scholarly journals RSS-based LTE Base Station Localization Using Single Receiver in Environment with Unknown Path-Loss Exponent

Author(s):  
Suhui Jeong ◽  
Halim Lee ◽  
Taewon Kang ◽  
Jiwon Seo
2021 ◽  
Vol 4 (1) ◽  
pp. 1-9
Author(s):  
Isaac Chukwutem Abiodun ◽  
Joshua Idogho

Propagation path loss exponent is an important component of system design, and knowing the values helps to avoid surprises when the actual service begins. The path loss exponent is known to be critical in establishing the coverage of any new cellular network. Estimating the path loss exponent of any environment requires raising new data sets, which can be accomplished by conducting experiments. With this objective, the present study reports the L-band signal RSS level measurements of 6 GSM base stations in the urban, suburban and rural environments of Ondo and Ekiti States in the Southwestern region of Nigeria. Using a Sony Ericsson TEMS phone monitoring device—connected to a laptop equipped with TEMS software and base station cell reference—and a GPS device, RSS measurements were performed in each sector of the base station up to 1200 m, employing a single sector verification method. The values of path loss exponents were computed from the deduced values of path loss at 50 m intervals up to distances of 1200 m. Close to the base station, the following exponent values were observed—between 2.0 and 3.8 in the urban environment, 2.0 to 2.8 in the suburban environment while for the rural environment, 1.5 to 2.6 we're observed. After the breakpoint distance, higher path loss exponent values of up to 6 was recorded in the urban environment, exponent value of up to 4.3 was observed in the suburban environment and up to 3.5 exponent value in the rural environment. It was also observed that the rural environment presented the longest breakpoint distance of 500 m. The high path loss exponents observed, especially in the urban environment, could cause GSM operators to rethink the margins they have provided. This study is useful for the design of upcoming network systems in these regions and in similar regions.


2019 ◽  
Vol 8 (2) ◽  
pp. 6527-6534

Massive Multi-Input and Multi-Output (MIMO) antenna system potentially provides a promising solution to improve energy efficiency (EE) for 5G wireless systems. The aim of this paper is to enhance EE and its limiting factors are explored. The maximum EE of 48 Mbit/Joule was achieved with 15 user terminal (UT)s. This problem is related to the uplink spectral efficiency with upper bound for future wireless networks. The maximal EE is obtained by optimizing a number of base station (BS) antennas, pilot reuse factor, and BSs density. We presented a power consumption model by deriving Shannon capacity calculations with closed-form expressions. The simulation result highlights the EE maximization with optimizing variables of circuit power consumption, hardware impairments, and path-loss exponent. Small cells achieve high EE and saturate to a constant value with BSs density. The MRC scheme achieves maximum EE of 36 Mbit/Joule with 12 UTs. The simulation results show that peak EE is obtained by deploying massive BS antennas, where the interference and pilot contamination are mitigated by coherent processing. The simulation results were implemented by using MATLAB 2018b.


2021 ◽  
Vol 9 (03) ◽  
pp. 72-79
Author(s):  
Akohoule Alex ◽  
◽  
Bamba Aliou ◽  
Kamagate Aladji ◽  
Konate Adama ◽  
...  

In wireless networks, propagation models are used to assess the received power signal and estimate the propagation channel. These models depend on the pathloss exponent (PLE) which is one of the main parameters to characterize the propagation environment. Indeed, in the wireless channel, the path loss exponent has a strong impact on the quality of the links and must therefore be estimated with precision for an efficient design and operation of the wireless network. This paper addresses the issue of path loss exponents estimation for mobile networks in four outdoor environments. This study is based on measurements carried out in four outdoor environments at the frequency of 2600 MHz within a bandwidth of 70 MHz. It evaluates the path loss exponent, and the impact of obstacles present in the environments. The parameters of the propagation model determined from the measurements show that the average power of the received signal decreases logarithmically with the distance. We obtained path loss exponents values of 4.8, 3.53, 3.6 and 3.99 for the site 1, site 2, site 3 and site 4, respectively. Clearly the density of the obstacles has an impact on the path loss exponents and our study shows that the received signal decrease faster as the transmitter and receiver separation in the dense environments.


