Adsorption of Nickel(II) with Composite Filter Material Made of Coal Fly Ash

Author(s):  
Zhaoqian Jing ◽  
Zheng Wang ◽  
Hongqin Xue ◽  
Shaohua Lin
2010 ◽  
Vol 105-106 ◽  
pp. 631-634 ◽  
Author(s):  
Zhao Qian Jing ◽  
Hong Qin Xue ◽  
Shao Hua Lin ◽  
Zheng Wang

Ceramic filter material was developed mainly with coal fly ash and used as an absorbent for Cr(VI) removal. This material was characterized through physico-chemical analysis with scanning electron microscope (SEM), energy dispersive X-ray spectrometry (EDS) and mercury porosimeter. Then static adsorption experiment was carried out to study adsorption characteristics of Cr(VI) on this filter material. SEM patterns indicated this material had enormous specific surface area and high porosity. EDS results showed this material was mainly composed of O, Si, C, Al, Mg, Fe, Ca and K in various compounds. Total pore area and porosity above 1.5 nm were 66.8 m2/g and 60.1% respectively. The main parameters affecting Cr(VI) adsorption were dosage and contact time. 200 g/l dosage of this filter material could remove more than 90% of Cr(VI) to solution with 20 mg/l initial concentration. Adsorption isotherm accorded with both Langmuir and Freundlich model. The study proved this ceramic filter material was a good adsorbent with high adsorption capacity to Cr(VI).


2010 ◽  
Vol 33 ◽  
pp. 700-703
Author(s):  
Hong Qin Xue ◽  
Xiao Dong Liu ◽  
Zhao Qian Jing ◽  
Chen Zhao

Adsorption of Pb(II) on composite filter material mainly made of fly ash was investigated for the removal of Pb(II) from aqueous solution. Batch experiments have been carried out for adsorption of Pb(II) on to this composite filter material. The effects of various parameters influencing the Pb(II) adsorption such as contact time, initial pH, different dosage of adsorbent and temperature have been studied. Results showed that adsorption equilibrium attained within 60 minutes time. Increase in adsorbent dosage led to increase in Pb(II) adsorption due to increased number of adsorption sites. Adsorption process was found to be highly pH dependent, and the optimum pH range for adsorption of Pb(II) was found to be >8.5. The sorption of Pb(II) increased with rise of temperature.


2008 ◽  
Vol 7 (3) ◽  
pp. 289-293 ◽  
Author(s):  
Maria Harja ◽  
Marinela Barbuta ◽  
Lacramioara Rusu ◽  
Nicolae Apostolescu
Keyword(s):  
Fly Ash ◽  

Agriculture ◽  
2021 ◽  
Vol 11 (1) ◽  
pp. 47
Author(s):  
Kai Yang ◽  
Zejun Tang ◽  
Jianzhang Feng

Sandy soils are prone to nutrient losses, and consequently do not have as much as agricultural productivity as other soils. In this study, coal fly ash (CFA) and anionic polyacrylamide (PAM) granules were used as a sandy soil amendment. The two additives were incorporated to the sandy soil layer (depth of 0.2 m, slope gradient of 10°) at three CFA dosages and two PAM dosages. Urea was applied uniformly onto the low-nitrogen (N) soil surface prior to the simulated rainfall experiment (rainfall intensity of 1.5 mm/min). The results showed that compared with no addition of CFA and PAM, the addition of CFA and/or PAM caused some increases in the cumulative NO3−-N and NH4+-N losses with surface runoff; when the rainfall event ended, 15% CFA alone treatment and 0.01–0.02% PAM alone treatment resulted in small but significant increases in the cumulative runoff-associated NO3−-N concentration (p < 0.05), meanwhile 10% CFA + 0.01% PAM treatment and 15% CFA alone treatment resulted in nonsignificant small increases in the cumulative runoff-associated NH4+-N concentration (p > 0.05). After the rainfall event, both CFA and PAM alone treatments increased the concentrations of NO3−-N and NH4+-N retained in the sandy soil layer compared with the unamended soil. As the CFA and PAM co-application rates increased, the additive effect of CFA and PAM on improving the nutrient retention of sandy soil increased.


2021 ◽  
Vol 170 ◽  
pp. 302-314
Author(s):  
Adeyinka S. Yusuff ◽  
Aman K. Bhonsle ◽  
Jayati Trivedi ◽  
Dinesh P. Bangwal ◽  
Lok P. Singh ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document