On Chip ◽  
Low Pass Filters

This paper presents a new approach based on the use of a Current Steering (CS) technique for the design of fully integrated Gm–C Low Pass Filters (LPF) with sub-Hz to kHz tunable cut-off frequencies and an enhanced power-area-dynamic range trade-off. The proposed approach has been experimentally validated by two different first-order single-ended LPFs designed in a 0.18 µm CMOS technology powered by a 1.0 V single supply: a folded-OTA based LPF and a mirrored-OTA based LPF. The first one exhibits a constant power consumption of 180 nW at 100 nA bias current with an active area of 0.00135 mm2 and a tunable cutoff frequency that spans over 4 orders of magnitude (~100 mHz–152 Hz @ CL = 50 pF) preserving dynamic figures greater than 78 dB. The second one exhibits a power consumption of 1.75 µW at 500 nA with an active area of 0.0137 mm2 and a tunable cutoff frequency that spans over 5 orders of magnitude (~80 mHz–~1.2 kHz @ CL = 50 pF) preserving a dynamic range greater than 73 dB. Compared with previously reported filters, this proposal is a competitive solution while satisfying the low-voltage low-power on-chip constraints, becoming a preferable choice for general-purpose reconfigurable front-end sensor interfaces.

scholarly journals Design of an Ultra-Low Voltage Bias Current Generator Highly Immune to Electromagnetic Interference

2021 ◽  
Vol 11 (1) ◽  
pp. 6
Author(s):  
Orazio Aiello
Keyword(s):  
Integrated Circuits ◽  
Electromagnetic Interference ◽  
Low Voltage ◽  
Current Source ◽  
Building Blocks ◽  
Cmos Technology ◽  
Threshold Region ◽  
Output Current ◽  
Current Generator ◽  
Technology Process

The paper deals with the immunity to Electromagnetic Interference (EMI) of the current source for Ultra-Low-Voltage Integrated Circuits (ICs). Based on the properties of IC building blocks, such as the current-splitter and current correlator, a novel current generator is conceived. The proposed solution is suitable to provide currents to ICs operating in the sub-threshold region even in the presence of an electromagnetic polluted environment. The immunity to EMI of the proposed solution is compared with that of a conventional current mirror and evaluated by analytic means and with reference to the 180 nm CMOS technology process. The analysis highlights how the proposed solution generates currents down to nano-ampere intrinsically robust to the Radio Frequency (RF) interference affecting the input of the current generator, differently to what happens to the output current of a conventional mirror under the same conditions.

scholarly journals Investigation of PVT-Aware STT-MRAM Sensing Circuits for Low-VDD Scenario

Micromachines ◽  
2021 ◽  
Vol 12 (5) ◽  
pp. 551
Author(s):  
Zhongjian Bian ◽  
Xiaofeng Hong ◽  
Yanan Guo ◽  
Lirida Naviner ◽  
Wei Ge ◽  
...  
Keyword(s):  
Nonvolatile Memory ◽  
High Speed ◽  
Low Voltage ◽  
Supply Voltage ◽  
Random Access ◽  
Magnetic Tunnel Junction ◽  
Complementary Metal Oxide Semiconductor ◽  
Current Mode ◽  
Cmos Technology ◽  
Oxide Semiconductor

Spintronic based embedded magnetic random access memory (eMRAM) is becoming a foundry validated solution for the next-generation nonvolatile memory applications. The hybrid complementary metal-oxide-semiconductor (CMOS)/magnetic tunnel junction (MTJ) integration has been selected as a proper candidate for energy harvesting, area-constraint and energy-efficiency Internet of Things (IoT) systems-on-chips. Multi-VDD (low supply voltage) techniques were adopted to minimize energy dissipation in MRAM, at the cost of reduced writing/sensing speed and margin. Meanwhile, yield can be severely affected due to variations in process parameters. In this work, we conduct a thorough analysis of MRAM sensing margin and yield. We propose a current-mode sensing amplifier (CSA) named 1D high-sensing 1D margin, high 1D speed and 1D stability (HMSS-SA) with reconfigured reference path and pre-charge transistor. Process-voltage-temperature (PVT) aware analysis is performed based on an MTJ compact model and an industrial 28 nm CMOS technology, explicitly considering low-voltage (0.7 V), low tunneling magnetoresistance (TMR) (50%) and high temperature (85 °C) scenario as the worst sensing case. A case study takes a brief look at sensing circuits, which is applied to in-memory bit-wise computing. Simulation results indicate that the proposed high-sensing margin, high speed and stability sensing-sensing amplifier (HMSS-SA) achieves remarkable performance up to 2.5 GHz sensing frequency. At 0.65 V supply voltage, it can achieve 1 GHz operation frequency with only 0.3% failure rate.

Sign in / Sign up

Export Citation Format

Share Document