Ferroelectric properties of BiFexCr1-xO3 thin film formed on Pt electrodes

Author(s):  
Zhiyong Zhong ◽  
Yoshihiro Sugiyama ◽  
Hiroshi Ishiwara
Sensors ◽  
2021 ◽  
Vol 21 (4) ◽  
pp. 1433
Author(s):  
Esther Tanumihardja ◽  
Douwe S. de Bruijn ◽  
Rolf H. Slaats ◽  
Wouter Olthuis ◽  
Albert van den Berg

A ruthenium oxide (RuOx) electrode was used to monitor contractile events of human pluripotent stem cells-derived cardiomyocytes (hPSC-CMs) through electrical impedance spectroscopy (EIS). Using RuOx electrodes presents an advantage over standard thin film Pt electrodes because the RuOx electrodes can also be used as electrochemical sensor for pH, O2, and nitric oxide, providing multisensory functionality with the same electrode. First, the EIS signal was validated in an optically transparent well-plate setup using Pt wire electrodes. This way, visual data could be recorded simultaneously. Frequency analyses of both EIS and the visual data revealed almost identical frequency components. This suggests both the EIS and visual data captured the similar events of the beating of (an area of) hPSC-CMs. Similar EIS measurement was then performed using the RuOx electrode, which yielded comparable signal and periodicity. This mode of operation adds to the versatility of the RuOx electrode’s use in in vitro studies.


1999 ◽  
Vol 14 (4) ◽  
pp. 1190-1193 ◽  
Author(s):  
J. H. Kim ◽  
A. T. Chien ◽  
F. F. Lange ◽  
L. Wills

Epitaxial PbZr0.5Ti0.5O3 (PZT) thin films were grown on top of a SrRuO3 epitaxial electrode layer on a (100) SrTiO3 substrate by the chemical solution deposition method at 600 °C. The microstructure of the PZT thin film was investigated by x-ray diffraction and transmission electron microscopy, and the ferroelectric properties were measured using the Ag/PZT/SRO capacitor structure. The PZT thin film has the epitaxial orientational relationship of (001) [010]PZT ║ (001) [010]SRO ║ (001) [010]STO with the substrate. The remnant (Pr ) and saturation polarization (Ps) density were measured to be Pr ~ 51.4 µC/cm2 and Ps ~ 62.1 µC/cm2 at 5 V, respectively. Ferroelectric fatigue measurements show that the net-switching polarization begins to drop (to 98% of its initial value) after 7 × 108 cycles.


2002 ◽  
Vol 92 (9) ◽  
pp. 5420-5424 ◽  
Author(s):  
J. S. Zhu ◽  
D. Su ◽  
X. M. Lu ◽  
H. X. Qin ◽  
Y. N. Wang ◽  
...  

2021 ◽  
Vol 8 ◽  
Author(s):  
Jinyu Ruan ◽  
Chao Yin ◽  
Tiandong Zhang ◽  
Hao Pan

Ferroelectric multilayer films attract great attention for a wide variation of applications. The synergistic effect by combining different functional layers induces distinctive electrical properties. In this study, ferroelectric BaZr0.2Ti0.8O3/PbZr0.52Ti0.48O3/BaZr0.2Ti0.8O3 (BZT/PZT/BZT) multilayer thin films are designed and fabricated by using the magnetron sputtering method, and a LaNiO3 (LNO) seed layer is introduced. The microstructures and electrical properties of the BZT/PZT/BZT films with and without the LNO seed layer are systematically studied. The results show that the BZT/PZT/BZT/LNO thin film exhibits much lower surface roughness and a preferred (100)-orientation growth, with the growth template and tensile stress provided by the LNO layer. Moreover, an enhanced dielectric constant, decreased dielectric loss, and improved ferroelectric properties are achieved in BZT/PZT/BZT/LNO thin films. This work reveals that the seed layer can play an important role in improving the microstructure and properties of ferroelectric multilayer films.


2012 ◽  
Vol 139 (1) ◽  
pp. 26-31 ◽  
Author(s):  
J. L. Lai ◽  
X. G. Tang ◽  
C. B. Ma ◽  
R. Li ◽  
Q. X. Liu ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document