Parallel-Resonance Methods for Precise Measurements of High Impedances at Radio Frequencies and a Comparison with the Ordinary Series-Resonance Methods

1938 ◽  
Vol 26 (12) ◽  
pp. 1466-1497 ◽  
Author(s):  
D.B. Sinclair
Sensors ◽  
2020 ◽  
Vol 20 (2) ◽  
pp. 334 ◽  
Author(s):  
Ainan Leong ◽  
Tridib Saha ◽  
Varghese Swamy ◽  
Narayanan Ramakrishnan

We propose a novel langasite crystal microbalance (LCM) sensor with a graphene-based sensing medium to detect and discriminate volatile organic compounds (VOCs) at room temperature. A thin film of graphene oxide embedded with Pt nanostructures (GO-Pt nanocomposite) was deposited on the electrode surface of the LCM, a thickness-shear acoustic wave resonator. Ethyl acetate, acetic acid, and ethanol were chosen as typical VOCs for this study. Sensitivity and selectivity of coated LCM were investigated for different concentrations of the VOCs by analysing the resonant properties of the sensor. When exposed to VOCs, a negative shift in series resonance frequency was observed due to the mass loading of VOC molecules. Simultaneously, changes in equivalent resistance and parallel resonance frequency of the sensor were also observed due to the interaction of VOCs with charge carriers on the GO-Pt nanocomposite film surface. This dual measurement of both series and parallel resonance frequencies allowed for detection and discrimination of VOCs. Moreover, the high thermal stability of langasite makes the proposed sensor suitable even for harsh environmental conditions.


1971 ◽  
Vol 46 (2) ◽  
pp. 241-265 ◽  
Author(s):  
John W. Miles

The surface-wave response of a harbour to a prescribed, incident wave is calculated on the hypotheses of shallow-water theory, an ideal fluid, and a narrow mouth,M.An equivalent electrical circuit is constructed, in which the incidentwave displacement inMappears as the input voltage and the flow throughMappears as the input current. This circuit contains aradiation impedance, ZM, which comprises resistive and inductive terms, and aharbour impedance, ZH, which comprises an infinite sequence of parallel combinations of inductance and capacitance that bear a one-to-one correspondence with the natural modes of the closed harbour, together with a single capacitor, which corresponds to the degenerate mode of uniform displacement and dominates the response of the harbour as a Helmholtz resonator. Variational approximations toZHandZMare developed. The equivalent circuit exhibits parallel resonance at the resonant frequencies of the closed harbour, ωn, and series resonance at a second set of frequencies,$\tilde{\omega}_n $, where$\tilde{\omega}_n\downarrow \omega_n > 0 $and$\tilde{\omega}_0\downarrow 0 $asM→ 0;$\tilde{\omega}_0 $corresponds to the Helmholtz mode. A narrow canal between the coastline and the harbour is represented by a four-terminal network betweenZMandZH. It is shown that narrowing the harbour mouth and/or increasing the length of the canal does not affect the mean response of the harbour to a broad-band, random input except in the Helmholtz mode, but that it does increase significantly the response in that mode, which may dominate tsunami response. The general results are applied to circular and rectangular harbours. The numerical calculation ofZHfor an arbitrarily shaped harbour is discussed.


2015 ◽  
Vol 781 ◽  
pp. 410-413 ◽  
Author(s):  
Artit Rittiplang ◽  
Wanchai Pijitrojana

Nowadays, there are more studies about the wireless power transfer (WPT) for mobile charging, electrical vehicles, implantable biomedical devices, and other applications. They (series resonance) commonly operate at high the self-resonant frequency (f0, several hundred kHz - several MHz ranges) based on magnetic coupling under impedance matching (IM). Operating at high f0 to increase the transfer distance, but high f0 (several MHz ranges) causes other parasitic losses of devices and the effectiveness to humans. In this paper, we propose a new method to design WPT using the parallel resonance under IM at low f0. The two coils are 10-turns with the radius of 6.2 cm. The efficiency (35.77 %) of the system under IM is achieved at the transfer distance of 10 cm and f0=20.388 kHz (low frequency), and the transfer distance can be increased by reducing f0.


2021 ◽  
Vol 21 (3) ◽  
pp. 167-176
Author(s):  
Ki-Chai Kim ◽  
Jong-Woo Kim ◽  
Jae-Yong Kwon ◽  
No-Weon Kang

This paper presents a non-contact method for the detection of surface cracks in metal materials through a forced-resonance microwave method (FRMM) using a cutoff cavity-backed narrow slot as a crack detection probe without using a vector network analyzer (VNA) at microwave frequencies. The FRMM uses the deviations in the ammeter or voltmeter readings of the forcefully obtained resonance of a cutoff-cavity probe for a metal material with or without cracks. The cutoff cavity-backed narrow slot on metal with no cracks produces a series resonance (maximum current) or a parallel resonance through an external control element located on a post inside the cutoff cavity. Cracks were detected by a change in this forced-resonance state (maximum current) when the cutoff-cavity probe was scanned over a crack. The characteristic crack signal was derived from the resonance current deviation on the ammeter located on a post inside the cavity probe. Galerkin’s method of moments was used to obtain a forced-resonance state from which the crack signal of the FRMM was calculated. The experimental measurements for non-contact (remote or lift-off) crack detection are also presented.


2014 ◽  
Vol 511-512 ◽  
pp. 223-226
Author(s):  
Zhi Qiang Dai ◽  
Xiao Du ◽  
Huan Lian ◽  
Si Ming Wei ◽  
Huan Liu ◽  
...  

Different voltage-class buses of transformer substations which are established based on harmonic voltage distortion to limit amplitude via national standards, so study of harmonic longitudinal propagation (RHLP) is essential to power networks. In order to research RHLP, building models of different electrical components which are harmonic sources, equivalent generators, distribution parameter overhead lines (DPOL), transformers, and loads and so on are crucial. This paper proposes a method which utilizes the principle of electric circuits' ohm' law, series resonance and parallel resonance to study RHLP. Finally, according to Henan province power networks frame, a model is constructed in the simulation software packages PSCAD/EMTDC to verify the method. Furthermore, using MATLAB calculation and PSCAD/EMTDC simulation conclude RHLP in different voltage classes.


2020 ◽  
Vol 20 (4) ◽  
pp. 285-292
Author(s):  
Ki-Chai Kim ◽  
Jong-Woo Kim ◽  
Jae-Yong Kwon ◽  
No-Weon Kang

This paper presents the current characteristics inside a cutoff cavity slot probe applied to crack detection using the forced resonance microwave method (FRMM). Crack detection using FRMM has two stages: preparation and detection. In the preparation stage, the current characteristics inside the probe with a shorting plate are important for determining the crack signal and detection sensitivity. The cutoff cavity probe produces a forced resonance by adjusting a control element. There are two kinds of forced resonance: series resonance (SR) and parallel resonance (PR). Four types of current characteristics are applied to crack detection using FRMM: SR, the region around SR, the region around PR, and non-resonance. These current characteristics are discussed from the point of view of current change for crack detection. The experimental results are compared with the theoretical results to check the current state inside the cutoff cavity probe.


PIERS Online ◽  
2009 ◽  
Vol 5 (3) ◽  
pp. 251-255 ◽  
Author(s):  
Hsin-Hung Li ◽  
Jen-Yu Jao ◽  
Ming-Kun Chen ◽  
Ling-Sheng Jang ◽  
Yi-Chu Hsu

Sign in / Sign up

Export Citation Format

Share Document