Harmonic distortion reduction in multi-level PWM modulators for audio power amplifiers

2003 ◽  
Author(s):  
V.M.E. Antunes ◽  
V.F. Pires ◽  
J.F. Silva
Keyword(s):  
Power Amplifiers ◽  
Harmonic Distortion ◽  
Multi Level ◽  
Distortion Reduction

scholarly journals The multilevel inverter with clamped-diode

2019 ◽  
Vol 14 (3) ◽  
pp. 1189
Author(s):  
Trong-Thang Nguyen
Keyword(s):  
Numerical Simulation ◽  
Circuit Design ◽  
Output Voltage ◽  
Harmonic Distortion ◽  
Control Circuit ◽  
Multilevel Inverter ◽  
Power Circuit ◽  
Advantages And Disadvantages ◽  
Multi Level ◽  
And Control

<p>In this study, the author analyzes the advantages and disadvantages of multi-level inverter compared to the traditional two-level inverter and then chose the suitable inverter. Specifically, the author analyzes and designs the three-level inverter, including the power circuit design and control circuit design. All designs are verified through the numerical simulation on Matlab. The results show that even though the three-level inverter has a low number of switches (only 12 switches), but the quality is very good: the total harmonic distortion is small; the output voltage always follows the reference voltage.</p>

scholarly journals Performance Research of Seven Level Multi-Level Inverter with Reduced Switches using Various PWM Techniques

2019 ◽  
Vol 8 (2S8) ◽  
pp. 1149-1154
Keyword(s):  
High Power ◽  
Harmonic Distortion ◽  
Total Harmonic Distortion ◽  
Switching Topology ◽  
Switching Loss ◽  
Medium Voltage ◽  
Switching Losses ◽  
Multi Level ◽  
Low Efficiency ◽  
Performance Research

A inverter is basically a device that usually converts DC to AC voltage without causing any power loss, applicable to only low to medium voltage applications. But in case of medium to high power applications, it has demerits like high switching losses, reduced cost and low efficiency. To overcome these demerits a Multilevel inverter applicable to high voltage and high-power applications which have low total harmonic distortion (THD) is introduced. This paper is mainly focused on seven-level inverter with five switches and four dc sources. with low total harmonic distortion, less switching loss without adding any complexity to the circuit. The switching topology is integrated with various SPWM techniques like Phase Disposition (PD), Phase Opposition Disposition (POD) and Anti Phase Opposition Disposition (APOD). For better performance of the inverter above three PWM techniques will be compared and analyzed to find the low THD configuration. The simulation of switching topology is done by MATLAB/Simulink.

scholarly journals Harmonics reduction of a five-level inverter by unbalanced carriers and over-modulation techniques

2018 ◽  
Vol 7 (3) ◽  
pp. 1059
Author(s):  
Mustafa Fawzi Mohammed ◽  
Ali Husain Ahmad ◽  
AbdulRahim Thiab Humod
Keyword(s):  
Fundamental Frequency ◽  
Output Voltage ◽  
Single Phase ◽  
Harmonic Distortion ◽  
Total Harmonic Distortion ◽  
Modulation Method ◽  
Labview Software ◽  
Design And Implementation ◽  
Modulation Techniques ◽  
Multi Level

The most concerns in the inverter's design are about, how to make the output voltage of the inverter sinusoidal at the desired fundamental frequency with low total harmonic distortion (THD). This paper presents a design and implementation of single-phase five-level inverter which is powered by single dc source and based on T-type multi-level inverters construction. The proposed inverter is built mainly by six IGBTs and two diodes. The used modulation technique is based on using two triangular carriers at 2000 Hz frequency and shifted by phase opposition disposition (POD) method. The carriers are made slightly unbalanced with their amplitudes. The over-modulation method is also introduced in the design to get the lowest possible THD effect without using filters. The inverter is simulated by MATLAB SIMULINK, implemented practically, and tested with the help of LabVIEW software.  

Sign in / Sign up

Export Citation Format

Share Document