IEEE Access ◽  
2019 ◽  
Vol 7 ◽  
pp. 101366-101375 ◽  
Author(s):  
Hasan F. Ates ◽  
Syed Muhammad Hashir ◽  
Tuncer Baykas ◽  
Bahadir K. Gunturk

Sensors ◽  
2020 ◽  
Vol 20 (22) ◽  
pp. 6582
Author(s):  
SeYoung Kang ◽  
TaeHyun Kim ◽  
WonZoo Chung

We present a novel hybrid localization algorithm for wireless sensor networks in the absence of knowledge regarding the transmit power and path-loss exponent. Transmit power and the path-loss exponent are critical parameters for target localization algorithms in wireless sensor networks, which help extract target position information from the received signal strength. In the absence of information on transmit power and path-loss exponent, it is critical to estimate them for reliable deployment of conventional target localization algorithms. In this paper, we propose a simultaneous estimation of transmit power and path-loss exponent based on Kalman filter. The unknown transmit power and path-loss exponent are estimated using a Kalman filter with the tentatively estimated target position based solely on angle information. Subsequently, the target position is refined using a hybrid method incorporating received signal strength measurements based on the estimated transmit power and path-loss exponent. Our proposed algorithm accurately estimates transmit power and path-loss exponent and yields almost the same target position accuracy as the simulation results confirm, as the hybrid target localization algorithms with known transmit power and path-loss exponent. Simulation results confirm the proposed algorithm achieves 99.7% accuracy of the target localization performance with known transmit power and path-loss exponent, even in the presence of severe received signal strength measurement noise.


Sensors ◽  
2020 ◽  
Vol 20 (22) ◽  
pp. 6553
Author(s):  
Edgar A. Esquivel-Mendiola ◽  
Hiram Galeana-Zapién ◽  
David H. Covarrubias ◽  
Edwin Aldana-Bobadilla

A progressive paradigm shift from centralized to distributed network architectures has been consolidated since the 4G communication standard, calling for novel decision-making mechanisms with distributed control to operate at the network edge. This situation implies that each base station (BS) must manage resources independently to meet the quality of service (QoS) of existing human-type communication devices (HTC), as well as the emerging machine type communication (MTC) devices from the internet of things (IoT). In this paper, we address the BS assignment problem, whose aim is to determine the most appropriate serving BS to each mobile device. This problem is formulated as an optimization problem for maximizing the system throughput and imposing constraints on the air interface and backhaul resources. The assignment problem is challenging to solve, so we present a simple yet valid reformulation of the original problem while using dual decomposition theory. Subsequently, we propose a distributed price-based BS assignment algorithm that performs at each BS the assignment process, where a novel pricing update scheme is presented. The simulation results show that our proposed solution outperforms traditional maximum signal to interference plus noise ratio (Max-SINR) and minimum path-loss (Min-PL) approaches in terms of system throughput.


2020 ◽  
Vol 10 (1) ◽  
Author(s):  
Peter J. Burke

Abstract In order to determine how an electromagnetic wave propagates from a base station to a cell phone or a wirelessly connected device, we use a novel Unmanned Aerial Vehicle (UAV) mapping technology to map the cellular network coverage at various altitudes in various terrains (flat, hilly, mountainous). For the flat terrains, the waves are shown to propagate ballistically: They have an altitude independent path loss consistent with minimal scatter in the propagation from transmitter to (aerial) receiver. In mountainous terrain, the waves are shown to propagate in the diffuse regime, and demonstrate a 10 dB increase in received signal intensity per 100′ of altitude gain, up to 400′. In the intermediate case, evidence of coherent wave interference is clearly observed in altitude independent interference patterns. These general observations can be used to build a physical or empirical model for drone-to-ground and drone-to-drone propagation, for which existing models are shown to fail. While important for building physical models of wave propagation in wireless networks, this method can be used more generally to determine the magnitude and phase of an electromagnetic wave at every point in space, as well as usher in the era of drone-to-ground and drone-to-drone communications.


Sign in / Sign up

Export Citation Format

Share Document