Path Following Control of Autonomous Ground Vehicle Based on Nonsingular Terminal Sliding Mode and Active Disturbance Rejection Control

2019 ◽  
Vol 68 (7) ◽  
pp. 6379-6390 ◽  
Author(s):  
Yan Wu ◽  
Lifang Wang ◽  
Junzhi Zhang ◽  
Fang Li
2020 ◽  
Vol 2020 ◽  
pp. 1-12
Author(s):  
Jining Guo ◽  
Haoyu Zhang ◽  
Desheng Liu

In order to improve the disturbance rejection ability and tracking accuracy of the hydraulic servo system of the rolling mill, this study combines nonsingular terminal sliding mode control (NTSMC) with active disturbance rejection control (ADRC). A fourth-order extended state observer was designed to estimate the disturbance of the system in real time. The stability of the control system was tested using the Lyapunov method. System effectiveness was verified through simulation experiments. Simulation results showed that the designed state observer can estimate the total disturbance of the system in real time and that the chattering of the control input can be eliminated by the introduction of a state observer. In terms of uncertainty in the system model caused by load changes and external interference signals, the nonsingular terminal sliding mode-active disturbance rejection control method exhibited better disturbance rejection capacity and a higher tracking accuracy than NTSMC.


2014 ◽  
Vol 2014 ◽  
pp. 1-9
Author(s):  
Juan Li ◽  
Haitao Gao ◽  
Jiajia Zhou ◽  
Zheping Yan

This paper addresses the problem of accurate path following control for an underactuated unmanned underwater vehicle (UUV) in the horizontal plane. For an underactuated UUV, the line-of-sight (LOS) guidance method is adopted to map 2D reference trajectory into a desired orientation, and through the tracking of heading to achieve path following, where the sideslip is introduced to modify the desired orientation. In this paper, we propose a method called dynamic surface and active disturbance rejection control (DS-ADRC) to solve the path following control problem. This controller can effectively avoid the phenomenon of explosion of terms in the conventional backstepping method, reduce the dependence on the UUV controller mathematical model, and enhance the antijamming ability. Simulation is carried out to verify the effectiveness of the proposed control method for an underactuated UUV. The results show that, even for this controller with disturbance, the cross-track error of UUV is gradually converged to zero and has some certain robustness.


2021 ◽  
Vol ahead-of-print (ahead-of-print) ◽  
Author(s):  
Nigar Ahmed ◽  
Syed Awais Ali Shah

PurposeIn this research paper, an adaptive output-feedback robust active disturbance rejection control (RADRC) is designed for the multiple input multiple output (MIMO) quadrotor attitude model subject to unwanted uncertainties and disturbances (UUDs).Design/methodology/approachIn order to achieve the desired control objectives in the presence of UUDs, the low pass filter (LPF) and extended high gain observer (EHGO) methods are used for the estimation of matched and mismatched UUDs, respectively. Furthermore, for solving the chattering incurred in the standard sliding mode control (SMC), a multilayer sliding mode surface is constructed. For formulating the adaptive output-feedback RADRC algorithm, the EHGO, LPF and SMC schemes are combined using the separation principle.FindingsThe findings of this research work include the design of an adaptive output-feedback RADRC with the ability to negate the UUDs as well as estimate the unknown states of the quadrotor attitude model. In addition, the chattering problem is addressed by designing a modified SMC scheme based on the multilayer sliding mode surface obtained by utilizing the estimated state variables. This sliding mode surface is also used to obtain the adaptive criteria for the switching design gain parameters involved in the SMC. Moreover, the requirement of high design gain parameters in the EHGO is solved by combining it with the LPF.Originality/valueDesigning the flight control techniques while assuming that the state variables are available is a common practice. In addition, to obtain robustness, the SMC technique is widely used. However, in practice, the state variables might not be available due to unknown parameters and uncertainties, as well as the chattering due to SMC reduces the performances of the actuators. Hence, in this paper, an adaptive output-feedback RADRC technique is designed to solve the problems of UUDs and chattering.


Electronics ◽  
2018 ◽  
Vol 7 (12) ◽  
pp. 357 ◽  
Author(s):  
Chunlin Song ◽  
Changzhu Wei ◽  
Feng Yang ◽  
Naigang Cui

This article presents a fixed-time active disturbance rejection control approach for the attitude control problem of quadrotor unmanned aerial vehicle in the presence of dynamic wind, mass eccentricity and an actuator fault. The control scheme applies the feedback linearization technique and enhances the performance of the traditional active disturbance rejection control (ADRC) based on the fixed-time high-order sliding mode method. A switching-type uniformly convergent differentiator is used to improve the extended state observer for estimating and attenuating the lumped disturbance more accurately. A multivariable high-order sliding mode feedback law is derived to achieve fixed time convergence. The timely convergence of the designed extended state observer and the feedback law is proved theoretically. Mathematical simulations with detailed actuator models and real time experiments are performed to demonstrate the robustness and practicability of the proposed control scheme.


Author(s):  
Zhang He ◽  
Zhao Jiyun ◽  
Wang Yunfei ◽  
Zhang Zhonghai ◽  
Ding Haigang ◽  
...  

This study proposes a compound control method based on sliding mode and active disturbance rejection control to address the difficulty of controlling the cutting head for boom-type roadheader with parameter changes and uncertain disturbances. The fastest discrete tracking differentiator and extended state observer based on the traditional active disturbance rejection control are designed. Additionally, the controller of the sliding mode and active disturbance rejection control is constructed. Theoretical analysis indicates that the proposed controller ensures asymptotic stability, despite the existing uncertain disturbances. Moreover, a system based on AMESim and MATLAB/Simulink Co-simulation model is developed to further verify the performance of proposed algorithm. Compared with traditional active disturbance rejection control, proportional-integral-derivative(PID) and sliding mode control, co-simulation results demonstrate that the sliding mode active disturbance rejection compound control improves the tracking accuracy and robustness of the position servo system.


Author(s):  
Haoping Wang ◽  
Yeqing Lu ◽  
Yang Tian ◽  
Nicolai Christov

This article deals with the control problem of 7-degrees of freedom full-car suspension system which takes into account the spring-damper nonlinearities, unmodeled dynamics and external disturbances. The existing active disturbance rejection control uses an extended state observer to estimate the “total disturbance” and eliminate it with state error feedback. In this article, a new type of active disturbance rejection control is developed to improve the ride comfort of full car suspension systems taking into account the suspension nonlinearities and actuator saturation. The proposed controller combines active disturbance rejection control and fuzzy sliding mode control and is called Fuzzy Sliding Mode active disturbance rejection control. To validate the system mathematical model and analyze the controller performance, a virtual prototype is built in Adams. The simulation results demonstrate better performance of Fuzzy Sliding Mode active disturbance rejection control compared to the existing active disturbance rejection control.


Sign in / Sign up

Export Citation Format

Share Document