Drain Current Density Over 1.1 A/mm in 2D Hole Gas Diamond MOSFETs with Regrown p++-Diamond Ohmic Contacts

2020 ◽  
pp. 1-1
Author(s):  
Shoichiro Imanishi ◽  
Ken Kudara ◽  
Hitoshi Ishiwata ◽  
Kiyotaka Horikawa ◽  
Shotaro Amano ◽  
...  
Author(s):  
Akiyoshi Inoue ◽  
Sakura Tanaka ◽  
Takashi Egawa ◽  
Makoto Miyoshi

Abstract In this study, we fabricated and characterized heterojunction field-effect transistors (HFETs) based on an Al0.36Ga0.64N-channel heterostructure with a dual AlN/AlGaInN barrier layer. The device fabrication was accomplished by adopting a regrown n++-GaN layer for ohmic contacts. The fabricated HFETs with a gate length of 2 μm and a gate-to-drain distance of 6 μm exhibited an on-state drain current density as high as approximately 270 mA/mm and an off-state breakdown voltage of approximately 1 kV, which corresponds to an off-state critical electric field of 166 V/μm. This breakdown field, as a comparison in devices without field-plate electrodes, reaches approximately four-fold higher than that for conventional GaN-channel HFETs and was considered quite reasonable as an Al0.36Ga0.64N-channel transistor. It was also confirmed that the devices adopting the dual AlN/AlGaInN barrier layer showed approximately one order of magnitude smaller gate leakage currents than those for devices without the top AlN barrier layer.


2011 ◽  
Vol 130-134 ◽  
pp. 3392-3395 ◽  
Author(s):  
Gang Chen ◽  
Peng Wu ◽  
Song Bai ◽  
Zhe Yang Li ◽  
Yun Li ◽  
...  

. Silicon carbide (SiC) SITs were fabricated using home-grown epi structures. The gate is a recessed gate - bottom contact (RG - B). We designed that the mesa space 2.7μm and the gate channel is 1.2μm. One cell has 400 source fingers and each source finger width is 100μm. 1mm SiC SIT yielded a current density of 123mA/mm of drain current at a drain voltage of 20V. A maximum current density of 150 mA/mm was achieved with Vd=40V. The device blocking voltage with a gate bias of-16 V was 200 V. Packaged 24-cm devices were evaluated using amplifier circuits designed for class AB operations. A total power output in excess of 213 W was obtained with a power density of 8.5 W/cm and gain of 8.5 dB at 500 MHz under pulse operation.


2017 ◽  
Vol 64 (11) ◽  
pp. 4581-4586 ◽  
Author(s):  
Yanbin Qiao ◽  
Dongyan Zhao ◽  
Yanning Chen ◽  
Jin Shao ◽  
Haifeng Zhang ◽  
...  

2016 ◽  
Author(s):  
H. Kawarada ◽  
Y. Kitabayashi ◽  
M. Syamsul ◽  
M. Shibata ◽  
D. Matsumura ◽  
...  

Author(s):  
Н.А Малеев ◽  
А.П. Васильев ◽  
А.Г. Кузьменков ◽  
М.А. Бобров ◽  
М.М. Кулагина ◽  
...  

High-electron mobility transistor (HEMT) with improved breakdown characteristics has been developed. Composite InGaAs channel structure was used in combination with fully selective double recess device fabrication process. HEMTs with T-gate length of 120 nm and width 4x30 m demonstrate maximum extrinsic transconductance of 810 mS/mm, maximum drain current density of 460 mA/mm and gate-drain reverse breakdown voltages as high as 8–10 V. Devices cut-off frequency exceed 115 GHz. Because of increased breakdown voltage and fully selective double recess fabrication process designed HEMTs are promising for medium power mm-wave MMIC amplifiers.


2018 ◽  
Vol 6 ◽  
pp. 106-109 ◽  
Author(s):  
Yuangang Wang ◽  
Hongyu Guo ◽  
Yulong Fang ◽  
Zhihong Feng ◽  
Shujun Cai ◽  
...  

Carbon ◽  
2021 ◽  
Author(s):  
Ken Kudara ◽  
Masakazu Arai ◽  
Yukiko Suzuki ◽  
Aoi Morishita ◽  
Jun Tsunoda ◽  
...  

2015 ◽  
Author(s):  
Y. Kitabayashi ◽  
T. Yamada ◽  
D. Xu ◽  
T. Saito ◽  
D. Matsumura ◽  
...  

2018 ◽  
Author(s):  
T. Yabe ◽  
N. Oi ◽  
J.J. Buendia ◽  
S. Okubo ◽  
K. Horikawa ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document